Roadstar PCD-498NMP Portable CD MP3 Player User Manual

PCD-498NMP Portable CD MP3 Player
User Manual

• Your new unit was manufactured and assembled under strict ROADSTAR quality control. Thank you for purchasing our product for your music enjoyment. Before operating the unit, please read this instruction manual carefully. Keep it also handy for further future references.

PCD-498NMP

LOCATIONS OF CONTROLS

1. LCD DISPLAY
2. PLAY/PAUSE
3. STOP
4. SKIP –
5. SKIP +
6. PROGRAM
7. MODE
8. OPEN
9. CD DOOR
10. VOLUME KNOB
11. HEADPHONES OUT
12. DC INPUT JACK
13. RECHARGE SWITCH
14. BATTERY COMPARTMENT

POWER SUPPLY

USE WITH REGULAR BATTERIES (NOT INCLUDED)

1. Open the battery compartment door, located on the bottom of the unit, by sliding the door and lift it up. (Do not remove the battery door);
2. Insert 2 x 1.5V /UAM-3/AA size alkaline batteries, following the correct polarity, as indicated in the battery compartment;
3. Close the battery compartment door. If the symbol “LOW BATTERY“ appears in the display, batteries are weak and ought to be replaced.

USE WITH AC/DC ADAPTOR (NOT INCLUDED)

1. Insert the DC plug, at the end of the AC/DC adaptor cord, into the DC 5 V INPUT socket (12) located on the back of the unit;
2. Connect the AC/DC adaptor to a 100-240V ~ 50-60 Hz AC power outlet.

Notes:

• If the AC adaptor is connected when regular batteries are installed, the power supply automatically switches to the AC power source.
• Use only the supplied AC/DC adaptor. Using other types of adaptors may damage the unit.
• Make sure that the AC/DC adaptor matches with your household voltage before connecting it to the wall outlet.
• When not using AC power, disconnect the AC/DC adaptor from the wall outlet.
• Do not touch the AC/DC adaptor with wet hands.

USE RECHARGEABLE BATTERIES (NOT INCLUDED)

1. Disconnect the AC/DC adaptor from the wall outlet if it is being connected to the unit;
2. Open the battery compartment door as mentioned previously;
3. Insert 2 recommended rechargeable batteries, following the correct polarity as indicated in the battery compartment;
4. Close the battery compartment door;
5. Connect the AC/DC adaptor to the wall outlet;
6. Move the RECHARGE SWITCH (13) to ON to start the recharging function;
7. After 15 hours of charging set the RECHARGE SWITCH (13) to OFF.

Cautions:

• DO NOT mix rechargeable (Nickel-Cadmium) and regular (Carbon-zinc) batteries.
• DO NOT charge continuously for 24 hours or more, otherwise, it will deteriorate the performance of the rechargeable batteries.
• DO NOT try to recharge normal (not rechargeable) batteries. They can explode!

Notes:

• If the rechargeable batteries are being charged for the first time, it will take approximately 15 hours to be fully charged.
• If the operating time decreases drastically even when the rechargeable batteries are properly recharged, purchase a new set of rechargeable batteries.

AUTO POWER-OFF

When the unit is stopped for approximately 30 seconds, the Auto Power Off function will be activated and turn the unit off automatically..

CD-MP3 OPERATION

1. Connect your earphones to the [HEADPHONES SOCKET] (11);
2. Press [OPEN] (8) to open the [CD DOOR] (9) and place a CD with the label up in the CD compartment;
3. Close the [CD DOOR] (9);
4. Press [PLAY] (2). Focus search is performed and playback will start automatically from the  first track;
5. Adjust the volume with the [VOLUME KNOB] (10) to the desired level;
6. To turn the unit off, press the [STOP] button (3) twice.

Note:

• Press [PLAY-PAUSE] (2)to play. When it plays, press to stop playback temporarily and press again to resume playback.
• Press [STOP¨] (3) when you want to finish playback. Press twice to set off the unit.
• Press [SKIP -] (4) to go to the previous track, and press & hold to go back fast.
• Press [SKIP +] (5) to go to the next track, and press & hold to go fast forward.

PROGRAMMING
Up to 99 tracks (MP3, 20 in CD) can be programmed and played in any order.

1. Stop the playback by pressing [STOP] (3);
2. Press [PROGRAM] (6), and the display (1) will show the number of the track on the left side and the number of program on the right side.
3. Select desired track by using [SKIP -/+] buttons (4/5);
4. Press [PROGRAM] (6) to confirm desired track into the program memory;
5. Repeat steps 3 and 4 to enter additional tracks into the program memory.
6. When all the desired tracks have been programmed, press [PLAY] (2) to play the disc in the order you have programmed.

Note: Press [STOP] (3) to terminate programmed play.

REPEAT – RANDOM MODE

During playback, press repeatedly the [MODE] (7) to select:

• REP-ONE: The current track is played repeatedly.
• REP-ALL: All tracks are played repeatedly.
• REP-FOLDER: The current folder is played repeatedly.
• RANDOM: Tracks are played randomly.
• INTRO: All tracks are played for 10 seconds.

