beamZ S900 160.487 Smoke Machine Instruction Manual

: June 4, 2024
: beamZ

Table of Contents

Warning:
Safety
Installation and Use
Location
Switching the unit off
Maintenance
Specifications
Accessories
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Ref. Nr. 160.487 S900
INSTRUCTION MANUAL

Warning:

The smoke machine must be placed at least 100 cm away from inflammable materials such as curtains, books, etc. Make sure that the housing cannot be touched by accident.
For indoor use only.
During installation, nobody should stand beneath the mounting area.
Prior to the first use, have the unit checked by a qualified person.
The unit contains voltage-carrying parts. DO NOT open the smoke machine.
Never plug or unplug the unit with wet hands.
If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
If the unit is damaged to an extent that you can see internal parts, do not plug the unit into the main outlet. It needs to be repaired by a qualified technician.
Only connect this unit to an earthed mains outlet of 230Vac/50Hz.
Always unplug the unit during a thunderstorm or when it is not in use.
If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please let the unit reach room temperature prior to use.
When you unplug the unit from the mains always pull the plug, never the lead.
In order to prevent the dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a steel cable, etc. which has to be fastened separately from the mounting bracket.
The supplied bracket is the main fixing and must be used to solidly mount the light effect.
In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings must be fulfilled.
Keep out of the reach of children.

Safety

Plug the smoke machine only in an earthed mains outlet or extension cord!
ATTENTION: the power cord can only be replaced by an original replacement, supplied by Tronios.
Be careful when filling the fluid tank. First of all, unplug the mains lead! Then unscrew the cap on the tank and fill it by means of a funnel.
Only use the original Beamz smoke fluid which is environmentally friendly and, if used correctly, leaves no residues.
Do not obstruct the openings on top of the case to guarantee a good ventilation. The heating element of the smoke machine generates heat which needs to be removed. Don’t put any objects on the smoke machine.

Installation and Use

Unpack the fog machine. Fill the fluid tank by means of a funnel. Plug the unit into the main outlet. Thus the heating element is automatically switched on. Depending on the room temperature, it takes about 5 minutes until the working temperature is reached. Then the thermostat is clicking and the LED on the manual control lights up. Push the switch once and the smoke machine will produce a nice thick fog. Once the smoke machine has reached its working temperature (the LED is lit) the smoke machine can produce continuously fog for about 1 minute.
After this period of time, the fog generator is cooled so much down that the thermostat switches off. Wait a few minutes until the working temperature is reached again. It is recommended to produce smoke with small pauses in between so that the temperature is maintained and the thermostat doesn’t switch off.

Location

Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied holder and fixing screws.

Switching the unit off

Switch the unit off by unplugging it from the mains. Otherwise, the 900W heating element will draw unnecessarily current.

Maintenance

Refilling the fluid reservoir should be done carefully. Remove the plug from the mains first! Then unscrew the cap of the reservoir and fill it by means of a suitable funnel. Use only the original Beamz smoke liquid. This fluid is environmentally friendly, biodegradable and leaves no residue when used correctly. Make sure the smoke liquid becomes contaminated, close the cap of the liquid smoke can and after filling the tank right. After 40 hours, the smoke machine must be cleaned to avoid deposits in the machine, pump, and heater.
Clean procedure
Run clean procedure in a well-ventilated area

Remove smoke liquid from the tank, add cleaning solution to the tank
Switch the smoke machine and wait until it is warm-up
Press the button to switch the liquid pumped through the machine
Perform the above operation until the tank is empty
Fill the tank with liquid smoke

Specifications

Power supply: …………………………………………. 220-240VAC/50Hz
Heating element: ………………………………………………….. 900 watts
Heat up time: ……………………………………………………. 3.5minutes
Smoke production: …………………………………….. ca. 125m³/minute
Tank capacity: ……………………………………………………….. 2,5 liters
Dims: ……………………………………………………. 345 x 205 x 190mm
Weight ……………………………………………………………………… 4.2 kg

Accessories

Smoke fluid, high-quality fluid on a water basis, specially designed for Beamz smoke machines. Guarantees trouble-free use.
5-liter packaging, ref. no. 160.583
1-liter packaging, ref. no. 160.644
Flavor, adds a pleasant fragrance to the air. One bottle is sufficient for a 5-liter smoke fluid.

coconut	160.65	tropical	160.653
mint	160.651	strawberry	160.654
vanilla	160.652

Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the warnings contained in this manual. Tronios BV cannot be held responsible for personal injuries caused by the disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.
Electric products must not be put into household waste. Please bring them to a recycling center. Ask your local authorities or your dealer about the way to proceed.
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications can be changed without prior notice.
The products referred to in this manual is conforming European and UK legislation directives to which they are subject:
European Union
Tronios B.V.,
Bedrijvenpark Twente Noord 18, 7602KR Almelo, The Netherlands
2014/35/EU
2014/30/EU
2011/65/EC

United Kingdom
Tronios Ltd., 130 Harley Street,
London W1G 7JU, United Kingdom
S.I. 2016:1101/ S.I. 2016:1091
S.I. 2012:3032
www.tronios.com
Copyright © 2022 by TRONIOS the Netherlands