LOCKER DOWN LD2041/LD2041EX 2014-2019 Chevrolet Silverado and GMC Sierra 1500 Instruction Manual
- June 3, 2024
- LOCKER DOWN
Table of Contents
Security Products
INSTALLATION INSTRUCTIONS
LD2041/LD2041EX
[2014-2019 Chevrolet Silverado and GMC Sierra 1500, also 2015-2020
Chevrolet and GMC 2500,3500] 
LD2041/LD2041EX 2014-2019 Chevrolet Silverado and GMC Sierra 1500
-
For any combination style lock, it is a good idea to set the combination before installing the safe. We recommend that the combination be set with the DOOR OPEN in order to test the lock combination effectively without locking yourself out.
-
Clear out the contents of the center console for now.
-
Remove the neoprene padding from the inside of the safe.
-
Place the safe into the console compartment.
-
Using a 1/8 DRILL BIT along with a drill, pre-drill pilot holes into the console compartment where the screws will be set.
a. The screws will be set in the two holes on either side of the safe.
b. Make sure to drill through until the drill hits metal.
c. To make this process easier, mark the locations where the holes will be drilled, remove the safe, then drill the pilot holes into the console compartment. -
If you removed the safe from Step 4: c), reinsert the safe into the console compartment.
-
Secure the safe into the console compartment using the 4 SELF TAPING SCREWS provided by LOCK’ER DOWN, these screws are to be set into the pre-drilled pilot holes from Step 4.
-
Tighten the screws, DO NOT OVER TIGHTEN, THIS COULD DAMAGE THE CONSOLE.
-
Re-insert the padding that was removed from the safe before installation.
-
Enjoy your purchase!
Tools Needed:
- IMPACT DRILL or PHILLIPS SCREWDRIVER
- 1/8 Drill Bit
- Phillips Head Drill Bit (optional)
Contents Included : 4 Self Tapping Screws
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>