hp CC16 Slide Top Crosscut Shredder User Manual
- June 3, 2024
- HP
Table of Contents
hp CC16 Slide Top Crosscut Shredder User Manual
Shredder overview
- Power cord located in back
- Slide top cover in closed position
- Slide top cover recessed finger grip area
- Shredder head
- Shredder cabinet
- Pull-out 5 gal waste bin
- Clear window for shred inspection
- Casters for easy mobility
- Slide switch for power On, Off, Reverse
- Slide top cover in open position
- Paper feed entry slot for up to 16 sheets1
- Credit card entry
- Power on Ready LED light
- Overheat LED tight
Sole remedies/No incidental or consequential damages
To the extent allowed by local law, the remedies provided in this Limited
Warranty are your sole and exclusive remedies. These terms and conditions
supersede any prior agreements or representations, including statements made
in sales literature or advice given in connection with your purchase.
TO THE EXTENT ALLOWED BY LOCAL LAW, AND EXCEPT AS SPECIFICALLY SET FORTH IN
THIS LIMITED WARRANTY, IN N0 EVENT SHALL HP, ANY HP SERVICE CENTER 0R ANY HP-
AUTHORIZED SERVICE PROVIDER BE LIABLE FOR ANY AMAGES CAUSED BY THE PRODUCT OR
THE FAILURE OF THE PRODUCT TO PERFORM, INCLUDING ANY DIRECT, INDIRECT,
SPECIAL, INCIDENTAL 0R C0NSE9UENTIAL DAMAGES, WHETHER BASED 0N CONTRACT, TORT,
0R ANY OTHER LEGAL THEORY, AND WHETHER 0R NOT ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES.
Important information:
A few pieces of shredded paper may be found inside the shredder and the
wastebasket.
This is normal. API HP shredders are tested at the factory to ensure quality.
Setup
- The CC16 shredder should be placed on a flat level surface.
- To install the casters, carefully lay the shredder on its back. Place the long post of each caster inside the hole located in each corner on the bottom of the shredder. Push each caster into place until you hear or feel it snap and lock into place. Place the shredder in an upright position. take sure the shredder stands evenly and that all four casters fit squarely on the floor.
- Place the shredder head securely on the top of the shredder cabinet.
- Blake sure that the waste bin is completely inserted into the shredder cabinet and that it fits fuss with the shredder cabinet.
- Plug the power cord into any standard 115—volt AC outlet. We recommend that you do not plug your shredder into the same outlet as other electronic devices.
- To operate the shredder, slide the top cover towards the rear of the shredder by placing both thumbs in the recessed area located on the top of the shredder. Directional arrows wilt indicate the direction to open the cover. The sliding top in the open position will reveal the power On, Off and Reverse switch. The paper feed area will now be visible.
Operation
Plug in the electrical cord and move the slide top cover into the open
position. take sure the pull-out waste bin is properly secured. Slide the
Power On, Off, Reverse switch to the On position. The Ready LED will light up.
The shredder is now ready for operation.
Shredding: A maximum of 16 sheets at one pass or a single credit card is
recommended. Exceeding the maximum 16 sheet or multiple credit card insertions
could result in unnecessary paper jams. When the paper is inserted into the
feed opening, the shredding process wilt start automatically and stop when the
paper has completed its travel through the feed opening.
Electronic features
The Ready LED lets you know the shredder is working and ready to shred.
Photo sensor allows auto start, stop feature.
Motor overload and overheat protection circuit will protect the shredder
motor.
Sheet capacity:
The CC16 will shred up to sixteen (16) sheets and will accept paper widths up
to 8 3/4 inches.
When shredding small material like credit cards, envelopes, or receipts,
insert them through the middle of the feed opening
Paper jams and motor overload situations:
The CC16 is equipped with an automatic motor overload and an overheat
protection circuit.
Power will automatically terminate in case of the following abnormal
situations.
- Operating the shredder at the maximum 16-sheet capacity continuously for a prolonged period of time. A running time of 3 minutes on and 40 minutes off is recommended.
- Exceeding the shredding capacity by inserting more than sixteen {16) sheets of Z0-lb.
paper in one pass, or if the paper is not fed squarely into the feed opening.
Both abnormal operations may result in the activation of the automatic thermal motor overload protection circuit, which terminates the power to the shredder. A paper jam could cause the thermal motor overload protection to terminate AC power to the motor. Never allow the shredder to remain in a jammed condition with the AC power turned on.
In case of a minor paper jam:
- Place the slide switch in the Reverse position and pull the remaining sheets of paper out of the feed opening. Be careful not to place your fingers near the feed opening or serious harm could result.
- Take sure that all of the excess paper has been removed from the feed opening and place the slide switch back in the On position.
- You are now ready to resume normal shredding.
In case of a major paper jam:
- Turn off or unplug the power cord from the AC outlet and wait at least 40 minutes for the thermal overload protection to reset.
- Plug in the AC power cord. If paper was left inside the feed opening prior to the overload, place the slide switch in the Reverse position and grasp the excess paper from the top and pull it out. Be careful not to place your fingers near the feed opening or serious harm could result. Place the slide switch back into the On position.
