eufy C210 Security SoloCam Wireless Outdoor Camera User Guide

: June 13, 2024
: Eufy

Table of Contents

AT A GLANCE
CHARGING YOUR SOLOCAM
SETTING UP THE SYSTEM
MOUNTING YOUR SOLOCAM
SAFETY
NOTICE
CUSTOMER SERVICE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

eufy C210 Security SoloCam Wireless Outdoor Camera

eufy C210 Security SoloCam Wireless Outdoor Camera

AT A GLANCE

At A Glance

Camera Lens
Motion Sensor
Microphone
Photosensitive Sensor
LED Indicator
Speaker
SYNC Button
USB-C Charging Port (with Sealing Cap)
Mounting Hole

CHARGING YOUR SOLOCAM

Charging Your Solocam

Charging	Solid Blue
Fully Charged	Off
Charging Time	4.5 Hours

SETTING UP THE SYSTEM

Download and install the eufy Security app, then sign in or create an account.
|
---|---
Follow the in-app instructions to add the camera to the device list.

MOUNTING YOUR SOLOCAM

Select a Location

This camera can be mounted on a wall. Select a location where you can get the desired view. We recommend mounting the camera 7-10 ft (2-3 m) above the ground to achieve up to 26 ft of motion detection range.

Mounting Your Solocam

Mount the Camera

This camera can be mounted both outdoors and indoors.

Loosen the cover of the mounting bracket by turning it counterclockwise and disassemble the mounting bracket.
For walls that are made out of hard materials, such as stucco, brick, or concrete, drill holes with a 15/64 inch (5.95mm) drill bit, then insert the anchors into the holes.
For soft surfaces such as wood, skip this step.
Firmly screw the base of the mount onto the wall. Reassemble the mounting bracket.
Screw the camera onto the mounting bracket. Position the camera to achieve the desired view, checking it using the live stream in the eufy Security app.

The C210 Solo Cam can also be installed on the ceiling. Follow the steps above to install it. For troubleshooting, check Help on the eufy Security app. Refer to the app page for LED indicator status.

SAFETY

The suitable temperature for devices and accessories is -20°C to 50°C (Charging temperature is 0°C to 40°C).
Unless specifically indicated that it is safe to do so in the user guide or instruction manual, do not use this device in an environment that exceeds the recommended low or high temperature.
Unless specifically indicated that it is safe to do so in the user guide or instruction manual, avoid exposing your device to direct sunshine or excessively wet environments.
It is recommended to supply the device in an environment with a temperature that ranges from 5°C to 25°C.
When supplying power, place the device in an environment that has a normal room temperature and good ventilation.

CAUTION!

THERE IS A RISK OF EXPLOSION IF AN INCORRECT BATTERY TYPE IS USED.
DISPOSE OF USED BATTERIES ACCORDING TO THEIR INSTRUCTIONS.

Warning :

Replacing a battery with an incorrect type may bypass safeguards and create danger;
Disposal of a battery in a fire or other source of significant heat, or by crushing, or cutting, may result in an explosion as well as leakage of flammable liquids and gases;
Leaving a battery in an extremely hot environment may result in an explosion as well as leakage of flammable liquids and gases;
A battery subjected to extremely low air pressure may result in an explosion as well as leakage of flammable liquids and gases.

NOTICE

This product complies with the radio interference requirements of the European Community.
Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the Web site: https://uk.eufylife.com/.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance between the device and human body.
Wi-Fi Operating Frequency Range: 2412~2472MHz; Wi-Fi Max Output Power: 19.10 dBm The following importer is the responsible party (contact for EU matters only)
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich, Germany.
This product complies with the radio interference requirements of the United Kingdom.
This product complies with the radio interference requirements of the United Kingdom.
Hereby, Anker Innovations Limited declares that this product is in compliance with Radio Equipment Regulations 2017(SI2017/1206). The full text of the UK declaration of conformity is available at the following internet address: https://uk.eufylife.com.
Anker Technology (UK) Limited I GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom.
Symbol Your product is designed and manufactured with high-quality materials and components, which can be recycled and reused.
This symbol means the product must not be discarded as household waste and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling help protect natural resources, human health, and the environment. For more information on the disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

CUSTOMER SERVICE

Service client
12-month limited warranty
(US) +1 800-988-7973
(UK) +44 (0) 1604 936200
(DE) +49 (0) 69 9579 7960
( 中国 ) +86 400 0550 036
( 日本 ) 03 4455 7823
(AU) +61 3 8331 4800
(Egypt) +20 8000000826
(UAE) +971 8000320817
(Kuwait) +965 22069086
(Saudi Arabia) +966 8008500030

support@eufy.com
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
@EufyOfficial @EufyOfficial @EufyOfficial