ACOUSTIC SBI001 Wireless Bling Mouse User Manual
- June 17, 2024
- ACOUSTIC
Table of Contents
SBI001 Wireless Bling Mouse
User Manual
FCC ID:2AKZ8-SBI001 for Mouse
FCC ID:2AKZ8-SBI001D for Dongle
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Operation Steps
- Open the battery cover of the mouse, take out the USB Dongle, and plug it into the computer.
- Install 2 pcs No.7 batteries into the battery slots, and make sure the positive and negative terminals correctly.
- When the red light of the mouse is blinking on, it is proved that the mouse is paired with the USB Dongle, and the mouse can work normally.
Note: Plug the USB Dongle first and then install the battery, if there is no pairing, after inserting the USB Dongle, click the mouse left&right button and then install the battery on the power can be used normally.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>