OPODEE HP1502R PTC Electric Space Heater User Manual

OPODEE HP1502R PTC Electric Space Heater

Model: HP1502R
User Manual

Thank you for choosing OPODEE Space Heater. Please read this User Manual thoroughly before use and retain it for future reference.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFERENCE When using an electrical appliance, especially when children are present, basic safety precautions should always be followed, including the following:

DANGER!

• DO NOT partially or fully cover or obstruct the front of this heater.
• DO NOT touch or hold the mains plug with wet hands.
• DO NOT touch hot surfaces with bare hands. Use handles when moving the unit.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by person responsible for their safety.
• Extreme caution is necessary when any heater is used near children, pets or the disabled. NEVER leave the heater unattended while operating.
• Suitable for dry locations only. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never place the heater where it may fall into a bathtub or other water container. Do not use or store where it may get wet or in the immediate surroundings of a bath, a shower, or a swimming pool.
• It is NOT intended for industrial or commercial use. Do not use outdoors. Use the appliance only for intended household purposes as described in this User Manual.

ELECTRICITY SAFETY

• This appliance must be provided with correct voltage via a professionally installed power socket. Make sure the voltage indicated on the label of the appliance is the same as your local supply.
• DO NOT operate the heater with a damaged cord or plug or if the product malfunctions, is dropped or damaged in any manner.
• Always plug heaters directly into a wall outlet/ receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
• To prevent overload and blown fuses, be sure that no other appliance is plugged into the same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.

IMPORTANT
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician, Do not attempt to rig this safety feature.

• DO NOT attempt to disassemble, repair, modify or replace any part of your product. All servicing should be performed by qualified personnel only.
• DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic areas and where it will not be tripped over. To avoid fire hazard, NEVER route cord under furniture or appliances.
• DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause electric shock, fire or damage to the heater.
• The heater has hot or arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored.
• Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 meters) from the front and top of the heater and keep them away from the sides and rear.
• Always make sure to place the heater on a flat, level and secure surface before operation.
• Always turn the heater OFF and unplug it before cleaning, making any repairs or servicing, or whenever not in use.
• It is normal that there is a trace of smoke or odor when using it for the first time. It will quickly evaporate and should not re-occur.

FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS

EXPLORING YOUR SPACE HEATER

Package Contents

• 1 x PTC Space Heater
• 1 x Front Base
• 1 x Rear Base
• 1 x Remote Control
• 1 x User Manual

Product Diagram

Specifications

Assembling Your Space Heater

Make sure that space heater is properly installed before plugging into an electrical outlet.

Step 1. Keep two base halves in a crossed position, then insert pegs on one half onto the slots on the other half. Press down on edges to click two base halves together. (Fig.1)

Step 2. Fit the base onto the bottom of the space heater by aligning the arrows on the underside. (Fig.2)

Step 3. Rotate the base counterclockwise to lock in place. (Fig.3)

Control Panel

LED Display

1. “-” Temperature Adjustment
2. Mode/Heat Level Setting
3. Timer Button
4. Power ON/OFF
5. Oscillation
6. Child Lock
7. “+” Temperature Adjustment
8. Timer Icon
9. Fahrenheit
10. Celsius
11. Temperature
12. ECO Mode
13. High Mode
14. Low Mode

| Power ON/OFF| •  Press once to turn ON (HI by default).

• Press once again to turn OFF (Standby mode) with 15s countdown delay.

---|---|---
| Temperature Setting| • With unit on, tap to set desired temperature (61- 95°F)

• When the set temperature is reached, the heater will stop heating

1′ re Conversion| • With unit on, hold + and – simultaneously for 2s to convert the temperature unit.
| Heating Mode| • With unit on, press to cycle through

High (HI) –+ Low (LO)-+ ECO-+ High (HI) modes.

• Temperature cannot be adjusted under HI or LO mode.

ECO Mode| • With unit on, press once to turn on ECO Mode. Keep pressing to set desired temp (61- 95°F).

