JFA Redline Remote Control User Manual
- October 30, 2023
- JFA
Table of Contents
JFA redline remote control
PRESENTATION
The REDLINE allows you to control by distance¹ the main functions of the “player” and change music, folder, volume, pause, play, and power.
FUNCTIONING
Transmitter unit: Each time a key is pressed, a radio frequency (RF) signal is transmitted to the receiving unit. Receiving unit: it will turn on the “led action” indicating the presence of a received signal and controls the player through the P2 plug of the W/R interface of the PIONEER brand models that have this input and PLAYERS with the resistive interface.
IMPORTANT REMARKS
- To avoid interference, install the receiving unit at a distance of at least 1 meter from the alarm center or electronic injection module.
- For a greater range, the antenna should be kept stretched and in a place that is visually and distant from the car store.
- Check the intensity of the light on the led of the transmitter unit. If it is weak or does not turn on, replace the battery.
BASIC COMMANDS THE TRANSMITTER UNIT
-
Volume control (+);
-
Volume control ( _ );
-
Rewind the music;
-
Advance the music;
-
LED indicator;
-
Go up the folder;
-
Go down the folder;
-
Play/pause / ATT;
-
Power/function (switches to aux, CD, USB, radio, etc.).
BASIC COMMANDS OF THE RECEIVER UNIT
-
RF receiver antenna;
-
Led action, reception indicator;
-
Memory mode button;
-
12v power supply (black white stripe) and GND (black);
-
Connector for W/R interface for Pioneer models;
-
Resistive interface cable for Players with this technology;
CONTROL CODING
To encode a control, follow these steps:
- Press the “M” key on the receiver (Indication 9). The LED ACTION (Indication 8) will have permanent access;
- Press the (+) key on the control (Indication 1). Verify that the led ACTION (indication 8) will blink 1 time, indicating that the control has been encoded with the REDLINE receiver.
- After gnashing this process, LED ACTION (Indication 8) lights up will delete immediately.
IMPORTANT REMARK
The panel will not work if the procedure control coding is not performed.
RECOMMENDED INSTALLATION FOR THE RECEIVER (W/R MODE)
TECHNICAL SPECIFICATIONS
|
---|---
UNITY RECEIVER
| Operating voltage: 9 to 16 V
Stand-by consumption: 13 mA
Reverse polarity protection: YES
UNITY TRANSMITTER
| Battery model: A 23 – 12 V
Operating Frequency: 433.92 MHz
Reverse polarity protection: NO
Radiated power (3 meters): 0.808 mW
Modulation: ASK
|
APPROVED PRODUCT
- 01260-14-04318
“This equipment operates on a secondary basis, does have not the right of protection against harmful interference, even of the same type of station, and not may cause interference to systems operating on a primary basis. “
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>