Bellini BOM613G Built in Electric Oven User Manual

: June 3, 2024
: Bellini

Table of Contents

Bellini BOM613G Built in Electric Oven User Manual
DANGER
GROUNDING INSTRUCTIONS
WARNING
IMPORTANT – BEFORE YOU BEGIN
Aftercare Instructions
TOOLS USED
ELECTRICAL WIRE INFORMATION
Please follow below illustrations
INSTALLATION GUIDE
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Bellini BOM613G Built in Electric Oven User Manual

DANGER

Risk of personal injury. To avoid possible electrical shock, the electricity must be turned oﬀ at the circuit breaker or fuse box before attemting any installation procedure. The mirror must also be properly grounded. To reduce the risk of burns, fire, electric shock or injury to persons. Use this furnishing only for it’s intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. Never drop or insert any object into any opening. Do not use outdoors.

GROUNDING INSTRUCTIONS

This product must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the product.

WARNING

All fitings must be installed in accordance with current IEE wiring regulations. If in doubt, consult a qualified electrician.
Switch off the electrical supply at the main circuit board BEFORE installation and maintenance.
Suitable for Bathroom Zones 2, 3 and non bathroom/dry areas. See diagram below.
NOT suitable for above baths or Zone 1 not for installation in Saunas, Steam
Rooms or Shower Cubicles.
DO NOT fix to damp or conductive surfaces.
Suitable for indoor use only. Site well away from curtains and fabrics.
Never cover the mirror. Switch off atier use.

IMPORTANT – BEFORE YOU BEGIN

Inspect the product immadiately upon receipt for transit damage or missing parts.
Handle the product with care and protect against knock to all sides and edges of the glass.
Make sure that you have all the tools you need to complete the job. (SEE BELOW)
Ensure ther are no hidden pipes or cables in the wall before drilling.
If drilling holes in ceramic tiles use a piece of masking tape on the tile to stop the drill bit from slipping.

Aftercare Instructions

Clean using a soft dry cloth only when turned oﬀ.
Never use cleaning agents or abrasive materials.
Do not allow moisture to come into contact with lamps.

TOOLS USED

ELECTRICAL WIRE INFORMATION

The Lead Contains 3 Wires:
COPPER WIRE (GREEN) = GROUND WIRE… Connect to GROUND WIRE in your box, or to the box as a ground.
WHITE (or BROWN) = NEUTRAL WIRE… Connect to the WHITE NEUTRAL WIRE in your box.
BLACK (or BLUE) = HOT WIRE… Connect to the BLACK HOT WIRE in your box.
The Bijou wires will be connected to your 120 Volt electric box. This should be placed in the wall, behind your Icon Bijou. The suggested method for placement is towards the center, however there is ﬂexibility with the lead wire.