AUSSIE TRAVELLER 25L Microwave Oven Instruction Manual

AUSSIE TRAVELLER 25L Microwave Oven

Specifications

• Product: Microwave Bracket
• Compatibility: Aussie Traveller 25L Microwave Oven
• Material: Metal
• Dimensions: Standard size for microwave oven installation

FAQs

• What type of screws should be used for installation?
  • Use (maximum) 8gx14mm screws or 5-4 pop rivets for attaching the bracket to the microwave oven.
• Can I install screws in areas other than the pre-punched holes?
  • No, do not install screws into any section of the bracket or microwave other than the pre-punched holes to avoid damage.

PRODUCT INTRODUCTION

• This bracket is used to mount the Aussie Traveller 25L Microwave Oven into your caravan or RV unit.

INSTALLATION

1. Remove the microwave oven from the packaging and sit on a flat bench with clear access to both sides. Position the microwave oven so that the front face and door is slightly over the edge of the bench to allow for the bracket to be fitted. (Fig. 1.)
2. Position the microwave bracket onto the microwave oven, ensuring that the face of the bracket is even or slightly behind the face of the microwave itself. If the bracket is forward of the microwave oven face, the bracket may interfere with the door hinges and not allow the door to open fully. (Fig. 2–3.) Ensure the bracket is orientated correctly with the door hinge side of the bracket on the hinge side of the microwave. (Fig. 4.)
3. Using (maximum) 8gx14mm screws or 5-4 pop rivets, carefully fix the bracket to each side of the microwave oven using the pre-punched hole locations. (Fig. 5)
4. Once the bracket has been affixed securely on the sides of the microwave oven using the 4 pre-punched hole locations, connect the microwave 3-pin plug into the power source and switch on. Fit the microwave oven into place (into the cavity). It is highly recommended that the power to the power point is switched off at the circuit breaker before fitting the microwave into the cavity and connecting it to the PowerPoint. When connecting the plug to the PowerPoint, ensure the power cord is not in contact with the microwave oven body and that there is clear space between all side and rear walls and the oven — refer to the Aussie Traveller Microwave Oven instruction manual.
5. Once the microwave oven with the bracket secured is in position in the cavity, open the microwave door.
6. There are 2x pre-punched holes at the top of the bracket and 2x pre-punched holes at the bottom. Carefully affix the top and bottom sections of the bracket to the cupboard (wall) section of the cavity. (Fig. 6.) Make sure the screws finish flush onto the microwave bracket. (Fig. 7.)
7. Open and close the door ensuring there is no interference.
8. Connect the power at the circuit breaker to ensure power is active to the microwave.

NOTE: DO NOT install screws into any section of the bracket or microwave other than the pre-punched holes.

PRE-PUNCHED HOLE LOCATIONS

NOTE: Images are representative only.

WARRANTY STATEMENT

Aussie Traveller Pty Ltd ACN 642 775 460 (Aussie Traveller) offers the following warranty to the products it supplies directly or through an authorized manufacturer, dealer, or approved service repair agent (Product).

Australian Consumer Law

• The benefits of this warranty are in addition to any rights and remedies imposed by Australian State and Federal legislation that cannot be excluded. Nothing in this warranty is to be interpreted as excluding, restricting, or modifying any State or Federal legislation applicable to the supply of goods and services which cannot be excluded, restricted or modified.
• If you are a consumer as defined in the Australian Consumer Law: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Warranty

Aussie Traveller warrants that subject to the exclusions and limitations below, all parts of the manufacture and assembly of the Product will be free from defects in materials and workmanship (Warranty) for 12 months from the date of purchase as follows:

1. This Warranty is activated at the time of purchase by the final retail customer (being the owner of the Product).
2. In the event the Product is purchased by a manufacturer, dealer, or approved service repair agent, this Warranty will commence at the time the final retail customer makes payment for the Product to the wholesale purchaser.
3. If the Product is purchased directly from Aussie Traveller for use by the final retail customer and is not to be on sold in any way, the Warranty will commence at the time of the original purchase.

Warranty Period

• This Warranty cannot be assigned or transferred to a subsequent owner of the Product.
• The purchaser or final retail customer should inspect the Product immediately when received or at vehicle handover, to ensure that it appears free from any damage or defect, and matches the description provided.
• If after accepting the Product, a defect appears in the manufacture or assembly of the Product before the end of the Warranty Period and Aussie Traveller finds the Product to be defective in materials or workmanship, Aussie

Traveler will, in its sole discretion, either:

• a. replace, repair, or refund the Product or the defective part of the Product free of charge; or
• b. cause the Product or the defective part of the Product to be replaced or repaired by a qualified repairer free of charge.

