vtech 21181 Switch and Go Dinos Hero The Triceratops Instruction Manual

21181 Switch and Go Dinos Hero The Triceratops

“`html

Specifications:

• Product Name: Hero the Triceratops
• Power Source: 2 AA (AM-3/LR6) batteries
• Recommended Battery Type: Alkaline or fully charged Ni-MH
  rechargeable batteries

Product Usage Instructions:

Getting Started:

WARNING: Adult assembly required for battery
installation. Keep batteries out of reach of children.

1. Make sure the unit is turned Off.

2. Locate the battery cover on the bottom of the unit. Use a
   screwdriver to loosen the screw and then open the battery
   cover.

3. If used batteries are present, remove these batteries from the
   unit by pulling up on one end of each battery.

4. Install 2 new AA (AM-3/LR6) batteries following the diagram
   inside the battery box. (For best performance, alkaline batteries
   or fully charged Ni-MH rechargeable batteries are
   recommended).

5. Replace the battery cover and tighten the screw to secure.

Product Features:

1. Off/Low/High Volume Switch: Slide to Low or
   High volume position to turn On or adjust volume. Slide to Off
   position to turn Off.

2. Voice Button: Press for fun phrases and sounds
   in Dino or Vehicle mode.

3. Water Burst Button: Insert Water Burst,
   activate light in Water Launcher, then press to launch Water
   Burst.

4. Rescue Motorcycle: Pull out Launch Pad, rev
   Rev-Up Lever, press Motorcycle Launcher lever to launch
   Motorcycle.

5. LCD Screen: Displays animations in Dino and
   Vehicle modes.

Care & Maintenance:

1. Keep the unit clean by wiping it with a slightly damp
   cloth.

2. Avoid direct sunlight and heat sources.

3. Remove batteries if not in use for an extended period.

4. Avoid dropping on hard surfaces or exposure to extreme
   conditions.

FAQ:

Q: How do I switch between Dino and Vehicle modes?

A: Follow the steps provided in the manual to
switch between modes. Begin in Dino mode and reverse the steps to
switch back.

Q: What type of batteries should I use for optimal

performance?

A: It is recommended to use alkaline batteries
or fully charged Ni-MH rechargeable batteries for best
performance.

“`

Instruction Manual
®
HERO THE TRICERATOPS

INTRODUCTION
Switch into fun with Switch & Go Dinos® Hero the Triceratops! Switch this mighty Fire Engine into a tough Triceratops and back in just a few simple steps! Launch the Water Burst and release the Rescue Motorcycle to save the day! Let’s go!
Water Burst Button Voice Button
LCD Screen
Motorcycle Launcher

Off/Low/High Volume Switch

Launch Pad

Rev-Up Lever

2

INCLUDED IN THE PACKAGE
· Switch & Go Dinos® Hero the Triceratops · Quick Start Guide WARNING All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety. NOTE Please save this Instruction Manual as it contains important information. WARNING Do not aim at eyes or face. Do not discharge any object other than the projectile provided with this toy. NOTE Please remove all the cable ties before playing with this toy.
3

GETTING STARTED
WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children.
Battery Removal and Installation
1. Make sure the unit is turned Off. 2. Locate the battery cover on the bottom
of the unit. Use a screwdriver to loosen the screw and then open the battery cover. 3. If used batteries are present, remove these batteries from the unit by pulling up on one end of each battery. 4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended). 5. Replace the battery cover and tighten the screw to secure.
4

IMPORTANT: BATTERY INFORMATION
· Insert batteries with the correct polarity (+ and -). · Do not mix old and new batteries. · Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. · Only batteries of the same or equivalent type as recommended
are to be used. · Do not short-circuit the supply terminals. · Remove batteries during long periods of non-use. · Remove exhausted batteries from the toy. · Dispose of batteries safely. Do not dispose of batteries in fire. RECHARGEABLE BATTERIES · Remove rechargeable batteries (if removable) from toy before
charging. · Rechargeable batteries are only to be charged under adult
supervision. · Do not charge non-rechargeable batteries.
5

