YONGKANG XG-8076 Boxing Board User Manual

YONGKANG XG-8076 Boxing Board

Product Information

Specifications

• Compliance: Part 15 of FCC Rules
• RF Exposure: General requirement met

Product Usage Instructions

• Safety Information
• Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

Operating Conditions
Ensure the device is used in accordance with the following conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation

RF Exposure
The device has been evaluated to meet general RF exposure requirements. Please ensure proper handling and maintain a safe distance during operation.

FAQ

• Q: What should I do if I encounter interference while using the device?
  A: If you experience interference, try relocating the device to a different area. Ensure there are no other electronic devices nearby that could be causing the interference.

• Q: Can I make modifications to the device for better performance?
  A: No, any changes or modifications not approved by the manufacturer could void your authority to operate the equipment. It is recommended to use the device as intended.

boxing board
XG-8076

Please read the instructions before using

Introduction

Boxing is a combat sport in which two opponents of equal size and ability cover their fists with gloves, Fighting each other, it is both an usually used to train the speed and strength of the players during amateur and a professional sport. In boxing, boxing targets are boxing training. Since the opponent’s gap in boxing matches is so short, speed is more important than strength training.hand offensive and defensive reflexes, the product uses electionically controlled light guidance to train people’s ability to respond by sound signals to accurately hit the target point, thus efficiently forging exercise one’s overall coordination and sensitivity.

Technical Data

• Input voltage: DC3.7V
• Working voltage: 3.7V
• Power: 7.4W
• Packing size: 414185cm

Battery: 1200mA
2000mA D

Charging

Use the mobile phone charger (5V/1A-2A) to charge via the attached cable link. Mounting Boxing Pro should be considered close to the wall socket position

Operation

• On/off : Long press to Power on and Power off.
• Bluetooth,press On/Off button to power on or power off bluetooth.
• Speed: Press it to adjust the speed, displaying H01-H09, Flashing faster accordingly. Default speed level H01.
• Mode: Press it to adjust mode, displaying P01-09.Each mode has different speed and difficulty level.

Assembly

1. Peel off the transparent film behind the black adhesive tape and attach it to the back of the Boxing Pro. (Figure 1).

Gloves Operation (If included)

Caution:

1. Don’t use until 30minutes after a meal.
2. It should not be used during pregnancy or menstruation.
3. Electronic products can not be washed, can be wiped with a rag.
4. The machine battery is out of power after timely charging, to prevent battery loss.
5. Stop using immediately if you feel that your body is not used to it.
6. It is recommended to wear boxing gloves when using.
7. It is prohibited to disassemble the product without permission.

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

• If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>