BRESSER PSW 88 Mobile Power Station Instruction Manual

BRESSER PSW 88 Mobile Power Station

• Visit our website via the following QR Code or web link to find further information on this product or the available translations of these instructions.

About this Instruction Manual

Please read the safety instructions and the operating instructions carefully before use.

Keep these instructions for renewed use at a later date. When the device is sold or given to someone else, the instruction manual must be provided to the new owner/user of the product.

General Warning

DANGER!
Children should only use the device under adult supervision. Keep packaging material, like plastic bags and rubber bands, out of the reach of children, as these materials pose a choking hazard. Do not expose the device to high temperatures. Excessive heat or improper handling could trigger a short circuit, a fire or an explosion.

FIRE RISK!
Do not place the device, particularly the lenses, in direct sunlight. The concentration of light could cause a fire.

RISK of ELECTRIC SHOCK!
This device contains electronic components that ope-rate via a power source. Children should only use the device under adult supervision. Only use the device as described in the manual; otherwise, you run the risk of an electric shock.

NOTE!
Do not dismantle the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if necessary.

NOTES on Cleaning
Before cleaning the device, disconnect it from the po-wer supply! Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid. Clean the eyepieces and/or lenses only with a soft, lint-free cloth, (e.g. microfibre cloth). To avoid scratching the lenses, use only gentle pressure with the cleaning cloth. Protect the device from dust and moisture.

The unit provides Modified Sine Wave output
The unit provides Modified Sine Wave output and can be compatible with AC electric appliances that work with Sinusoidal waveform (power <80W). However, anything that uses an AC motor isn‘t going to work to full capacity on a modified sine wave, such as an electrical fan. It will even make the electric appliance emit some noise. Appliances like refrigerators, microwave ovens, and compressors that use AC motors and some delicate medical equipment will be better off with a pure sine wave inverter. This product is only used for an emergency, it cannot replace the normal alternating current, for long-term use.

EC DECLARATION OF CONFORMITY

Bresser GmbH has issued a „Declaration of Conformity“ in accordance with applicable guidelines and corresponding standards. The full text of the EU declaration of Conformity is available at the following internet address: www.bresser.de/download/9638100/CE/9638100_CE.pdf

UKCA DECLARATION OF CONFORMITY

Bresser GmbH has issued a „Declaration of Conformity“ in accordance with applicable guidelines and corresponding standards. The full text of the UKCA declaration of conformity is available at the following internet address: www.bresser.de/download/9638100/UKCA/9638100_UKCA.pdf Bresser UK Ltd. Suite 3G, Eden House, Enterprise Way Edenbridge, Kent TN8 6HF, Great Britain

Scope of delivery
Mobile Power Station, Power Adapter, Micro USB cable

Technical data

• Capacity 88.8wh,6Ah/14.8V (equivalent:24000mAh/3.7V)

• Dimensions(LWH) 165x80x117 mm

• Weight about 1.04 kg

• Built-in Battery High-Quality Lithium-ion Batteries

• Input Recharging Adapter: DC19V/1.5A Solar Panel Charging: DC 15V-24V/1.2A Max Time until fully charged DC19V/1.5A: 5~6 hours

• USB Output

  • 2 x USB 5V-2.4A Total:4.8A Max
  • 2 x USB 5-12V/2A QC3.0(18W Max, Total: 5V/3.4A max)
  • 1 x USB C 5V/3A,9V/2A,12V/1.5A(PD2.0 18W Max)

• DC Output DC Output 12-16.8V/10A Total 13A Max

• AC Output

  • Modified SineWave Output;
  • AC Voltage: 100/110/120/220/230/240VAC±10%
  • Output Frequency: 50/60Hz±10%
  • Attention: Actual AC voltage/Frequency/Outlet(s) are customized according to different countries and areas.
    AC Power AC Continuous Output: 80W/120W Max

• Bulb Type

  • 1 x LED light (low: 52 lm, medium: 92 lm, high: 132 lm, SOS)

• Power Indicator LED Indicators

• Operation temperature -10° – 40°

• Lifecycle >500 times

Parts overview

Qualcomm QuickCharge 3.0 (Total 5V/3.4A Max)

8| USB: 5V-2.4A

Total:4.8A Max

9| DC Output:

12-16.8V/10A (13A Max)

10| USB-C: 5V/3A,9V/2A,12V/1.5A (PD2.0 18W Max)

PRODUCT INSTRUCTIONS

How to provide power for DC12V appliances (such as a head lamp or fan) with this product?
Plug your appliances into the DC output port and press the power switch button to gain power. DC output rated Current: 10A, Max output Current<13A.

Notices: Please confirm whether your DC12V appliance support charging with a 5.5mm DC header interface (The diametre of the DC Port of the Product is: 5.5mm/2.1mm), otherwise it is unable to connect with the DC output, you can consult the electrical manufacturer, buy the corresponding adapter and connect with it.

WARNING!