• Once the set temp is reached, the heater will stop heating. It will start again when he temp drops to 2°F below the set one.

| Auto-off Timer Setting| • With unit on, press to set timer for turning off the heater (0-24H).

• To cancel, hold for 3s, or set timer to 00, or turn the unit off.

| Oscillation| • With unit on, press to start/ stop oscillating.
| Child Lock| • Long press the child lock button for 3s, and the lock icon turns into red, the child lock function is activated.

• When child lock function is activated, there is no response to any function button on the remote or control panel but the lock icon will flash.

• Long press the child lock button for 3s to deactivate child lock function.

Additional Features

Remote Control

• For added convenience, the same control buttons can be found on the remote control. Effective range: 16 ft. /5 m.

Replacing Remote Battery

• Replace with new batteries of the same type (CR2025,3V) when replacement is required.
• When not using the remote control for a long time,please take out the batteries.

1. Press the locking switch then hold to pull out the battery holder.
2. Replace the battery with the same type, making sure the(+) side facing up.
3. Push in the holder until securely locked into place.

WARNING

• Do Not Ingest Battery. Chemical Burn Hazard
  The This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death . Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children . If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. The batteries contain materials, which are hazardous to the environment; they must be removed from the appliance before it is scrapped and that they are disposed of safely.

CARE AND CLEANING

• Always make sure the heater is turned off and unplugged before cleaning.
• DO NOT stick any foreign objects or your fingers inside of the unit.
• Never immerse in water or allow water to drip into the motor housing.

Outer Surface

• Turn the heater OFF, unplug and wait for it to cool down. Wipe the surface with a soft, dry cloth only.

Air Inlet & Outlet Grills 

• Clean dust between the grills with a vacuum cleaner or air duster.

How to Disassemble the Base

• Press on the lock sign here and rotate clockwise to release the base from the space heater, then press the tabs on the edges to detach the base halves from each other.

Storage

• Cover and store in a cool dry location with the cord arranged away from traffic areas to avoid trip-over or damage.

TROUBLESHOOTING

The troubleshooting guide addresses the most common problems. If problems persist, feel free to contact the Customer Support at support@opodee.com

powered electrical outlet and the voltage indicated is the same as your local supply.

•  Make sure the temperature you set is higher than the ambient temperature.

•  When the set temperature is reached, the heater will stop heating. It will resume working again when the ambient temp is lower than the set one.

•  Check if you have enabled Auto-OFF timer, lap the power button to turn it on again.

My heater stops heating suddenly.| •  The heater is tipped over and shut off automatically. Place it back on a flat, level surface and remain upright. Then turn it on again.

•  The ambient temperature is above 122°F, unplug and wait for the temp to drop below 122°F before turning it on again.

•  The heater will turn off automatically after 24 hours of continuous use.

• In ECO mode, the heater will turn off automatically when the set temperature has been reached. This is normal. If your heater turns off frequently, please raise the set temperature, or switch to Power Heat mode.

WARRANTY AND SERVICE

Thank you for choosing OPODEE Space Heater. This product is covered with OPODEE product and labor warranty for 12 months from the date of its original purchase.

The warranty will not apply in cases of:

Accident, misuse, or repairs performed by unauthorized personnel.

• Any unit that has been tampered with or used for commercial purpose.
• Normal wear and tear of wearable parts.
• Use of force, damage caused by external influences.
• Damage caused by non-observance of the User Manual, e.g. connection to an unsuitable mains supply or non-compliance with the instructions.
• Partially or completely dismantled appliances.
• Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized.
  We can only provide after sales service for products that are sold by OPODEE or OPODEE authorized retailers and distributors. If you have purchased your unit from a different place, please contact your seller for return and warranty issues.
  Please have your invoice and order ID ready before contacting Customer Support.

Question or Concerns?

Email: support@opodee.com

PTC SPACE HEATER
MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>