Darkglass Enhancer Series Harmonic Booster User Guide
- September 12, 2024
- DARKGLASS
Table of Contents
Darkglass Enhancer Series Harmonic Booster
Product Information
Specifications
- Controls:
- Boost: Flat -20dB to +20dB cut or boost
- Character: Allows blending in the perfect amount of tone-shaping circuitry
- Mid Gain: +-20dB @ the frequency selected by Mid Frequency
- Mid Frequency: Mid frequency from 250Hz to 2.5kHz
- Bass: +-20dB @ 80 Hz
- Treble: +-20dB @ 5 kHz
- Technical Specifications:
- Input Impedance: 470k
- Output Impedance: 1k
- Current Consumption: 30mA
- Voltage: 9V DC (Center Negative)
- Dimensions:
- Width: 75 mm / 2.95″
- Length: 111 mm / 4.37″
- Height: 43 mm / 1.69″
- Weight: 250 g / 0.55 lb
Warning
The Harmonic Booster has a current draw of 30mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.
Warranty
To activate the warranty, register your product on: mypedal.darkglass.com and enter the serial number on the back of your pedal. Contact support@darkglass.com before shipping a product for any issues.
Disclaimer
In the interest of continuous improvement, specifications are subject to
change without notice.
If you have any questions, please don’t hesitate to contact us
atwww.darkglass.com The manufacturer claims that the above product fulfils the
requirements as set by EN55013,EN55020, EN60555-2, EN60555-3, RoHS, WEEE.
1176®, and SSL® are registered trademarks of their respective companies. Names
of factory modes are intended for descriptive purposes only and should not be
construed as an endorsement or affiliation with the companies or products
named.
For any queries, contact us at www.darkglass.com. The
product meets requirements as set by various standards.
EMC / EMI
This equipment has been tested and found to comply with the limits for a Class
B Digital device, pursuant to part 15 ofthe FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
residential installations.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. There is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Product Usage Instructions
Setting Up Your Harmonic Booster
- Ensure you have a regulated 9V DC adapter with a center-negative plug.
- Connect the adapter to the Harmonic Booster’s power input.
- Connect your instrument to the input jack and your amplifier to the output jack of the Harmonic Booster.
- Adjust the Boost, Character, Mid Gain, Mid Frequency, Bass, and Treble controls to achieve your desired tone.
- Your Harmonic Booster is now ready to use!
Maintaining Your Harmonic Booster
To ensure optimal performance and longevity of your Harmonic Booster:
- Keep the unit clean and free from dust or debris.
- Avoid exposing it to extreme temperatures or moisture.
- Regularly check and tighten all connections.
- If issues arise, refer to the warranty information provided.
Troubleshooting
If you encounter any issues with your Harmonic Booster, such as abnormal noise or malfunction:
- Check the power supply and ensure it meets the specified requirements.
- Verify all connections are secure and cables are in good condition.
- Contact customer support for further assistance if problems persist.
FAQ
-
Q: Can I use an unregulated power supply with the Harmonic Booster?
A: It is recommended to only use a regulated 9V DC adapter with a center- negative plug to avoid potential damage to the unit. -
Q: How can I activate the warranty for my Harmonic Booster?
A: Register your product on mypedal.darkglass.com and enter the serial number located on the back of your pedal. Contact support@darkglass.com before shipping if needed.
DARK GLASS is a registered trademark in the U.S., number 4,616,801, owned by
Darkglass Electronics Oy.
Designed by Revolve Studio
MORE INFORMATION
References
- Darkglass Electronics - Login
- Darkglass Electronics - Login
- Darkglass Electronics
- Darkglass Electronics
- Careers – Darkglass Electronics
- Creations – Darkglass Electronics
- Dealers – Darkglass Electronics
- Privacy Policy – Darkglass Electronics
- Suite – Darkglass Electronics
- Darkglass Electronics (@darkglasselectronics) • Instagram photos and videos
- Revolve Studio • Custom Web Design Services in Helsinki
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>