ACT AC8302 Dual Monitor Arm Installation Guide

Table of Contents

For 2 Monitors

Quick Install

Specifications

Installation Instructions

Step 1
Attach part E to the desk using the clamp mechanism. Ensure the clamp is securely fastened to the desk.
Step 2a
Attach part C to part E using screws and washers (M, K, L). Tighten securely.
Step 2b
Alternatively, attach part C to the desk using the grommet base (H). Ensure the grommet is securely fastened to the desk.
Step 3
Attach part B to part C. Ensure it is securely fastened and can rotate freely.
Step 4a
Attach the monitor to part A using screws (MA, MC) and washers (ME). Ensure the monitor is securely fastened.
Step 4b
Alternatively, use screws (MB, MD) and washers (MF) to attach the monitor to part A. Ensure the monitor is securely fastened.
Step 5
Attach the monitors to part B. Ensure both monitors are securely fastened and can rotate freely.
Step 6
Use cable management clips to organize and secure the cables along the monitor arms.
Step 7
Adjust the monitor arms using the provided tools (M, N) to achieve the desired angle and height.
Step 8
Ensure the monitor arms are not overextended to prevent damage or instability.

Adjust the monitors to the desired viewing angle. The monitors can rotate 360 degrees and tilt 45 degrees.

Warnings and Precautions

Read the entire installation instructions before you start the installation and assembly.
If you have any doubts about the installation, please consult a professional.
Ensure the desk and mounting surface can support the combined weight of the monitors and the mount.
Do not exceed the maximum weight capacity of the mount.
Keep all tools and small parts away from children.
Do not attempt to modify or alter the mount in any way.
Regularly check all screws and bolts to ensure they are tight and secure.

FAQ

What is the maximum weight capacity of the mount?
The maximum weight capacity is specified in the product manual. Ensure not to exceed this limit.
Can I use this mount for a single monitor?
Yes, the mount can be used for a single monitor. Follow the same installation instructions, but only attach one monitor.
What tools are required for installation?
The necessary tools are provided with the mount. Additional tools like a screwdriver may be needed.
How do I adjust the monitor height and angle?
Use the provided tools (M, N) to adjust the height and angle of the monitors.
Can the mount be installed on a glass desk?
It is not recommended to install the mount on a glass desk as it may not support the weight and could cause damage.

For more information, visit www.act-connectivity.com

ACT, Korenmarkt 17, 7571 BM Barneveld, The Netherlands

Installation

You can find safety information at www.act- connectivity.com/safety
For service, manuals, firmware or updates visit www.act- connectivity.com

Read the entire instruction before you start the installation and assembly.
CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.
Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious personal injury.
Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components
Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from children
This product is intended for indoor use only. Using this product outdoors could lead to product failure and injury.

IMPORTANT
Ensure that you have received all parts according to the component checklist prior to the installation.