MONOGRAM ZK1BN304VRH Brass and Titanium Door Panel Kit Installation Guide

MONOGRAM ZK1BN304VRH Brass and Titanium Door Panel Kit

Specifications

• Designated Width:
  • 30
  • 36
• Actual Width:
  • 29-9/16
  • 35-9/16
• Actual Height:
  • 91-7/8
  • 91-7/8
• Door Thickness: 3/4

FAQs

• Q: Why is it important to secure the appliance to prevent tipping forward?
  • A: Securing the appliance prevents tip-over hazards, especially with open doors, reducing the risk of serious injury or death due to tipping forward.
• Q: How can I minimize the finger pinch point hazard when operating the door?
  • A: To minimize this risk, follow the installation instructions carefully for cabinet dimensions, trim assembly, and door stop angle, especially in households with children.

SAFETY INSTRUCTIONS

• Brass: ZK1BN304VRH, ZK1BN309VLH, ZK1BN364VRH, ZK1BN369VLH
• Titanium: ZK1TN304VRH, ZK1TN309VLH, ZK1TN364VRH, ZK1TN369VLH

WARNING Tip Over Hazard.

• These appliances are top-heavy, especially with any doors open, and must be secured to prevent tipping forward which could result in death or serious injury.
• Read and follow the entire installation instructions for securing the appliance with the anti-tip system before installing the door panel kit.

WARNING Door Trim Pinch Point Hazard

• Improper installation can lead to a finger pinch point hazard between the side door trim and the cabinets when operating the door, especially with children.
• To minimize this risk you must follow the installation instructions for cabinet dimensions, trim assembly, and door stop angle.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• Note to Installer – Be sure to leave these instructions with the Consumer.
• Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.

ADDITIONAL PARTS PROVIDED

PRODUCT DIMENSIONS

Installation Instructions

Please Note: These Door Panels are taller than standard door panels. The required installation space is 12″ taller than indicated in the Column Installation Instructions. Refer to the sections marked “DUAL INTEGRATED INSTALLATION SPACE” and “SINGLE INTEGRATED INSTALLATION SPACE” in the Column Installation Instructions. Increase the height to 96″. All other dimensions remain the same.

INSTALL DOOR PANEL

1. Remove the bottom hinge cover and retain the four T30 Torx screws for later installation.
2. Open door to 90°. Slide the panel onto the door with the panel brackets interlocking on top and bottom with the door brackets (make sure not to slide the panel into the cabinetry surround). Center the panel on the door, then slowly close the door while watching to make sure the panel does not contact the surrounding cabinetry.
3. With the door fully closed, carefully slide the panel towards the cabinetry with the goal gap of 1/8″.

Note: Instructions for this kit are also included in the full installation instructions included with the unit.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>