STATINT 110120 Film One Way Mirror Film Daytime Privacy Instruction Manual
- June 14, 2024
- STATINT
Table of Contents
110120
Film One Way Mirror Film Daytime Privacy
COMMODITY COMPOSITION
- The window film itself has various sizes and colors.
TOOLS NEEDED
Preparation
Soapy solution= 6 drops liquid soap + 16 oz. (500ml) water
INSTALLATION STEPS
Installation Guide Video
https://www.youtube.com/watch?v=H4mGIhdndbQ
-
Clean window
Generously spray the window with the soapy solution, use a razor blade to remove stubborn dirt or paint.
-
Measure window
Measure width and height of window
-
Cut the film
Cut the film at least an inch bigger than the window on all four sides.
The excess will be trimmed once film is applied.
-
Remove the backing liner & Wet window film
Peel off the backing liner (transparent liner) from one corner, and then spray soapy solution, soaking both the window and adhering side of film.
Hint:
Window film has 2 parts, the film & clear backing liner Have a helper hold the film by the edges while you spray.
A fully wet window and film is the key to installing successfully without bubbles. -
Apply film to glass
Hold the film so that the smooth side is facing the window and apply to the glass. Use your hands to smooth the film out and position it so that the excess 1 inch is overlapping the window on all four sides.
-
Squeegee to remove bubbles
Lightly squeegee the centerline of the film from top to bottom to set it in place.
Begin smoothing the film, starting at the right side and work downward. Repeat the process for the left side.
-
Trim extra film
Use the squeegee as a guide, trim the film around all four sides.
-
Dry edges
Wipe frame edge dry.
TIPS
- Keep the window and film extremely wet during installation process. If it becomes dry, re-wet it completely before applying film.
- When you squeegee out all bubbles, please use the cloth as a cushion between the squeegee and the film to avoid making scratches.
- Application is easier with two people,especially on larger windows (3-4 feet wide).
- Apply film to cool shaded windows when glass temperature is between 45-90°F. For best results, do not apply in direct sunlight or freezing weather.
NOTICE
- Do not apply any film to frosted, treated, etched,stained glass,or any otherwise flawed or defective glass.
- Do not apply the film to motor vehicle windows.
- Handle the film carefully while installing to avoid wrinkles or creases, which can’t be removed.
- If you notice imperfections such as air bubbles or debris between the filmand the glass,simply peel the affected area of the film away from the glass and use the tip of your utility knife or squeegee to remove any debris or bubble.
FAQ
1.Is the film difficult to apply?
Anyone can install window film, but there may be a learning curve. It will be easier once you practice with a smaller window first.
2.The film is not adhering. Why?
Window films come with a backing liner to protect the non-adhesive or static surface. The backing liner needs to be separated from the film first.
3.Is this applied inside or outside of the window?
Inside. All window films should be installed inside except for films that are
4,Which liquid soap should I use for the water solution?
Any type is fine, from dishwash to hand soap. You may get the best result with baby shampoo.
5.How come I don’t have privacy at night?
Privacy effect works when there is a difference in lighting. At night, if it is brighter inside than it is outside, the privacy effect will be reversed. This is why our privacy films are known as day time privacy films.
6.Can I remove this film later?
Yes. A fabric steamer or a heat gun can heat up the film and loosen the adhesive.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>