EASY 8 Pipette Pump Instructions
- September 25, 2024
- EASY
Table of Contents
EASY 8 Pipette Pump
“`html
Product Information
Specifications:
-
Product Name: Pipette pump EASY 8
-
Compatibility: Suitable for use with sterile pipettes of
various sizes -
Capacity: Depends on the size of the pipette used
-
Maintenance: Requires periodic lubrication with silicone
grease -
Material: Contains glass components, handle with care
Product Usage Instructions
Operation:
-
Insert the cotton-filled end of a sterile pipette into the
pipette pump tip. -
Rotate the wheel on the top of the pump to raise the piston
approximately 5 mm before inserting the pipette into the liquid to
create air pressure. -
Carefully rotate the wheel downwards with your thumb to fill
the pipette with liquid until it reaches the desired level. -
Remove the pipette tip from the liquid and dispense the liquid
in the desired location. -
To empty the liquid, press the top lever or rotate the wheel
upward to dispense from the pipette.
Maintenance:
-
Periodically lubricate the piston seal with silicone grease by
following these steps: -
Pull out the pin and remove the wheel.
-
Withdraw the piston and seal.
-
Grease the piston seal.
-
Reassemble in reverse order.
Additional Tips:
-
Ensure the pipette tip remains submerged in liquid during
pipetting. -
Handle glass pipettes with care to avoid shattering.
FAQ
Q: What should I do if the piston does not move smoothly?
A: Try lubricating the piston seal with silicone grease
following the maintenance instructions provided.
Q: Can I use any size of a pipette with this pump?
A: Be sure to use a pump that can accommodate the needed liquid
volume based on the size of your pipette. For example, use a 10 ml
pump with a 5 ml or 10 ml pipette.
“`
Pipette pump EASY 8
Pipette pump EASY 8
OPERATION
Insert the cotton filled
end of a sterile pipette into the
pipette pump tip.
&_Pipettes and pumps come in
different sizes. Be sure to use a pump that can take in the needed liquid
quantity (e.g. 10 ml pump with a 5 ml or 10 ml pipette).
2. By using the wheel on the top of the pump, the piston shall be raised
approximately 5 mm BEFORE inserting the pipette into the liquid.
&_ This step is necessary in order to
create additional air pressure into the pipette to expel the liquid.
5. Use your thumb to rotate the wheel downwards and the liquid should fill up
the pipette; Do this carefully until the liquid reaches the desired level.
6. Remove the tip of the pipette from the liquid and pour it in the desired
place.
7. Press the top of the lever for quick emptying the liquid or use your thumb
to rotate the wheel upward. This will cause the liquid to be dispensed from
the pipette. Lower the piston all the way to the pump shaft. Because you
created the extra space before pipetting, the entire contents of the pipette
should be dispensed.
MAINTENANCE
To maintain good sealing and free action of the piston, it is recommended to
lubricate the piston seal from time to time with silicone grease. Proceed as
follows:
l) Pull out the pin and remove the wheel
2) Withdraw piston and seal.
3) Grease the piston seal.
4) Re-assemble in reverse order.
3. Place the tapered tip of the pipette into the liquid. The tip should be
within the liquid during the pipetting.
4. Hold the pipette pump with one hand. Your thumb should be placed on the
wheel.
WARNING
Extreme care should be taken when inserting glass pipettes because of the
possibility of shattering. To loosen the pipette, pull it slightly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>