AUTO-RESUME FUNCTION

• If you pause the device for a long time it will automatically switch off in order to save battery life.
• If you press [PLAY-PAUSE] (2) the device will turn on and resume the track you were listening to.
• Please note that the auto-resume function is enabled only if the device is connected to some power source (DCcable or batteries).

ANTI-SHOCK FUNCTION

• If in use, the player is likely to receive shocks or vibrations (i.e. whilst walking or in a moving vehicle). As soon as the PLAY/PAUSE button is pressed, the ASP function is automatically activated to allow uninterrupted playback.
• Should the player receive shocks for more than 60 seconds continuously in CD playback or 100 seconds in MP3 playback, the sound can mute for a very short while and will resume once the player has stabilized from the shock.
• The Anti-shock function will not correct the errors arising from the use of defective scratched or dirty discs.

MAINTENANCE

Cleaning the unit
Wipe the outside surface of the unit with a soft cloth moistened with water and mild soap.

Handling CDs
Your CD player has been specially designed for the reproduction of compact discs bearing the CD mark. No other discs should be loaded into the player.
Always place the disc in the tray with the label facing up.
Although compact discs are impervious to wear during play, damage to the surface of a disc through improper handling will result in playback irregularities.
To preserve your compact discs, please handle them with care.
Although minute dust particles and fingerprints should have no effect on playback, you should keep the serface of the recorded side of your discs clean by wiping the disc with a  clean, dry, lint-free soft cloth with straight movements from the center outwards.
Never use record cleaners, record sprays, antistatic sprays, liquids or chemical-based liquids to clean the surface of a disc. They may in fact irreparably damage the disc’s plastic
surface.
Always return the disc to its protective plastic case when not using it. Avoid exposing discs to direct sunlight, excessive temperatures, or high humidity for extended periods of time. Do not write on the label side of the disc with a ball/point pen as this may scratch the disc.

IMPORTANT

Since the movement of the CD mechanism and the sensitive circuitry may cause interference to a radio tuner nearby switch this unit off while operating other radio devices.
This product utilizes a laser:
Danger – Invisible laser radiation when opened and interlock failed or defeated. Avoid direct exposure to the beam.
Caution – Use of controls, adjustments, or procedures not listed in this manual may result in hazardous radiation exposure.

TECHNICAL SPECIFICATIONS

Power Supply:
USB plug to DC jack cable included
DC 5V (Adaptor not included).
DC 3V = (2 x “LR6” Batteries not included).

General
Headphones Out: 3.5mm jack plug.

Specifications and the design are subject to possible modifications without notice due to improvement.

WARNINGS

The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product.
The lightning flash with an arrowhead symbol within the triangle is a warning sign alerting the user of “dangerous voltage” inside the unit.
To reduce the risk of electric shock, do not remove the cover. No user- serviceable parts inside the unit. Refer all servicing to qualified personnel.
This unit operates on 230V ~ 50Hz. If the unit is not used for a long period of time, remove the plug from the AC mains.
Ensure all connections are properly made before operating the unit.
This unit must not be exposed to moisture or rain.
This unit should be positioned so that it is properly ventilated. Avoid placing it, for example, close to curtains, on the carpet or in a built-in installation such as a bookcase.
Do not expose this unit to direct sunlight or heat-radiating sources.

| CORRECT DISPOSAL OF THIS PRODUCT (Waste Electrical & Electronic Equipment) 
This marking shown on the product or its literature indicates that it should not be disposed of with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of waste and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their suppliers and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.
---|---

INTERNATIONAL WARRANTY

Serial No……….
Type of set……….
Purchase date……..
Dealer’s Stamp……..

is a registered Trademark of Roadstar S.A. – Switzerland. All rights reserved.

Roadstar Warranty Terms and Conditions
Roadstar- by means of its sales organization, representative or distributor- guarantees its products against manufacturing defects in material and/or workmanship throughout the period of warranty.
Should the product fail to work or shows a manufacturing defect within the warranty period, Roadstar- by means of its sales organization, representative or distributor – will take the necessary actions to restore the perfect functioning of the product. To repair or to replace is at the discretion of Roadstar or its representative or distributor. The warranty period is in accordance with directive 99/44/CE of the European Union. For all non-EU members, please refer to the local law of each country. This warranty does not cover normal wear and tear of the product and/or its parts, any damage, failure, or loss caused by accident, misuse, and any other failure not directly related to a defect of the product.
This warranty does not void consumer’s rights in accordance with EU Directive99/44/CE. For further information please visit the website www.roadstar.com, or write o aftersales@roadstar.com.

Hereby, Roadstar Management SA declares that the equipment type PCD-498NMP is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://roadstar.com/images/ce/PCD-498NMP.pdf or by scanning the following QR Code.

http://roadstar.com/images/ce/PCD-498NMP.pdf

www.roadstar.com

References

• roadstar.com/images/ce/
• Roadstar Management SA - Home

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>