CENTEK CT-7032, CT-7033 Vacuum Sealer Instruction Manual

CT-7032, СТ-7033
VACUUM SEALER
Серия СТ
INSTRUCTION MANUAL

CT-7032, CT-7033 Vacuum Sealer

Dear Customer,
Thank You for purchasing a CENTEK brand product. We guarantee flawless function of this item, provided the guidelines of its operation are observed.
The vacuum sealer is a domestic appliance and is not designed for industrial applications!
INTENDED PURPOSE: the appliance is designed for prolonging the storage life of foods and non-food items by way of pumping air out of the packaging (i.e. vacuumizing).

SAFETY PRECAUTIONS

Please strictly observe the following instructions to avoid situations potentially hazardous for human life and health, as well as damage and premature failure of the appliance:

1. Use the appliance for its intended purpose only.

2. Before starting operation ensure that the power supply voltage indicated on the appliance corresponds to your household power grid voltage.

3. Do not pull the power cable if it touches sharp edges, is jammed by any objects or entangled.

4. Do not route the power cord and do not place the appliance itself in  areas with high humidity, on hot surfaces, near heat-emitting appliancesor open flames.

5. Do not use the appliance if:
   – the power cord is damaged;
   – the appliance has visible damage;
   – the appliance has been dropped from height;
   – the appliance has been exposed to moisture.

6. Never wind the power cord around the vacuum sealer!

7. Never place the operating appliance on soft pillows, woolen blankets, etc.!

8. This appliance should not used by persons (including children) with limited physical, sensory or mental abilities, or with insufficient knowledge or experience, except under the supervision of a person responsible for their safety or when they have been informed of and instructed in the use of the appliance by such a person. Take precautions not to let children play with the appliance.

9. Ensure that the appliance is turned off when not in use!

10. Do not keep the power plug in the socket:
    – when the appliance is out of order or malfunctioning;
    – before and during maintenance;
    – after using the appliance.

11. Do not pull or carry the appliance by its power cord.

12. Pull the plug from the electric socket by grabbing the plug itself to avoid damage to the power cord; do not pull the plug with wet hands.

13. In case of power cord damage it should be replaced, to avoid dangeroussituations, by the Manufacturer, a service centre or similar skilled personnel.

14. Special transportation (shipment) and sale instructions: none.

15. In order to avoid overheating and to prolong the service life of the appliance allow it to “rest” for approx. five minutes after each 10vacuumizing cycles.

16. Should you intend to transfer the appliance to another person, please turn the present manual over together with it.
    

APPLIANCE DESCRIPTION

1. «РЕЖИМ» button
2. «ЗАПАЙКА+ВАКУУМ» button
3. «ЗАПАЙКА» button
4. «СТОП» button
5. Hose attachment nozzle
6. Rubber roller
7. Sealing tape
8. Top cover latches
9. Thermal tape
10. «Container Vacuumizing» button
11. Knife for bags
12. Bag holders
13. Vacuum channel

SCOPE OF SUPPLY

– Vacuum sealer – 1 pc.
– Power cord – 1 pc.

– Vacuum container connection hose – 1 pc.
– Knife for bags – 1 pc.
– Vacuum bag, 12х20 cm – 5 pcs.
– Vacuum bag, 20х25 cm – 5 pcs.
– User Manual – 1 pcs.

OPERATING PROCEDURE PREPARATION FOR USE

In order to start vacuum sealing the bag has to be prepared first.
If you are not using pre-cut vacuum bags you make a bag by cutting a desired length from the roll. Use special serrated bags and vacuum bag rolls only. Ordinary plain bags are only suitable for weld sealing, no vacuumizing is possible with them.

USING THE APPLIANCE

1. Plug the power cord into the power socket of the appliance.

2. Open the appliance by pressing the top cover latches (8).

3. Place the edge of the bag to be made on the thermal tape surface (9) so that the bag is retained by the holders (12) (Fig. 1). Carefully close the top cover so that both side latches engage (Fig. 2).

4. Connect the appliance to power supply.

5. Select the desired mode using the mode button (1): dry, mild, wet (Fig. 3).

6. Press the «ЗАПАЙКА» button (3) if you only need to seal the bag.
   Otherwise press the «ЗАПАЙКА+ВАКУУМ» button (2) if you wish to pump the air from the bag and then seal it. The appliance will start operating. When the operating cycle is over the operating noise will stop and the mode indicator will go out. Press the latch buttons (8) and open the top cover.

7. If you wish you can make a second sealing seam as a precaution in case the first seam has not sealed the bag completely. To do so repeat the steps above, only without inserting the bag into the retainers (12); move it lower so that the edge of the bag is placed on the thermal tape and the first seam is visible on the outside. This method is desirable for 30 cm wide bags.

