OLIGHT Baton Turbo Long Range Flashlight User Manual
- September 24, 2024
- OLIGHT
Table of Contents
OLIGHT Baton Turbo Long Range Flashlight
Specifications
- COOL WHITE CCT: 5700~7000K CRI:70
- TURBO
- 800 lumens
- 100% – 2.5min
- 38% – 70min
- 10% – 12min
- HIGH
- 300 lumens
- 100% – 82min
- 20% – 20min
- MEDIUM
- 60 lumens
- 100% – 8h
- LOW
- 10 lumens
- 100% – 60h
- MOONLIGHT
- 1 lumen
- 100% – 50days
- 62,500cd
- 500m
- 1.5m
- (L)81.7(D)29mm (L)3.22(D)1.14in
- Rechargeable Li-ion Battery 1100mAh 3.6V (3.96Wh)
- Above data are tested per ANSI/PLATO FL 1-2019 standard in Olight’s labs for reference.
Product Usage Instructions
Remove Insulating Film
Before using the flashlight, remove the insulating film as shown in Figure 1.
Charging the Flashlight
To charge the flashlight, use the USB Magnetic Charging Cable provided. The
charging status is indicated by red for charging and green for charging
completed.
Turning On/Off the Light
To turn on or off the light, press the button as indicated in Figure 3.
FAQ
Q: How do I change the brightness level?
A: Double press quickly to enter Turbo mode or follow the instructions
for different modes as shown in the manual.
Q: How do I lock/unlock the flashlight?
A: Press and hold the button for more than 1 second to lock or unlock the
flashlight as indicated in Figure 4.
IN THE BOX
Multi-language dictionary
Multi-language dictionary, see Table 3.
SPECIFICATIONS
Product specifications, see Table 1 and Table 2.
Operating instructions as below:
Table 1
Table 2:
USB Magnetic charging cable
ASSEMBLY INSTRUCTION
Remove the insulating film before use, see Figure 1.
Charge the flashlight, see Figure 2.
Turn On/Off the flashlight, see Figure 3.
Press the button to turn on/off the flashlight. When turned on, the flashlight
will light up at the memorized brightness level. (Moonlight, Low, Medium, and
High modes will be memorized when turned off. Turbo mode will be memorized as
High mode; High mode output will be memorized for 1 minute before switching to
Medium mode; Strobe mode will not be memorized.)
Lock/Unlock, see Figure 4.
To lock the flashlight, when it’s off, press and hold the switch (for about 2
seconds) until the Moonlight mode turns on and off. In lockout mode, press the
switch once to display the remaining battery level without turning on the
flashlight. Press and hold the switch for 1 second or longer to unlock it and
activate Moonlight mode.
Moonlight mode, see Figure 5.
To activate Moonlight mode, press and hold the button for 1 second or longer
when the flashlight is off. If the last used mode was Moonlight mode, simply
press the button.
Turbo mode, see Figure 6.
Quickly double-press the button to enter Turbo mode.
Strobe mode, see Figure 7.
Quickly press the button three times or more to enter Strobe mode. Press the
button once or hold it down to exit Strobe mode.
Change the brightness level, see Figure 8.
When the flashlight is on, press and hold the button.
The flashlight will cycle through Low, Medium, and High modes, starting from
the present brightness level.
Release the button to select the desired brightness level. (Note: Moonlight
mode and Turbo mode are not included in this cycle).
Auto Shut-Off function, see Figure 9.
The flashlight can be set to automatically turn off after two preset periods:
a long period (9 minutes) and a short period (3 minutes). To activate the Auto
Shut-Off function, double-press and hold the button when the flashlight is on.
After the function is turned on, the light will flash once to indicate that
the short period is set, and twice for the long period. To switch between
timing periods, double-press and hold the button during a timing period. When
reactivating the Auto Shut-Off function, the previous timing setting will be
used.
Indicators instructions as below
Brightness level indicator, see Figure 10-1.
Battery level indicator, see Figure 10-2.
WEEE Disposal and Recycling Information
All products bearing this symbol are waste electrical and electronic equipment
(WEEE as in directive 2012/19/EU) which should not be mixed with unsorted
household waste.
Instead, to protect human health and the environment, you should dispose of
your waste equipment at a designated collection point for the recycling of
WEEE, appointed by the government or local authorities. Proper disposal and
recycling will help prevent potential negative consequences to the environment
and human health.
Please contact the installer or local authorities for more information about
the location as well as terms and conditions of such collection points.
FCC compliance statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received,including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED Notice
This device complies with Industry Canada’s ICES standard(s). Operation is
subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-005.
EU Declaration of Conformity Hereby
Hereby Dongguan Olight E-Commerce Technology Co.,Ltd declares that the
equipment [Baton Turbo] is in compliance with Directive 2014/30/EU and RoHS
Directive 2011/65/EU & (EU) 2015/863. The full text of the EU declaration of
conformity is available at the following internet
address:https://www.olight.com/download.
WARRANTY
We are proud to offer a lifetime warranty in Australia, China, France, Germany, and the USA. We are also working hard to expand coverage to more countries, where we provide a 2 or 5-year warranty. The warranty covers defects in material and workmanship under normal use, excluding loss, theft, deliberate damage, or cosmetic damage. For complete warranty information, please visit Olight.com or your local Olight official website.
Australia Customer Support
contact@olightstore.com.au
Austria Customer Support
kontakt@olightstore.at
Canada Customer Support
cs@olightstore.ca
China Customer Support
Wechat: olightcs
France Customer Support
cs@olightstore.fr
Germany Customer Support
kontakt@olightstore.de
Italy Customer Support
contatto@olightstore.it
Japan Customer Support
cs@olightstore.jp
Korea Customer Support
olightkorea@olight.com
Spain Customer Support
contacto@olightstore.es
Thailand Customer Support
cs@olightstore.co.th
UK Customer Support
contact@olightstore.uk
USA Customer Support
cs@olightstore.com
For other countries and regions, please contact Global Customer Support
contact@olight.com
Dongguan Olight E-Commerce Technology Co., Ltd.
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town,
Dongguan City,Guangdong, China.
Made in China
CAN ICES-005 (B) / NMB-005 (B)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>