In arranging Warranty inspection, service, and repair, Aussie Traveller will seek to provide the details of an approved service agent within your geographic area. Should one not be available, or if the Product is in use in travel, Aussie Traveller reserves the right to seek to arrange a repair or replacement at the next available location on the route of travel. Aussie Traveller reserves the right to replace defective parts of the Product with parts and components of similar quality, grade, and composition where an identical part or component is not available. Products presented for repair may be replaced by refurbished goods of the same type rather than being repaired. Refurbished parts may be used to repair the Product.

Aussie Traveller Awning Products
This Warranty covers specified defects in materials or workmanship for Awning Products as follows:

1. The vinyl fabric is warranted against:
   • a. holes caused by mildew (mildew will form on dust and dirt and stain fabric if fabric is not kept clean).
   • b. excessive cracking, peeling, hardening, or loss of strength while used under normal conditions.
   • c. excessive fading (a slight color change may occur due to ultraviolet rays).
2. All hardware components including the roller are warranted not to bend or break under normal use (excluding high winds, water pooling, and accidents).

Making a Warranty Claim

• If a defect covered by this Warranty appears, the Customer must first contact Aussie Traveller within 7 days of first becoming aware of the defect. Aussie Traveller will assist the Customer to rectify and resolve any Product issue that may arise.
• When claiming this Warranty, Aussie Traveller requires that the following information be provided before any further action will be taken.

1. Original Invoice (Document or Number);
2. Make and model of the Product;
3. Make and model of the vehicle (if Product fitted);
4. Vehicle build date (if Product fitted);
5. Vehicle chassis number;
6. Description of damage and/or repair required;
7. Photos of the damage and/or repair; and
8. Appropriate documentation (such as historical and maintenance records).

Aussie Traveller reserves the right to request more information or images should what is provided not be sufficient to assess the Warranty claim. The Product must be made available to Aussie Traveller or its authorized repair agent for inspection and testing. If such inspection and testing find no defect in the Product, the final retail customer must pay Aussie Traveller’s usual costs of service work and testing. The final retail customer must bear the cost of the transport of the Product to and from Aussie Traveller or the authorized repair agent, and all insurance of the Product.

Exclusions

This Warranty will not apply where:

• the Product has been repaired, altered, or modified by someone other than Aussie Traveller, or without the written consent of Aussie Traveller or an authorized repair agent;
• the alleged defect in the Product is within acceptable industry tolerances and variances;
• Aussie Traveller cannot establish any fault in the Product after testing and inspection;
• the Product has been used other than for the purpose for which it was designed;
• the alleged defect in the Product has arisen due to the final retail customer’s failure to properly use and
• maintain the Product by any of Aussie Traveller’s instructions, recommendations, and specifications (including applicable maintenance schedules);
• the alleged defect in the Product has arisen due to the final retail customer’s request to customize the Product;
• the Product has been subject to abnormal conditions, including environment, temperature, high or excessive wind, water, fire, humidity, pressure, stress or similar;
• the alleged defect has arisen due to abuse, misuse, neglect, or accident;
• unauthorized parts or accessories have been used on or about the Product;
• the Product has been overloaded or involved in an accident;
• the alleged damage or defect has been caused by normal wear and tear;
• the alleged damage to fabric has been caused by storm, wind or rain, or stretching of fabric caused by water pooling on fabric;
• breakage or bending of hardware components has been caused by storm, wind rain, or water pooling on fabric.

Replacement Warranty Item

• If, under Warranty, a Product is replaced or repaired by Aussie Traveller or an Aussie Traveller agent, unless provided in writing to indicate otherwise, the replacement Product will carry the remaining Warranty terms and conditions, including length of time, of the original purchased Product.

Change of Mind

• Aussie Traveller understands that at times, final retail customers may change their mind. Choose carefully as return and credit requests for items purchased by mistake or “change of mind” reasons may not be approved. Aussie Traveller will not accept Product returns under these circumstances unless by written approval by an authorized Aussie Traveller representative. If approved, an administration and restocking fee may apply.

Limitations

• Aussie Traveller makes no express warranties or representations other than those set out in this Warranty. The repair or replacement of the Product or part of the Product is the absolute limit of Aussie Traveller’s liability under this express Warranty

Contact

• Australia Wide: 1300 663 868
• Melbourne Office
• 235 Barry Road
• Campbellfield, Melbourne, 3061
• Ph: +61 3 9357 6565
• enquiries@aussietraveller.com.au.
• Brisbane Head Office, Factory & Showroom
• 11-15 Oasis Court
• Clontarf, Brisbane, 4019
• Ph: +61 7 3284 3284
• enquiries@aussietraveller.com.au.

To receive a copy of the Aussie Traveller Warranty Terms & Conditions or information regarding specific Aussie Traveller products, please contact Aussie Traveller Head Office at (07) 3284 3284 or email enquiries@aussietraveller.com.au.

References

• AussieTraveller.com is for sale | HugeDomains

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>