VACUUMIZING A CONTAINER OR BAG WITH A VALVE (FIG. 5)

1. You can vacuumize special containers or bags featuring a vacuum valve. To do so proceed as follows:
2. Open the appliance by pressing the top cover latches (8).
3. Connect the external vacuum tube to the hose connection nozzle (5) (located either on the outside the appliance or inside under the top cover); connect the other side of the tube to the vent opening on the vacuum container or the valve on the bag.
4. Press the «Container Vacuumizing» button (10); the vacuumizing mode indicator will light up and the appliance will start pumping the air out until a vacuum is achieved. The indicator light will go out and the vacuumizing process will stop.
5. Quickly close the vent opening so that air does not get back into the container or bag.

OVERHEAT PROTECTION
When the temperature of the heating tape exceeds the maximum safe temperature the appliance will automatically enter the overheat protection mode, the indicator will flash, the button will be inactive. When the heating tape cools down to s safe temperature (after approx. 2 minutes) the indicator will stop flashing and the appliance will return to normal mode and be available for further operation.
POSSIBLE PROBLEMS AND THEIR SOLUTIONS

side seams of the packaging (if you make the bags yourself).
• Make sure the top and bottom gaskets are free of dirt and foreign objects.
• A hose is connected to the device for pumping air from external objects.
The packaging is not sealed properly.| •There is too much liquid in the sealed bag. Freeze contents before sealing.
• Smooth out any wrinkles on the packaging. Keep the packaging in this condition until the pumping process begins.
• Device overheating. Allow the device to cool for a few minutes.
The control panel lights do not light up.| • Check the power connection.
• Check the mains voltage.
Air is not pumped out
from the external object.| • The air valve is located on an uneven surface. Place the valve on a flat surface, leaving the area directly below the valve clear.
• Make sure the appliance lid is closed.
After sealing, air began to penetrate into the package.| • Check the clasp and/or flap for crumbs or food particles as this may compromise the seal of the package.
• Moisture that has accumulated around the valve or fastener may compromise the seal of the package. Wipe off any accumulated moisture and reseal.
• Check the package for damage. When packaging foods with sharp edges or cuts, use paper towels as a protective layer.

MAINTENANCE

Disconnect the appliance from power supply and allow it to cool down before cleaning. Clean the appliance each time after use. Wipe the appliance with a damp soft cloth. Ensure that the appliance is completely dry before commencing operation.
WARNING! Never immerse the appliance in water or place it under a tap!
WARNING! Never use coarse tissue, sponges or abrasive pastes for cleaning. The use of any chemically aggressive and other substances not recommended for cleaning objects contacting with food is not allowed. Regularly clean the sealing gaskets of the vacuum chamber. Prevent the accumulation of crumbs on the sealing gaskets of the vacuum chamber. Be extremely careful when cleaning the sealing gaskets: damage to these can cause the appliance to fail. Vacuum seal bags can be re-used after cleaning. To clean the bags turn them inside out and rinse in warm water with mild detergent.
STORAGE AND TRANSPORTATION
ATTENTION! Do not leave the top cover latches engaged when storing the appliance. This may cause deformation to the sealing gaskets and failure of the appliance. Clean and let all parts of the appliance completely dry before storage and before resuming operation. Store the appliance in a dry ventilated place away from heat sources and direct sunlight.

SPECIFICATIONS

– Nominal voltage: 220-240 V ~50/60 Hz
– Power rating: 110 W
– Vacuum level: 65 kPa
– Output: 6 l/min
– Duration of a «ЗАПАЙКА+ВАКУУМ» cycle: 10 to 17 seconds
– Duration of a «ЗАПАЙКА» cycle: 6 to 13 seconds
– Sealing area length: 31 cm (the use of bags with a max. width of 30 cm is recommended)
– Seam width: 2.5 mm
– Noise level: 60 dB
– Number of continuous sealing cycles: ≥15 seams

DISPOSAL

Upon expiry of its service life the appliance can be disposed of separately from ordinary domestic waste. You can turn it over to a specialized electric and electronic appliance disposal and recycling centre.

CERTIFICATION DATA, GUARANTEE

The service life of this item is 5 years since the date of sale to the end user, provided the item will be used in strict accordance with the present manual and the applicable technical standards. Upon expiry of the service life please contact the nearest authorized service centre for suggestions as to further operation of the appliance. The manufacturing date of the appliance is integrated into the serial number (digits 2 and 3 – year, digits 4 and 5 – month of manufacture). If any questions related to appliance maintenance should arise, or if the appliance has malfunctions, apply to the  CENTEK TM Authorized Service Center. The address of the service center can be found on the website https://centek.ru/servis. Service support contacts:
Phone: +7 (988) 24-00-178, VK: vk.com/centek_krd. General Service Center:
OOO «Larina-Servis», Krasnodar, Phone: +7 (861) 991-05-42.
The product has the Certificate of Conformity.

