JBL Party Box Club 120 User Guide

: September 5, 2024
: JBL

Table of Contents

JBL Party Box Club 120
Product Usage Instructions
FAQ
What In The Box
BLUETOOTH PAIRING
PLAY AND LIGHTSHOW
APP
CONNECTIONS
CHARGING
SPLASH PROOF
TECH SPEC
More Information
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JBL Party Box Club 120

Product Usage Instructions

Bluetooth Pairing

To pair via Bluetooth:

Go to the Bluetooth settings on your device.
Select “JBL PartyBox Club 120” to connect.

Lightshow

To control the lightshow:

Download and install the JBL PARTYBOX app.
Open the app and follow the instructions to apply lightshow presets.

Microphone and Guitar Connection

For microphone and guitar connection:

Connect the microphone or guitar to the designated ports.
Adjust the input sensitivity as needed.

Multi-Speaker Connection

To connect multiple speakers:

Follow the instructions in the user manual for multi-speaker setup.

Charging

To charge the device:

Connect the AC power cable (type varies by region) to the speaker.
Monitor the charging status using the LED indicators.

FAQ

Q: How do I reset the device?
- A: To reset the device, press and hold the power button for 10 seconds until the device powers off and then back on.
Q: Can I use the PartyBox Club while it’s charging?
- A: Yes, you can use the PartyBox Club while it’s charging, but note that it may affect the charging time.

What In The Box

Power cord quantity and plug type vary by regions.

BLUETOOTH PAIRING

PLAY AND LIGHTSHOW

PLAY

LIGHTSHOW

Apply lightshow presets and more with the JBL PARTYBOX app.

APP

Download and install the JBL PARTYBOX app to get more from the product.

CONNECTIONS

MICROPHONE

GUITAR

MULTI-SPEAKER CONNECTION

CHARGING

SPLASH PROOF

SPLASH PROOF IPX4

TECH SPEC

Transducers: 2 x 5.25 inch (133 mm) woofers, 2 x 2.25 inch (57 mm) tweeters
Output power: 160 W RMS (IEC60268)
Power input: 100 – 240 V ~ 50/60 Hz
Frequency response: 40 Hz – 20 kHz (-6 dB)
Signal-to-noise ratio: > 80 dB
Battery type: JBL BATTERY200, Li-ion 34 WH (equivalent to 7.2 V / 4722 mAh)
Battery charge time: 3.5 hours (speaker off mode)
Music play time: up to 12 hours (varies by volume level and audio content)
Cable type: AC power cable (type varies by regions)
Cable length: 2.0 m / 6.6 ft
USB charge out: 5 V / 2.1 A (Max) (speaker off mode)
USB format: FAT16, FAT32
Bluetooth® version: 5.4
Bluetooth® profile: A2DP V1.4, AVRCP V1.6
Bluetooth® transmitter frequency range: 2.4 GHz – 2.4835 GHz
Bluetooth® transmitter power: ≤ 18 dBm (EIRP)
Bluetooth® transmitter modulation: GFSK, π/4 DQPSK, 8DPSK
Supported formats: .MP3, .WAV, .WMA, .FLAC
Input sensitivity:
- Aux-In: 370 mV RMS (3.5 mm connector)
- Mic-In: 20 mV RMS
- Guitar-In: 100 mV RMS
- Bluetooth/USB input: -9 dBFS
Product dimensions (W x H x D): 288.4 mm x 570 mm x 297 mm / 11.35″ x 22.44″ x 11.69″
Net weight: 11.05 kg / 24.35 lbs
Packaging dimensions (W x H x D): 340 mm x 617 mm x 369 mm / 13.4″ x 24.3″ x 14.5″
Gross weight: 14.1 kg / 31 lbs

Note: The product is in compliance with the European Union energy legislation.

More Information

Bluetooth connection mode
- The product is intended to be used for streaming music via Bluetooth connection. A consumer can stream Bluetooth audio to the speaker. When the product is connected through Bluetooth, the Bluetooth connection must remain active at all times to ensure proper operation.
- The product will enter sleep mode (networked standby) after 20 minutes without operation. The power consumption in sleep mode is less than 2.0 Watts, after which it can be re-activated via Bluetooth connection.
Bluetooth disconnection mode
- The product will enter standby mode after 20 minutes without operation. The power consumption in standby mode is less than 0.5 Watts.

The maximum operation temperature is 45 °C
No naked flame sources, such as lighted candles, should be placed on the apparatus.

This equipment is a Class II or double insulated electrical appliance.

www.jbl.com

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.