Serenify Saunas Serenify Cube Luxury Scandinavian Sauna Instruction Manual

Serenify Cube Luxury Scandinavian Sauna

“`html

Specifications

Product Usage Instructions

Safety Warnings

• All circuits should be installed by licensed electricians and
  conform to local and national codes.

• Power supply must be cut off before installation, maintenance,
  and repair.

• This appliance is not intended for use by children or infirm
  persons unless supervised.

• Disconnect the general power supply when not in use for a long
  time.

• Do not perform wiring installation and debugging with the power
  on.

• Ensure correct and well-connected wirings to prevent damage to
  the device.

• Do not attempt to repair the machine yourself; contact the
  local agent or manufacturer for malfunctions.

Installations

Attention: Speakers are suggested to be
installed under a temperature of up to 60°C.

Note: Bluetooth kit and controller should be
installed outside the steam or sauna room.

Test the whole Music System before securing it to the
wall.

Step 1: Install the back frame

1. Open a hole: size about 666650mm (depth 50mm), according to
   the actual size of the back frame.

2. Push the back frame and take it off. The depth should not be
   less than 50mm, and there should be no obstacle in front of the
   installation.

3. Use the two bracket screws to fix the back frame on the
   wall.

Step 2: Connect audio lines to the speakers

For Moment Music System, please refer to the Moment manual. Skip
step 2,6,7.

FAQ

Q: What do I do if I receive the Music System with missing

components?

A: When you receive the Music System, please check what you
received according to the configuration list provided in the
manual. If any components are missing, contact us immediately for
assistance.

Q: Can children use this Music System unsupervised?

A: This appliance is not intended for use by children or infirm
persons unless they have been adequately supervised by a
responsible person to ensure that they can use the appliance
safely. Children should always be supervised to prevent misuse of
the device.

Q: How should I handle a malfunctioning machine?

A: Please do not attempt to repair the machine yourself as it
may affect your rights and interests. If there is any malfunction
of the machine, please contact the local agent or the manufacturer
for professional assistance.

“`

TABLE OF CONTENT
02 Configuraon List 02 Introducon 03 Safety Warnings 04 Parameters 05 Installaons 09 Funcons And Operaons (Only for independent music system) 10 Troubleshoong

Configuraon List

When you receive the Music System, please check what you received according to below tables, please contact us immediately if any missing.

Photo

Independent Music System Configuraon List

Item name

Quanty

Bluetooth kit ( amplifier)

1pc

Waterproof speaker

2pcs

5 meters audio line

2pcs

Remote controller

1pc

Photo

Moment Music System Configuraon List

Item name

Quanty

Waterproof speaker

2pcs

Power supply for CB02

1pc

Antenna

1pc

5 meters audio line

2pcs

Introducon
Thank you for choosing this Music System. Our speakers are waterproof and specialized for steam room use. For independent Music System, it can support Bluetooth, remote control, USB, TF cards and FM. If working with the Moment Steam Generator, only Bluetooth is supported.
page 02

page 03

Safety Warnings
All circuits should be installed by licensed electricians and conform to local and naonal codes. Improper electrical connecon can cause fire or electric shock.
Power supply must be cut off before installaon, maintenance and repair. Press the on/ off buon on the controller can NOT cut power from the supply.
This appliance is not intended for use by children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely. Children should be supervised to ensure that they will not play with the appliance.
When you go out, or may not use it in long me, please DISCONNECT the general power supply.
This machine is used for AC110-240V. Please do NOT do the wiring installaon and debugging when the power is on.
Please refer to chapter 5 for installaons, if the wirings are wrong, it will damage the device. Make sure that all wirings are correct and well connected.
Please do not repair the machine by yourself, otherwise it will affect your rights and interests. If there is any malfuncon of the machine, please contact the local agent or the manufacturer.

Parameters
Specificaons
Waterproof Type Cone Size Outside Diameter Mounng Hole Diameter Mounng Depth Impedance Frequency Response Power (Max) Grill Material Rubber Surround Magnet Material Magnet Protecon Weight (single speaker) SPL (1 Wa / 1 Meter) Power supply Storage temperature Work temperature

TOLO SAUNA
IP66 6” Waterproof Marine Speakers 6” 175.5 mm 145mm 69mm 40hm 120Hz-20kHz 120W Non-corrosive Aluminum Yes Ferrite, 4oz Plasc water guard 1kg 80dB AC110-240V -20~80¥ -10~70¥
page 04

Dimensions
Installaons
Aenon: Speakers are suggested to be installed under 60 Ccircumstance Aenon: Bluetooth kit and controller should be installed outside the steam or sauna room. page 05

TOLO SAUNA

Test the whole Music System before securing to wall.

