BONDLINE WST1 ESD Wrist Strap Tester Calibrator Instruction Manual
- August 28, 2024
- BONDLINE
Table of Contents
Instruction Manual
ESD Wrist-Strap Tester Calibrator WST1/2/3
(WSC-QC) Registered at Cardiff No. 2933918
Registered Office: Bondline Electronics, Unit 4,
Rivermead Industrial Estate, Rivermead Drive,
Swindon, Wiltshire, SN5 7EX
Introduction
Thank you for purchasing an ESD Wrist-Strap Tester Calibrator WST1/2/3. Please read this instruction manual in great detail before operating the device. Keep this manual readily accessible for later reference.
Description
The ESD Wrist-Strap Tester Calibration Unit is designed to simplify the process of calibrating ESD Wrist-Strap Testers WST1/2/3. This unit allows the user to quickly and easily verify whether a tester is operating within specifications. The unit is a passive device and requires no power source. Light and audible signals verify results on the unit you are testing. The ESD Wrist-Strap Tester Calibrator is CE approved.
Specifications
| Low Fail Ohms | 685 KΩ |
|---|---|
| ‘Low Pass Ohms | 825 KΩ |
| High Pass Ohms | 31.50 MΩ |
| High Fail Ohms | 38.5 MΩ |
| Accuracy | ±10% |
| Dimensions | 96mm L x 61mm W x 40mm H |
Operation
- Connect the two leads to the banana sockets at the top of the calibration unit.
- Connect one of the leads to the banana socket of the WST-1 and touch the metal plate of the WST- 1 with the other.
- Once you have done this, you can then check low fail, etc. moving around the test knob on the calibrating unit.
sales@bondline.co.uk
www.bondline.co.uk
+44 (0)1793 511000
The information contained within this instruction manual is for guidance only.
We make no warranties expressed or implied and assume no liability regarding
any use of this information. (Re-view February 29th 2024)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>