Disposal of batteries and product
The crossed-out wheelie bin symbols on products and batteries, or on their respective packaging, indicates they must not be disposed of in domestic waste as they contain substances that can be damaging to the environment and human health. The chemical symbols Hg, Cd or Pb, where marked, indicate that the battery contains more than the specified value of mercury (Hg), cadmium (Cd) or lead (Pb) set out in the Batteries and Accumulators Regulation. The solid bar indicates that the product was placed on the market after 13th August, 2005. Please dispose of your product and batteries responsibly. In the UK, give this toy a second life by disposing of it at a small electricals collection point so all of its materials can be recycled. Learn more at: www.vtech.co.uk/recycle www.vtech.com.au/sustainability Visit www.recyclenow.com to see a list of collection points near you.
6

PRODUCT FEATURES
1. Off/Low/High Volume Switch
To turn the unit On or to adjust the volume, slide the Off/Low/High Volume Switch to the Low or High volume position. To turn the unit Off, slide the switch to the Off position.
2. Voice Button
Press the Voice Button to hear fun phrases and cool dinosaur sounds in Dino mode. In Vehicle mode, press the Voice Button to hear fun phrases and cool fire engine sounds.
3. Water Burst Button
Insert the Water Burst into the Water Launcher, the light in the Water Launcher will activate, then press the Water Burst Button to launch the Water Burst.
4. Rescue Motorcycle
Pull out the Launch Pad, and then rev the Rev-Up Lever several times. Then, press the Motorcycle Launcher lever to launch the Rescue Motorcycle.
5. LCD Screen
The LCD Screen displays dino eye animations in Dino mode and shows driver animations in Vehicle mode.
7

6. LED Lights
The LED lights flash along with the sounds in Dino mode and Vehicle mode.
7. AUTOMATIC SHUT-OFF
To preserve battery life, Hero the Triceratops will automatically shut off after approximately 20 seconds without input. The unit can be turned on again by pressing the Voice Button or by switching between Dino and Vehicle modes. NOTE If the unit powers down or if the light fades out during play, please install a new set of batteries.
HOW TO SWITCH

1. Begin in Dino mode. Flip the horns and close the jaw.

2. Rotate the crest down and then push the head in.

8

3. Adjust the water launcher backwards.

4. Aim the water launcher forwards.

5. Flip up the tail.

6. Flip out the rear legs.

7. Flip the rear legs up.

8. Rotate the lower legs up.

9

9. Rotate the lower legs.

10. Flip the front legs up.

11. Rotate each front leg and shoulder.

12. Flip the front bumpers out.

13. Push the front bumpers and wheels in.

14. The unit is now in Vehicle mode.

To switch back to Dino mode, reverse the steps above.
10

CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct
heat sources. 3. Remove the batteries if the unit will not be in use for an extended
period of time. 4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water. 5. If the unit stops working or malfunctions, install a brand new set of
batteries.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions, please follow these steps: 1. Turn the unit Off. 2. Interrupt the power supply by removing the batteries. 3. Let the unit stand for a few minutes, then replace the batteries. 4. Turn the unit On. The unit should now be ready to use again. 5. If the unit still does not work, install a brand new set of batteries. If the problem persists, please contact our Consumer Services Department and a service representative will be happy to help you.
11

CONSUMER SERVICES
Creating and developing VTech® products is accompanied by a responsibility that we at VTech® take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to call our Consumer Services Department with any problems and/or suggestions that you might have. A service representative will be happy to help you.
UK Customers: Phone: 0330 678 0149 (from UK) or +44 330 678 0149 (outside UK) Website: www.vtech.co.uk/support
Australian Customers: Phone: 1800 862 155 Website: support.vtech.com.au
NZ Customers: Phone: 0800 400 785 Website: support.vtech.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers: Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers: VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED ­ CONSUMER GUARANTEES Under the Australian Consumer Law, a number of consumer guarantees apply to goods and services supplied by VTech Electronics (Australia) Pty Limited. Please refer to vtech.com.au/consumerguarantees for further information.
12

Visit our website for more information about our products, downloads, resources and more.
www.vtech.co.uk www.vtech.com.au
© 2023 VTech. All rights reserved.
IM-549400-003 Version:0

References

• Support : VTech Electronics

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>