MANUFACTURER AND IMPORTER INFORMATION

Imported to EAEU by: Individualniy Predprinimatel Asrumyan Karo Shurikovich. Address: Russia, 350912 Krasnodar, ul. Atamana Lysenko, 23, pgt. Pashkovskiy. Phone: +7 (861) 2-600-900.
DEAR VALUED CONSUMER!
The guarantee period for all appliances amounts to 12 months since the date of sale to the end consumer. With this Warranty Card the Manufacturer confirms the proper condition of the appliance and undertakes to repair, free of charge, all defects caused by the Manufacturer’s default.

GUARANTEE MAINTENANCE TERMS

1. The guarantee shall be valid if the following documentation conditions are observed:
   – The original Warranty Card shall be filled out correctly and clearly, indicating the of appliance model, serial number and sale date, the stamp of the seller company and signature of its representative shall be available, as well as the stamps on each coupon and the buyer’s signature in the Warranty Card.
   The Manufacturer reserves the right to reject guarantee maintenance if the buyer fails to provide the abovementioned documents or if the information contained therein is incomplete, illegible or ambiguous.

2. The guarantee shall be valid if the following operation conditions are
   observed:
   – the appliance is used in strict accordance with the present manual;
   – the safety rules and requirements are observed.

3. The guarantee does not apply to regular maintenance, cleaning, installation and setup of the appliance at the owner’s location.

4.  The guarantee does not apply in the following cases:
   – mechanical damage;
   – normal wear of the appliance;
   – non-observance of operation requirements or erroneous actions on the part of the user;
   – improper installation or transportation;
   – natural disasters (lightning, fire, flood, etc.), as well as any other causes beyond the Manufacturer’s or Seller’s control;
   – ingress of foreign objects, liquids or insects into the inside of the appliance;
   – repairs or modifications to the appliance by unauthorized persons;
   – use of the appliance for commercial purposes (loads exceeding normal domestic application), connection of the appliance to utility and telecommunication networks incompliant with national technical standards;
   – failure of the following accessories, if replacement of these is allowed by design and does not involve disassembly of the appliance:
   a) remote control units, rechargeable batteries, replaceable batteries (power cells), external power supply units and chargers;
   b) consumables and accessories (packaging, covers, slings, carry bags, mesh screens, blades, flasks, plates, supports, grilles, spits, hoses, tubes, brushes, nozzles, dust collectors, filters, smell absorbers);
   – for battery-powered appliances – operation with inappropriate or depleted batteries;
   – for rechargeable battery-powered appliances – any damage caused by improper battery charging and recharging.
   5. The present guarantee is provided by the Manufacturer in addition to the consumer rights determined by the applicable legislation and does not limit these rights in any way.
   6. The Manufacturer shall not be made liable for possible damage, directly or indirectly inflicted by CENTEK brand products on people, domestic animals, the consumer’s or third persons’ property if such damage is inflicted as the result of non-observance of appliance installation and operation requirements, deliberate or negligent actions (omission) by the consumer or third persons, as well as of force majeure circumstances.
   7. Service centers will only accept appliances in a clean state (there should be no food residues, dust and other contamination on the appliance).

The Manufacturer reserves the right to change the design and specifications of the appliance without prior notice.
WARRANTY CERTIFICATE
ATTENTION!  Please ask the seller to fill out the warranty card and tear- off coupons in full. The ticket is valid in the presence of all stamps and marks
PRODUCT…………………………….
MODEL………………………………….
SERIAL NUMBER……………………..
DATE OF SALE………………………….
These tear-off coupons are filled in by a representative of the seller
PRODUCT…………………………….
MODEL…………………………….
SERIAL NUMBER………………………
DATE OF SALE……………………………
COMPANY-SELLER…………………….
COMPANY-SELLER……………………
The legal address of the seller’s company
FULL NAME AND PHONE NUMBER OF THE BUYER
These tear-off coupons are filled in by a representative of the service center
TYPE OF REPAIR…………………………….
DATE OF RECEIPT……………………………
RELEASE DATE………………………………..

WWW.CENTEK.RU

References

• Сервис - Официальный сайт Centek
• VK.com | VK
• Главная страница - Официальный сайт Centek
• Сервис - Официальный сайт Centek

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>