IKEA TRADFRI Lumen Smart Wireless Dimmable Warm LED Bulb Instruction Manual
- September 27, 2024
- Ikea
Table of Contents
TRADFRI Lumen Smart Wireless Dimmable Warm LED Bulb
“`html
Product Information
Specifications
- Models: LED1935C3, LED1934G3, LED2102G3, LED2103G5
- Maximum distance for pairing: 5 cm (2 inches)
- Pairing time: > 10 seconds
- Language: English
- Maximum light sources: 10 per steering device
Product Usage Instructions
Add Light Sources to Your Steering Device
-
Ensure the light source is installed and the main power switch
is on. -
Hold the steering device within 5 cm of the light source you
want to add. -
Press and hold the pairing button for at least 10 seconds. A
red light will shine steadily on the steering device. The light
source will dim and flash once to indicate successful pairing. -
Repeat the above steps for each additional light source, up to
a maximum of 10 per steering device.
Important: Pair the light sources one at a
time. Disconnect already paired light sources from the main power
switch if they are close to each other.
Caution: Do not use with standard dimmers. Only
use the control specified in the instructions. This bulb is only
controllable by IKEA Smart lighting products.
Reset Your Device
Toggle the main switch 6 times to reset your device.
FAQ
Q: What should I do if my light source does not pair with the
steering device?
A: Make sure the light source is within 5 cm of the steering
device and try pairing again. If issues persist, refer to
troubleshooting section in the manual.
Q: Can I pair more than 10 light sources with one steering
device?
A: No, the maximum limit for pairing is 10 light sources per
steering device.
“`
TRÅDFRI
LED1935C3, LED1934G3, LED2102G3, LED2103G5
max 5 cm (max 2″)
10 s
English
6
9
English
6
ADD LIGHT SOURCES TO YOUR STEERING DEVICE: Before you can use your light source you’ll need to pair it with a steering device. To add more light sources, just repeat the steps below:
1. Make sure that your light source is installed and the main power switch is
turned on.
2. Hold the steering device close to the light source you want to add (no
more than 5 cm away).
3. Press and hold the pairing button for at least 10 seconds. A red light
will shine steadily on the steering device. Your light source will begin to
dim and finally flash one time to indicate that it has been successfully
paired.
Up to 10 light sources can be paired with 1 steering device.
7
Make sure to pair them one at a time. If the light sources are close to each
other, disconnect those that have already been paired from the main power
switch.
CAUTION: DO NOT USE WITH STANDARD DIMMERS. Only use the control provided with
or specified by these instructions to control this bulb. This bulb will not
operate properly when connected to a standard (incandescent) dimmer or dimming
control. Only controllable by IKEA Smart lighting products.
RESET YOUR DEVICE Toggle the main switch 6 times.
TECHNICAL DATA: Operating frequency: 2405 2480 MHz Output power: 10 dBm
8
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
The crossed-out wheeled bin symbol indicates that the item should be disposed
of separately from household waste. The item should be handed in for recycling
in accordance with local environmental regulations for waste disposal. By
separating a marked item from household waste, you will help reduce the volume
of waste sent to incinerators or land-fill and minimize any potential negative
impact on human health and the environment. For more information, please
contact your IKEA store.
9
: ,
. ,
:
. .
. .)” 5 (
0 . . . .
. 0- .
, .
10
: .
. . )(
. IKEA
. 6
: MHz 480 405 :
dBm 0 :
11
IKEA of Sweden AB : Box 702, SE-343 81 Älmhult, SWEDEN :
.
, .
. . ,
© Inter IKEA Systems B.V. 2022
AA-2373160-4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>