B K Licht BKL1396 Ceiling Lamp Instruction Manual

: June 3, 2024
: B K Licht

Table of Contents

BKL1396 Ceiling Lamp
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BKL1396_BKL1397REV 00 / 08-2020
Mounting instructions

B K Licht BKL1396 Ceiling Lamp

BKL1396 Ceiling Lamp

Safety directions / Please read this information carefully before installing or using this product. Please keep this user manual for further reference.

The lamps may only be installed by authorized and qualified technicians according the valid regulations for electrical installation.
The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the light.
Maintenance of the lights is limited to the surfaces. When doing this, no moisture must come into contact with any areas of the terminal connections or mains voltage control parts.
Attention! Before starting the installation work, make sure that the mains power line is voltage-free – turn off safety cutout or unscrew the protection fuse. The switch must be “OFF”.
Warning! Before drilling the mounting holes, make sure that no gas, water or electricity pipes and wires can be drilled through or damaged in your chosen mounting location.
When mounting the wall or ceiling fixture, ensure that the attachment material is suitable for the subsurface and that this surface is capable of carrying the weight of the fixture. The manufacturer is not liable for improper installation of the item on the relevant subsurface.
The lights have a protection class rating of “IP20“ and are solely intended for use in interior areas of private households.
The symbol of the crossed-out garbage can on the product or the packaging means that the product must not be disposed with ordinary household waste. At the end of its useful life, the product must be returned to a point of acceptance for the recycling of electric and electronic device. Please ask your local municipality for the point of acceptance.
Safety class I. This light must be connected to the earthed conductor-terminal with the earthed conductor (green-yellow wire) .
Description of the supply terminals: L = Phase N = Neutral conductor = Earthed conductor.
Do not install the light on a damp or conductive subsurface.
Please make sure that no cables get damaged during the installation work.
Attention! During operation, lamp parts and illuminants can reach temperatures of more than 60°C. Do not touch during operation!
Do not look directly into the light source (illuminant, LED, etc.).
Please make sure that illuminants have first cooled down before replacing them. Attention! Switch the mains power line to zero potential and switch-off the circuit breaker and/or remove the fuse before!
Make sure that illuminants are securely fixed during the installation.
The maximum wattage indicated of each lighting unit must not be exceeded.