KODLIN KUS11300 Front 2 Wire LED Install Kit Installation Guide
- September 3, 2024
- KODLin
Table of Contents
KODLIN KUS11300 Front 2 Wire LED Install Kit
Product Specifications
- Model: KUS11300 and KUS11400
- Compatibility: Custom 2-wire LED lights
- Not Compatible with: K68500, K68501, K68510, K68511
Installation Instructions
This kit comes with KUS11300 and KUS11400 prewired and ready to install. For
use with custom 2-wire LED lights. Not for use with K68500, K68501, K68510, or
K68511.
TIP: Wiring diagram on the last page!
Note: Follow the Harley-Davidson service manual for your year/model
motorcycle to complete these steps.
Install
-
Disconnect the negative terminal from the battery.
-
Remove seat.
-
Remove the tank.
-
Expose handlebar wire connectors under the cover located on the left side of the neck frame.
-
Disconnect the connectors for the turn signals.
-
Push turn/run wires up through bars to provide enough room to make your slices.
-
Cut the original three (blue, purple, black) turn/run wires 3-4 inches away from the turn signal housing.
-
Remove the OEM turn signals and install new LEDs according to their instructions.
-
When installing the LED, connect the yellow LED wire to the purple harness wire and the black LED wire to the black harness wire. The blue harness wire will not be used.
-
Pull wires back into the bars to hide the splices. Make sure not to pinch any wires between the bar and housing or between the switch housing and brake or clutch control clamp.
NOTE : Channel 1 has the yellow wire in the input connector, and channel 2 has the blue. Channel 1 and channel 2 input and output connectors are grouped to help keep the channels isolated on one side from the other. Either channel can be used for left or right. Just keep the channel 1 input and outputs together on the same side. See picture #1 -
Plug the input connector into the main harness and plug the output connector into the turn signal wires. See picture 2 Picture 2
-
Make sure dip switches are all set to “ON”. This setting seems to work well with HD Can-Bus.
-
Connect your battery and test to make sure there are no hyperflashing or DTC error codes. Make sure to clear your DTC codes when finished.
-
Once tested, tuck KUS11550 into the frame opening the first frame out of the way of the rest of the harness, then install harness wires back into the frame and close the cover. Check for any tightness or binding of the harness.
-
Reinstall the tank, and seat and reconnect the power.
-
Verify all your bolts are torqued properly and go ride. For the latest install guides, videos, FAQ’s. and Tech-Tip’s scan QR code!
Revision Date: 2/6/2024
www.kodlinusa.com
Front Install Kit with 2-1 Intensifier KUS11300 and KUS11400 Load Balancer
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>