Darkglass Ultra Series Vintage Ultra User Manual

: September 12, 2024
: DARKGLASS

Table of Contents

Ultra Series Vintage Ultra
Specs
Technical Specifications
Warning
Warranty
Disclaimer
EMC / EMI
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Ultra Series Vintage Ultra

Vintage Ultra Manual
Ultra Series

Darkglass Ultra Series Vintage Ultra - cover

Specs

Controls
Master: Whereas the Level Knob controls the output of the overdrive section the Master volume adjusts the overall volume of the unit. Ideal for ne tuning the output on clean mode. It also serves as a DI level control.
Blend: Mixes the clean input signal with the overdriven signal. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for ne control of the blend ratio. Level: Sets the volume of the overdriven signal. Drive: Sets the amount of saturation in the overdriven signal.
Attack Switch: Sets the amount of treble content to saturate: The “Boost” setting emphasizes the treble content extra clarity and presence. The “Flat” position leaves this register untouched while the “Cut” position will reduce the amount of high frequencies being saturated.
Grunt Switch: Sets the amount of low frequency content to saturate by selecting between three dierent bass boost levels before the clipping stage.
Bass: +-12dB @ 100Hz
Lo Mids: +-12dB switchable 250Hz, 500Hz and 1kHz
Hi Mids: +-12dB switchable 750Hz, 1.5KHz and 3kHz
Treble: +-12dB @ 5kHz

Technical Specifications

Input Impedance: 1MΩ
Output Impedance: 1kΩ
Current Consumption: ~120mA
Voltage: 9V DC (Center Negative)

Dimensions
Width: 125 mm / 4,92″
Length: 96 mm/ 3,77″
Height: 57 mm / 2,24″
Weight: 430 g / 0,94 lb

Warning

The Vintage Ultra has a current draw of 120mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.

Warranty

To activate the warranty, we encourage you to register your product on: http://mypedal.darkglass.com and enter the serial number on the back of your pedal. Please contact us via email support@darkglass.com before shipping a product to us.

Disclaimer

In the interest of continuous improvement, specications are subject to change without notice. If you have any questions, please don’t hesitate to contact us at www.darkglass.com The manufacturer claims that the above product fulls the requirements as set by EN55013, EN55020, EN60555−2, EN60555−3, RoHS, WEEE. 1176®, and SSL® are registered trademarks of their respective companies. Names of factory modes are intended for descriptive purposes only and should not be construed as an endorsement or aliation with the companies or products named.

EMC / EMI

This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

PRIVACY POLICY CAREERS

DARKGLASS is a registered trademark in the U.S., number 4,616,801, owned by Darkglass Electronics Oy.
Designed by Revolve Studio