CONTROL by WEB X-410W Web Enabled Programmable Controller User Guide
- September 29, 2024
- CONTROL by WEB
Table of Contents
CONTROL by WEB X-410W Web Enabled Programmable Controller
Basic Setup Steps
-
Power the module and connect via ethernet to a computer.
-
Set IP address on computer to the same network as module.
(Ex: 192.168.1.50) Note : restore computer settings after setup. -
To configure module, open web browser and enter: http://192.168.1.2/setup.html
-
In General Settings under WiFi, enter the WiFi settings.
-
Assign the module a permanent IP address or enable DHCP.
-
Restart the module for the settings to take effect.
Factory Default Settings
- IP Address: 192.168.1.2
- Subnet Mask: 255.255.255.0
- Control Page Web Address: http://192.168.1.2
- Control Password: (no password set)
- Setup Page Web Address: http://192.168.1.2/setup.html
- Setup Username: admin
- Setup Password : web relay (all lower case)
Pinout Diagram
www.ControlByWeb.com
1681 West 2960 South, Nibley, UT 84321, USA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>