Lowes 90102FL 3 Light Flush Mount Lighting Instruction Manual
- September 20, 2024
- lowes
Table of Contents
Lowes 90102FL 3 Light Flush Mount Lighting
Overview
Assembly Instruction
- Pass the wire through the largest shade (B) and Canopy (D), screw Canpony (D) to Fixture body (A).
- Unscrew Finial (C) to have Mounting plate (G) loosened from Canopy (D).
- Attach the Mounting plate (G) to outlet box with Screws (E).
- Connect the wires according to the picture above. (Please refer to the wiring instruction for details )
- Pass Canopy (D) through the Screw (F) and fix it with Finial (C).
- Hang the remaining lamp shades in turn.
Wiring Instruction
-
Insert the green grounding screw into the hole with two raised dimples on the mounting bar. Wrap the ground wire from the fixture (if supplied) around the green grounding screw, then connect it to the ground wire from the outlet box (if not fixed on the outlet box) using a wire connector(not supplied). If the ground wire from the fixture is not supplied, wrap the ground wire (if not fixed on the outlet box) from the outlet box around the green grounding screw and tighten it.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES. -
Take note of the color of the wire(s) on your fixture. Identify which group your fixture wire(s) falls into and connect the wires according to the directions below:
[GROUP A]:
Connect to Black House Wire
| [GROUP B]:
Connect to White House Wire
---|---
BLACK| WHITE
PARALLEL WIRE (round & smooth)| PARALLEL WIRE (square & ridged)
WHITE OR GREY WITH TRACER| WHITE OR GREY WITHOUT TRACER
BROWN, GOLD OR BLACK WITHOUT TRACER| BROWN, GOLD OR BLACK WITH TRACER
- Take your fixture wire(s) from [Group A] and place evenly against the black wire from the outlet box. Do NOT twist wires together before using wire connectors.
- Fit a wire connector over the wires and screw the connector clockwise until you feel firmness.
- Try gently to pull the connector off the wires. If you can pull the connector off, carefully re-do steps 3 and 4 as above, and check again for a firm connection.
- Connect the fixture wire from [Group B] to the white wire from the outlet box in the same manner. Make sure no bare wires can be seen outside wire connectors.
Product Specifications
- Input voltage 120V
- Rated power 60W MAX × 3
- Lamp socket E26
Product Packaging
- Fixture body × 1
- Shade × 3
- Mounting plate × 1 & Canopy × 1
- Screw × 2 & Wire nut × 3
- Lamp instruction × 1
Cleaning
- To clean, wipe the fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool, or abrasive paper.
Safety Information
- Always switch off the electricity supply and allow it to cool for 10 minutes before changing the light bulbs.
CONTACT
- E-mail:service@24h-reply.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>