Step 1: Install the back frame
Open a hole: size about 666650mm (depth 50mm), please open the hole according to the actual size of back frame .

Push the back frame and take it off.

The depth is not less than 50mm,
and there should be no obstacle in front of the installaon, so as not to affect the receiving signal of Blue-
tooth.

Use the two bracket screws to fix the back frame on the wall.

Step 2: Connect audio lines to the speakers

For Moment Music System, please refer to Moment manual, please skip step 2,6,7. page 06

Step 3: Connect audio lines to the Bluetooth kit (amplifier) Connect the other end of the audio line to the connector R- R+ L+ L- on wiring board.

AC110-240V
Please pay aenon to the “+” and “-” . If the audio line is connected to “+” of the speaker, it should also be connected to “R+” or “L+” of the Bluetooth kit (amplifier). “-” is the same. Aer being done, fasten the screws.

Step 4: Connect electric wires:
For EU type 220V single phase: Connect the Null wire to where marked ” N” , connect the Live wire to where marked ” L” ;
For USA type 110V single phase: Connect the Null wire to where marked “N” , connect the Live wire to where marked “L” ;
For USA type two phases: Connect two Live wires “L1″” L2″ to where marked “L” and “N” .

Step 5: Install the Bluetooth kit (amplifier) Fix the Bluetooth kit (amplifier) into the back frame.

TOLO SAUNA

Step 6: Install the speakers
Open a hole: diameter 145mm, depth 69mm
Then gently push the speakers’ covers unl the covers fall. Use screws to fix the speakers on the ceiling.

Step 7: Connect Bluetooth
Turn on the Bluetooth device(amplifier), choose the “Bluetooth mode” .
Turn on the cellphone’ s Bluetooth, find the device of “Steamtec” , then connect.

Aer Then, push the covers into the speakers. Then done.

page 07

page 08

Funcons And Operaons
(Only for independent music system)

For Moment music system, please refer to Moment manual.

1

2

5

3

4

6

1#: Mode key: press this buon to exchange various modes (Bluetooth, TF card, USB, radio, external sound source).
2#: EQ: play music. Press this buon to switch sound (pop, smooth, jazz, rock, stress).
3#: Adjust 4#: Repeat : when playing music, press this buon
for sing repeat, cycle, holder playback, etc.
5#: Mute buonpress the buon to close the host sound, and then press the key to open the host sound again.
6#: TF card/USB: switch TF card and U disk
7#: TF card socket

16 15 14 13 12 11
8#: USB 9#: Audio input interface 2.0 10#: Reset key 11#: ON/OFF/MODE. Short click mode (Blue-
tooth, TF card, USB, radio, external sound source). Changeover, long press as switch machine. 12#: Volume + 13#: Volume 14#: Next song 15#: Pause/Play Key 16#: Previous song

Only need to connect those marked in red. page 09

TOLO SAUNA
Troubleshoong
1. No sound: Check if the wirings are correct. 2. No sound when connected to Bluetooth player:
Check if the phone has been selected for Bluetooth player. Check if the mobile phone, the amplifier and remote control are in mute mode . Verify if the music files on the phone are in a non-destrucve format that can be played. Make sure the phone is not too far away from the amplifier, as long distances can weaken the signal. 3. The Buons are unresponsive: Check if the panel is too dirty , and if there is water on the panel. If yes, please clean up firstly, then operate. 4. Unable to connect to Bluetooth: Check if other devices are connected and make sure your mobile phone is enabled to search for Bluetooth devices. 5. The remote control is not sensive: Check if the remote control is out of baery. 6. System lacks in bass: Check the connecons from the source unit/ Bluetooth kit(amplifier) to the speaker. Ensure the posive wire from the source is connected to the posive of the speaker. Ensure the speakers are mounted firmly to the mounng surface. 7. System lacks in high frequencies: Check polarity; Check the bass/treble control sengs on the source unit 8. Distorted sound: Check all wirings; Check that it is not the surrounding panels of the cra raling. Check connecons from the source to the speaker.
page 10

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>