Furniture 36.0040 Vanity Units Instructions
- September 3, 2024
- FURNITURE
Table of Contents
**Furniture 36.0040 Vanity Units Instructions
**
PLEASE READ BELOW NOTES BEFORE INSTALLING YOUR VANITY UNITS.
- Use protective gloves and eye protection at all times
- Never install products or components which looks damaged
- Please use qualified plumbers to install the vanity unit
- 2 people are required to install the units
- Check the parts are fully supplied
- Hinges for doors and sliders for drawers may need to be checked and adjusted to achieve proper position after installation
- Please avoid direct sunlight as this will affect the painted surface colour change
- If fixing to a stud or panelled wall, proper framework is required to support a wall hung unit
NECESSARY TOOLS (not supplied)
Installation for Floor standing Vanity Units
Mark the two holes levelly on the wall.
Drill the holes using proper size drill bit.
Insert expansion wall plug or appropriate alternative wall fixing
Screw in the tapping screws.
Add cover caps on the screws.
When fitting the basin to the unit, adequate silicone is required between basin and unit to prevent potential water ingress.
Installation for Wall Hung Vanity Units
When fitting the basin to the unit, adequate silicone is required between basin and unit to prevent potential water ingress.
Components Adjustment
- Drawer slider adjustment
If you need some fine adjustment, turn the screw clockwise to to get the drawer “up”, turn the screw anti-clockwise to get the drawer “down”
- **Soft closing hinge adjustment
**
- Wall hanging bracket adjustment
Aftercare and Maintenance
- Make sure your bathroom is well ventilated
- Do not use abrasive cleaning materials which will hurt the surface finish
- Do not use any cleaning with acidic substances or soda. We suggest use cleaning agents with a PH of 7
- The vanity unit must be kept dry and not subject to continuous moisture
- All spillages and splashes must be wiped off
- Do not lean on fully opened doors or drawers
- Check the hinges and sliders every 6 months and any loose screws must be tightened
Technical Helpline
Technical Helpline : 01452 317890 (Open times: Mon – Fri 8:00am-17:pm)
Email: technical@eastbrookco.com
Eastbrook Road, Gloucester GL4 3DB
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>