AUSSIE TRAVELLER Eyeball Rear View Camera Instruction Manual
- June 5, 2024
- AUSSIE TRAVELLER
Table of Contents
AUSSIE TRAVELLER Eyeball Rear View Camera
INCLUDES
BLACK EYEBALL REAR VIEW CAMERA:
- Black Eyeball Rear View Camera with Mount
- 7″ TFT, LCD Monitor
- Window Suction Mount
- Fixed Mount
- 15m Cable (for Towed Vehicle)
- 5m Cable (for Tow Vehicle)
- 5m Coiled Cable for Connection Between Vehicles
WHITE EYEBALL REAR VIEW CAMERA:
- White Eyeball Rear View Camera with Mount
- 7″ TFT, LCD Monitor
- Window Suction Mount
- Fixed Mount
- 15m Cable (for Towed Vehicle)
- 5m Cable (for Tow Vehicle)
- 5m Coiled Cable for Connection Between Vehicles
BLACK SQUARE REAR VIEW CAMERA:
- Black Square Rear View Camera with Mount
- 7″ TFT, LCD Monitor
- Window Suction Mount
- Fixed Mount
- 15m Cable (for Towed Vehicle)
- 5m Cable (for Tow Vehicle)
- 5m Coiled Cable for Connection Between Vehicles
SPECIFICATIONS
TFT LCD MONITOR:
- Screen dimensions: 7 inch
- Resolution: 800 x 480 RGB
- System: PAL & NTSC auto switch
- Power: DC 12V
- Consumption: 3W
- Video: Two way video input
- Rear View: Image can be changed Left & Right
- Operate Mode: Key button & Remote control
- Size: 180 x 120 x 50 (mm)
CAMERAS:
- System: PAL/NTSC
- Effective Pixels: 648 x 488 pixels
- Sensing Area: 5.55um x 5.55um
- Scanning System: 2:1 interlace
- Sync System: Internal
- Resolution: 420 TV lines
- Horizontal Sync,Frequency: 15.625KHz / 15.73KHz
- Vertical Sync,Frequency: 50Hz / 60Hz
- Minimum illumination: 1.5lux/F1.2
- Video Output: 1.0VP-P.75Ohm
- Gamma Consumption: 0.45
- AGC: Auto
- S/N ratio: Better than 48Db
- White Balance: Auto
- Electronic Shutter: 1/60-1/15,000 Seconds
- BLC: Auto
- Current Consumption: 80Ma
- Power Supply: DC 12V
- Operating Temperature: -10°C~46°C RH95% MAX
- Storage Temperature: -30°C~60°C RH95% MAX
- Lens: 1.8mm F=2.0
- Lens Angle: 120°
- Waterproof Grade: IP67
TFT LCD MONITOR USER MANUAL
MONITOR
- AV1/AV2
- Image Angle
- Menu
- Adjust Down –
- Adjust Up +
- Power ON/OFF
- Infrared Receiver
REMOTE CONTROL
- Power ON/OFF
- Video Select
- Adjust Down –
- Adjust Up +
- Menu (Brightness,Color,Contrast)
- Mode: Select Display
WARNING
CONTAINS BUTTON OR COIN CELL BATTERY—KEEP OUT OF REACH OF CHILDREN
Swallowing can lead to chemical burns, perforation of soft tissue, and death.
In the case of Lithium batteries, fatal injuries can occur in 2 hours or less
if it is swallowed or placed inside any part of the body. Severe burns can
occur within 2 hours of ingestion. Seek medical attention immediately. No
matter whether the battery is new or used.
If it is suspected your child or a person has swallowed or inserted a
button/coin battery inside any part of the body, contact the
24-hour Poisons Information Centre on 13 11 26 (Australia) or 0800 764 766
(New Zealand) immediately for 24/7 fast, expert advice.
Always check your devices to ensure the battery compartment is correctly
secured. Do not use if compartment is not secure.
Dispose of used batteries correctly and out of reach of children—even when
used they are still dangerous.
REVERSE CAMERA INSTALLATION INSTRUCTIONS
WARRANTY STATEMENT
Aussie Traveller Pty Ltd ACN 642 775 460 (Aussie Traveller) offers the following warranty in relation to the products it supplies directly or through an authorised manufacturer, dealer or approved service repair agent (Product).
Australian Consumer Law
The benefits of this warranty are in addition to any rights and remedies imposed by Australian State and Federal legislation that cannot be excluded. Nothing in this warranty is to be interpreted as excluding, restricting or modifying any State or Federal legislation applicable to the supply of goods and services which cannot be excluded, restricted or modified.
If you are a consumer as defined in the Australian Consumer Law: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Warranty
Aussie Traveller warrants that, subject to the exclusions and limitations
below, all parts of the manufacture and assembly of the Product will be free
from defects in materials and workmanship (Warranty) for a period of 12 months
from the date of purchase as follows:
- This Warranty is activated at the time of purchase by the final retail customer (being the owner of the Product).
- In the event the Product is purchased by a manufacturer, dealer or approved service repair agent, this Warranty will commence at the time the final retail customer makes payment for the Product to the wholesale purchaser.
- If the Product is purchased directly from Aussie Traveller for use by final retail customer and not to be on sold in any way, the Warranty will commence at the time of the original purchase.
Warranty Period
This Warranty cannot be assigned or transferred to a subsequent owner of the
Product.
