JBL PartyLight Stick Bluetooth Party Light Stick User Guide
- September 20, 2024
- JBL
Table of Contents
QUICK START GUIDE
PART YLIGHTS TICK
WHAT’S IN THE BOX
ASSEMBLY
POWER ON
WORK WITH PARTYBOX
LIGHTSHOW
APP
CHARGING
TECH SPEC
LED: | RGB x 183 pcs |
---|---|
Power consumption: | 10 W MAX |
Play time: | Up to 8 hours |
Battery type: | Lithium-ion battery pack 9.0 Wh (equivalent to 3.6 V 2500 mAh) |
Battery charge time: | < 3 hours |
USB charge in: | 5 V / 2 A |
USB cable length: | 900 mm / 3 ft |
Bluetooth version: | 5.3 |
Bluetooth modulation: | GFSK |
Bluetooth transmitter frequency range: | 2400 MHz – 2483.5 MHz |
Bluetooth transmitter power: | < 12 dBm (EIRP) |
Packaging dimensions (W x H x D): | 217 mm x 1081 mm x 217 mm / 8.54″ x 42.56″ |
x 8.54″
Net weight:| 1.15 kg / 2.54 lbs
Packaging dimensions| 1060 mm x 228 mm x 117 mm / 41.73″ x 8.89″ x 4.61″
Gross weight:| 2.44 kg / 5.38 lbs
**** To protect battery lifespan, fully charge at least once every 3 months.
Battery life will vary due to usage patterns and environmental conditions.
Do not expose the JBL PARTYLIGHT STICK to liquids without removing cable
connection. Do not expose JBL PARTYLIGHT STICK to water while charging. It may
result in permanent damage to the device or power source.
Chemicals, salt or “foreign particles” in your pool or the ocean can damage
the waterproof seals or harm the connector surface over time if not rinsed off
after use. After a liquid spill or rinse, do not charge your device until it’s
completely dry and clean. Charging when wet might damage your device. When
using an external adapter, the output voltage/current of the external adapter
should not exceed 5V/2A.
This equipment complies with FCC/ISED radiation exposure limits set forth for
an uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
The portable device is designed to meet the requirements for exposure to radio
waves established by the Federal Communications Commission (USA)/ISED. These
requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The
highest SAR value reported under this standard during product certification
for use when properly worn on the body.
The light source contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar qualified person. The maximum
operation temperature is 40
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>