CHELEGANCE KC4 Shortwave 4 Band Vertical Antenna Installation Guide
- September 9, 2024
- CHELEGANCE
Table of Contents
CHELEGANCE KC4 Shortwave 4 Band Vertical Antenna
DESCRIPTION & SPECIFICATION
The KC4 is a 4-band vertical antenna made of aluminum alloy. It covers 40/20/15/10 meters. The user trims the antenna to the part of the band as needed.
Automatic band switching: The KC4 has a single coax cable feed however each bandis individually tuned with a low VSWR across the band. Through fine- tuning, the best (rock-bottom) SWR can be achieved on the user’s choice of frequency within the band. The band selection is 100% automatic through the single feed, just switch bands on the radio.
Top loading : The KC4 uses top loading to achieve higher efficiency froma short self supporting vertical radiator.
Outdoor weather ability: The KC4 is rated for high wind environments. After a normal installation, it can resist a category one hurricane with no guying required.
| Dimensions | 14x14x120cm |
|---|---|
| Weight | 7kg |
| Axial length | around 7.8m |
| Radial length | around 2.7m |
| Maximum power handling | 1000 watt PEP (CW500W, RTTY300W) |
| Antenna impedance | 50 Ω |
| VSWR | ＜1.5:1 |
| Use frequency band | 7/14/21/28MHz (40m/20m/15m/10m) |
| Bandwidth | 40m: 150 kHz |
20m: 450 kHz
15m: 800 kHz
10m: 1000 kHz
Rated wind speed| 35 m/s
Interface type| SL16-K
PART LIST
- 1 x Main support (450464mm | 1.50.150.01ft)
- 6 x Main counterpoise (1x1300mm 5x1200mm | 3.9ft)
- 1 x Antenna body NO:1
- 1 x Antenna body NO:2
- 1 x Antenna body NO:3
- 1 x Antenna body NO:4
- 1 x Antenna body NO:5
- 1 x Antenna body NO:6
- 1 x Antenna body NO:7
- 1 x Matching box
- 2 x U clamp
- 1 x 7# sleeve
- 1 x 10# wrench
- 1 x 13# wrench
- 1 x M4 Allen wrench
INSTALLATION GUIDE
A. Fix the main support with a U-shaped holding clamp and a fixing plate.
B. Insert the NO.1 main rod into the main support. And put the two ends of the place for matching box on the same side,and fix it with screws. (Secure the components with screws and spanners.)
C. Install the matching box. (Red arrow: note that it is screwed to the rod)
D. Insert the NO.2 rod inside the NO.1 rod and secure it by tightening the screws on the outside. The remaining rods you can install by following the sequential prompts
E. Put the antenna on.
F. Finish
*Note: The actual wind resistance level depends on the method and the
firmness of the
installation (mainly depends on the fixed object). And please pay attention to
lightning protection
Customer Support
Reach out to us if you have any problems: support@chelegance.com
HAVE FUN WITH KC4, 731
support@chelegance.com
www.chelegance.com
KC4 SHORTWAVE 4-BAND VERTICAL ANTENNA, 40M/20M/15M/10M
https://chelegance.com/products/cntou-kc4-shortwave-4-band-vertical-antenna/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>