Applied Motion Products STM23 24 Ethernet Integrated Motor User Guide
- June 3, 2024
- Applied Motion Products
Table of Contents
Applied Motion Products STM23 24 Ethernet Integrated Motor
Requirements
To begin, make sure you have the following equipment:
- A small flat blade screwdriver for tightening the connectors (included).
- A 12-70V DC power supply.
- A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit).
- ST Configurator™ software (available at www.applied-motion.com/products/software).
- A CAT5 network cable (not included).
- For more detailed information, please download and read the appropriate hardware manual, available at www.applied-motion.com/support/manuals.
Step 1
- Download and install the ST Configurator™ software.
- If you intend to connect the drive directly to your PC, configure your computer to use IP address 10.10.10.11. (For instructions on connecting your STM drive to a local area network (LAN), please consult the appropriate hardware manual)
- On the STM drive, select switch position 0, which will assign IP address 10.10.10.10. (See the hardware manual for further details on selecting IP addresses for the drive and PC)
- Launch the software by clicking: Start / All Programs / Applied Motion Products / ST Configurator
Step 2
Wire the drive to the DC power source. (Do not apply power until Step 3)
Note – the STM drive accepts DC voltages from 12-70V. If using an external fuse, we recommend a 4 amp fast acting fuse (5A for STM24). (See the appropriate hardware manual for more information about power supply and fuse selection.) Connect I/O, if required by your application. (See the appropriate hardware manual for more information about wiring I/O to the STM drive.)
STM drives (STM23 shown)
Step 3
- Apply power to the drive. The drive model and firmware revision should be automatically displayed in the ST Configurator™ software.
- Follow the configuration instructions in the ST Configurator™ help screens. The ST Configurator™ software can be used to set up your drive to operate in several different modes including: pulse & direction, velocity (oscillator), streaming commands (SCL), and Q programming mode.
- ST Configurator™ includes a self test option (under the Drive menu) to verify that the STM and power supply are correctly wired and configured.
- If you have any questions or comments, please call Applied Motion Products Customer Support:800-525-1609, or visit us online at applied-motion.com.
- 18645 Madrone Pkwy Morgan Hill, CA 95037
- Tel: 800-525-1609
- applied-motion.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>