The purchaser or final retail customer should inspect the Product immediately
when received or at vehicle handover, to ensure that it appears free from any
damage or defect, and matches the description provided.
If after accepting the Product, a defect appears in the manufacture or
assembly of the Product before the end of the Warranty Period and Aussie
Traveller finds the Product to be defective in materials or workmanship,
Aussie Traveller will, in its sole discretion, either:
- replace, repair or refund the Product or the defective part of the Product free of charge; or
- cause the Product or the defective part of the Product to be replaced or repaired by a qualified repairer free of charge.
In arranging Warranty inspection, service and repair, Aussie Traveller will
seek to provide the details of an approved service agent within your
geographic area. Should one not be available, or if the Product is in use in
travel, Aussie Traveller reserves the right to seek to arrange a repair or
replacement at the next available location on the route of travel.
Aussie Traveller reserves the right to replace defective parts of the Product
with parts and components of similar quality, grade and composition where an
identical part or component is not available.
Products presented for repair may be replaced by refurbished goods of the same
type rather than being repaired. Refurbished parts may be used to repair the
Product.
Aussie Traveller Awning Products
This Warranty covers specified defects in materials or workmanship for Awning Products as follows:
- The vinyl fabric is warranted against:
- holes caused by mildew (mildew will form on dust and dirt and stain fabric if fabric is not kept clean).
- excessive cracking, peeling, hardening or loss of strength while used under normal conditions.
- excessive fading (a slight colour change may occur due to ultraviolet rays).
- All hardware components including the roller are warranted not to bend or break under normal use (excluding high winds, water pooling and accidents).
Making a Warranty Claim
If a defect covered by this Warranty appears, the Customer must first contact
Aussie Traveller within 7 days of first becoming aware of the defect. Aussie
Traveller will assist the Customer to rectify and resolve any Product issue
that may arise.
When making a claim under this Warranty, Aussie Traveller requires that the
following information be provided before any further action will be taken.
- Original Invoice (Document or Number);
- Make and model of the Product;
- Make and model of the vehicle (if Product fitted);
- Vehicle build date (if Product fitted);
- Vehicle chassis number;
- Description of damage and/or repair required;
- Photos of the damage and/or repair; and
- Appropriate documentation (such as historical and maintenance records).
Aussie Traveller reserves the right to request more information or images
should what is provided not be sufficient to make an assessment for the
Warranty claim.
The Product must be made available to Aussie Traveller or its authorised
repair agent for inspection and testing. If such inspection and testing find
no defect in the Product, the final retail customer must pay Aussie
Traveller’s usual costs of service work and testing.
The final retail customer must bear the cost of the transport of the Product
to and from Aussie Traveller or the authorised repair agent, and all insurance
of the Product.
Exclusions
This Warranty will not apply where:
-
the Product has been repaired, altered or modified by someone other than Aussie Traveller, or without the written consent of Aussie Traveller or an authorised repair agent;
-
the alleged defect in the Product is within acceptable industry tolerances and variances;
-
Aussie Traveller cannot establish any fault in the Product after testing and inspection;
-
the Product has been used other than for the purpose for which it was designed;
-
the alleged defect in the Product has arisen due to the final retail customer’s failure to properly use and
-
maintain the Product in accordance with any of Aussie Traveller’s instructions, recommendations and specifications (including applicable maintenance schedules);
-
the alleged defect in the Product has arisen due to the final retail customer’s request to customise the Product;
-
the Product has been subject to abnormal conditions, including environment, temperature, high or excessive wind, water, fire,
-
humidity, pressure, stress or similar;
-
the alleged defect has arisen due to abuse, misuse, neglect or accident;
-
unauthorised parts or accessories have been used on or in relation to the Product;
-
the Product has been overloaded or involved in an accident;
-
the alleged damage or defect has been caused by normal wear and tear;
-
the alleged damage to fabric has been caused by storm, wind or rain, or stretching of fabric caused by water pooling
on fabric; -
breakage or bending of hardware components has been caused by storm, wind or rain, or water pooling on fabric.
Replacement Warranty Item
If, under Warranty, a Product is replaced or repaired by Aussie Traveller or
an Aussie Traveller agent, unless provided in writing to indicate otherwise,
the replacement Product will carry the remaining Warranty terms and
conditions, including length of time, of the original purchased Product.
Change of Mind
Aussie Traveller understands that at times, final retail customers may change their mind. Choose carefully as return and credit requests for items purchased by mistake or “change of mind” reasons may not be approved. Aussie Traveller will not accept Product returns under these circumstances unless by written approval by an authorized Aussie Traveller representative. If approved, an administration and restocking fee may apply.
Limitations
Aussie Traveller makes no express warranties or representations other than set
out in this Warranty.
The repair or replacement of the Product or part of the Product is the
absolute limit of Aussie Traveller’s liability under this express Warranty.
Contact
Australia Wide: 1300 663 868
Melbourne Office
235 Barry Road
Campbellfield, Melbourne, 3061
Ph: +61 3 9357 6565
enquiries@aussietraveller.com.au
Brisbane Head Office, Factory & Showroom
11-15 Oasis Court
Clontarf, Brisbane, 4019
Ph: +61 7 3284 3284
enquiries@aussietraveller.com.au
To receive a copy of the Aussie Traveller Warranty Terms & Conditions or
information regarding specific Aussie Traveller products, please contact
Aussie Traveller Head Office on (07) 3284 3284 or email
enquiries@aussietraveller.com.au.veller.com.au