Razor W15110710027 Vector Handlebar Kit Instruction Manual
- June 3, 2024
- Razor
Table of Contents
W15110710027 Vector Handlebar Kit
Instruction Manual
W15110710027 Vector Handlebar Kit
VECTOR HANDLEBAR KIT
REPLACEMENT PROCEDURES
PART # W15110710027
Required Tools: (Not included)
A. Phillips screwdriver
B. Long needle pliers
C. 5 mm Allen wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Step 1
Using a Phillips screwdriver, remove two (2) screws from the battery cover on
the right side of the unit.| Step 2
Locate and disconnect the throttle and brake lever connectors from the
controller.
---|---
|
Step 3
Using long needle pliers, pinch the end cap from the brake cable remove it and
set aside.| Step 4
Using a 5 mm Allen wrench, loosen the bolt that holds the brake cable onto the
brake caliper actuator arm and slide the cable out.
|
Step 5
Using a 5 mm Allen wrench, loosen the bolts from the collar clamp and slide
the handle bar up from the fork.| Step 6
Slide the cables out from the battery cover fairing.
|
Step 7
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Need Help?
Visit our website at www.razor.com
or call toll-free at 866-467-2967
Monday – Friday 8:00am – 5:00pm Pacific Time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>