- You are now ready to resume normal shredding.
Specifications:
Shred type: Crosscut
Shred width: 4.3mm x 33mm
Shredding capacity: 16 Sheets (20 lb. bond paper) or 1 Credit Card
Duty cycle: 3minon/40minoñ
Feed opening: 83/4inches
Dimensions (W x D x H ): 13.78“x9.45″x18.47“
Weight: 16.97 lbs. (7.7 Kg)
Input: 115 volt AC, 5.5 Amp, 60Hz
Ambient Operating Temp: Maximum 87.8°F (31°C)
Warning
- ALWAYS keep out of the reach of children as serious injury could occur.
- DO NOT place fingers too close to feed slot as serious injury could occur.
- AVOID petting jewelry, hair or loose clothing too close to feed slot as serious injury could occur.
- ALWAYS keep shredder off and unplugged when not in use.
- ALWAYS unplug shredder when moving, cleaning or emptying the waste receptacle.
- DO NOT attempt to feed more sheets of paper than specified on the shredder.
- DO NOT attempt to shred materials other than paper, credit cards.
- ALWAYS use a power outlet or socket near the shredder so it is easily accessible.
- ALWAYS limit continuous shredding to the specified time as suggested in the instruction manual.
- ALWAYS empty the waste receptacle prior to the receptacle becoming full.
- DO NOT attempt to operate the shredder if it is experiencing any kind of problem.
- DO NOT use flammable synthetic oil, petroleum-based or aerosol products of any kind on shredder.
- DO NOT touch exposed cutting blades under the shredder head.
- DO NOT attempt to repair shredder yourself.
Warning icons
The Icons, on top of the shredder, warn the user of the potential dangers if
the shredders used improperly
Warning: Certain actions may cause harmful outcomes
Read user manual completely prior to using shredder
Keep children and pets away from shredder
Keep fingers and hands away from paper shredding opening
Keep loose clothing and dangling items away from paper shredding opening
Keep long hair or accessories away from paper shredding opening
Do not spray aerosol, lubricants or any other accelerant products into this unit
Limited warranty
Your HP Product is warranted to be free from defects in materials or workmanship under normal use for one year, with an additional 2 years on the cutting blades starting on your date of purchase. Your dated sales or delivery receipt is your proof of purchase. You may be required to provide proof of purchase as a condition of receiving warranty service.
During the warranty period, if a defective HP Product covered by this Limited
Warranty is returned to the designated Service Center, it wilt be repaired or
replaced or, at the option of the Service Center, its purchase price wilt be
refunded. No repair, replacement or refund will be provided unless the
defective HP Product is returned to the Service Center at your expense; for
some HP Products, no return will be accepted unless the Service Center first
provides you with a Return Material Authorization (RMA). If your HP Product
has recurring failures, at the option of the Service Center, either you will
be furnished with a different product that is equivalent in performance or you
will receive a refund of your purchase price. Service Center support may be
provided by an HP subcontractor or other third parties. Please see the Service
Center
information provided.
Where permitted by local law, HP Products and any replacement products or parts may contain new materials or used materials equivalent to new in performance and reliability. Replacement products or parts wilt have functionality at least equal to that of the product or part being replaced. Replacement products and parts are warranted to be free from defects in materials or workmanship for 90 days, or for the remainder of the warranty period for the HP Product which they are replacing or in which they are installed, whichever is longer.
This Limited Warranty does not include technical assistance. This Limited Warranty does not cover cosmetic damage, loss or damage in transit, or damage resulting from (a) accident, misuse, abuse or other external causes; (b) product elements not supplied by HP; (c) improper site preparation or maintenance; or (d) modification or service by anyone other than HP, an HP Service Center or another HP—authorized service provider.
Limitations/Local laws
EXCEPT AS EXPRESSLY SET FORTH IN THIS LIMITED WARRANTY, THERE ARE N0 OTHER WARRANTIES, EXPRESS OR IMPLIED, FOR YOUR HP PRODUCT. ALL OTHER WARRANTIES, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY DISCLAIMED. ANY IMPLIED WARRANTIES IMPOSED BY LAW ARE LIMITED IN DURATION TO THE APPLICABLE WARRANTY PERIOD.
This Limited Warranty gives you specific legal riphts, and it is governed by the laws of the state and country in which your HP Product was purchased. You may also have other rights that vary from state to state and country to country. You are advised to consult applicable state and country laws to determine your rights. Some states and countries do not allow any limitation on how long a limited warranty will last, or any exclusion or limitation of incidental or consequential damages. In such states and countries, some of the exclusions or limitations stated in this Limited Warranty may not apply to you.
Customer Support
HP Warranty Processing
50 Hilton Street
Easton, PA 1 8042
www.hp.com/officeequipment
HP is a trademark of HP Inc. or its affiliates, used by Royal
Consumer Information Products under license from HP Inc.
Copyright, Royal Consumer Information Products, Inc. 2022,
All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>