Note: The DC output voltage has a range between 12V~16.8V, the maximum output current is 13A. DC output voltage drops or increases while battery capacity drops or increases due to the chemical characteristics of the battery. If your appliance does not have a built-in input voltage stabilizing function, it may shut down when the input voltage is too low or too high. If your 12V devices cannot work due to the input voltage being too high, please read the device manual or consult the device manufacturer to get the input voltage range of your device.

Protection Mode:
Short circuit/Overpower Protection: If the DC output is short-circuited or overpowered (Load(s) power>150W), the unit will shut down to protect itself. Please resolve the problem and press the power button of the unit to exit from the protection mode.

How to provide power for AC appliances with this product?
Connect the power cable plug of the electrical appliance to the AC outlet of the product, long press the AC power button for 3-5 seconds to turn on AC output, and the unit will start providing power to your appliance.

When the AC port is not in use, turn it off to conserve power.

ATTENTION!: AC Outlets, AC output voltage and frequency will be different according to different countries or areas. Please refer to the actual product before using it.

Protection Mode:

Short-circuit/Overpower Protection: If the AC output is short-circuited or overpowered (Load(s) power>80W), the unit will shut down AC output to protect itself. Please resolve the problem and re-press the AC button for AC output. Some devices, such as a refrigerator, an ice maker or a laser printer may require a surge po-wer to start or work during a very short time period, the surge power could exceed 120W or even higher, and this could cause overpower protection with this unit. Please remove the devices and consult with the device manufacturers for more information. Please resolve the problem and re-press the AC button for AC output.

How to provide power for USB-C digital appliances with this product?
Connect the standard USB cable of the digital appliance to the USB output of the unit, press the “POWER ” to turn on the USB output.

Notice: Some smart devices, such as Bluetooth headphones and LED lights. Require a very small input current to charge, which could be less than 150mA. The unit may fail to charge this kind of smart device due to the detection of current limitations by the USB output ports. On this occasion, the user can press the AC button “ ” to keep the USB port output running. Please turn off AC output – when the smart devices are fully charged – to save power.

Quick Charge Output : This product supports Qualcomm Quick Charge 3.0 and USB C PD (Power Delivery) 2.0 Output, support: 5V/3A,9V/2A,12V / 1.5A 18W max output for smart devices which also support Qual-comm Quick Charge 3.0 or USB PD2.0 Protocol. The actual output voltage and current depend on the individual smart devices, it can be obtained by consulting the smart device manufacturer .

LED light
This unit is built with ultra-bright LED light. It supports 3 levels of brightness and SOS mode. Long press the button “ ” for 3 seconds to switch on the LED light and single press the button to switch the higher brightness/ SOS mode/off.

Warning! Do not point directly at the eyes of humans in case of any damage due to the strong light.

How to charge the unit?

• Charge through the AC Wall Charger Using the included AC Wall Charger, plug the unit into any wall outlet to charge the unit. You will know the unit is charging when the blue LED battery indicators are blinking. The unit is fully charged when all battery indicators stop blinking and remain solid. After the unit is fully charged, please remove the AC wall charger in time.

Charge from Solar panel

1. Place your solar panel where it will get as much direct sunlight as possible.
2. Plug the output of the solar panel into the input of the unit to start charging. You will know the unit is charging when the blue LED Battery Indicator lights up and blinks. The unit is fully charged when all battery indicators stop blinking and remain solid.

SECURITY AND MAINTENANCE

• Do not short-circuit the unit. To avoid short-circuiting, keep the unit away from all metal objects (e.g. coins, hair-pins, keys, etc.).
• Do not heat the unit, or dispose of it in fire, water or other liquids. Keep away from high temperatures. Do not expose the unit to direct sunlight.
• Keep away from high humidity, and dusty places.
• Do not disassemble or reassemble this unit.
• In order to extend the life of the unit (lithium battery), do not drop, place heavy objects on, or allow any strong impact to this unit.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not cover the device with towels, clothing or other items.
• The unit may become hot when charging. This is normal. Use caution when handling.
• Do not charge the unit over the required time.
• Disconnect the unit when fully charged.
• Use the unit properly to avoid electronic shock.
• Please deal with scrap products in accordance with the regulations, and do not treat the built-in battery as household garbage, so as not to cause an explosion and pollution.
• The product is only used for emergency situations, it cannot replace the standard DC or AC power of household appliances or digital products.

PRODUCT APPLICATION

• This product consists of a high-quality lithium-ion battery, has no memory effect but a high capacity, and is long-lasting. Nevertheless, we recommend that you use it in the range of 10 °C~30°C to maintain optimum charging capacity.
• When charging, in order to avoid interference, please remain away from TV, radio, and other equipment.
• If the unit is not being used for a long time, please disconnect the cable and store it.
• Some portable devices may need to be set in charge mode to charge, see the corresponding equipment user manual for more information.
• In order to extend the life of the lithium battery it is best to charge within 3 months and charge at least once within 6 months.
• The Power Station is suitable for Charge Through / USV. Connected devices can therefore also be operated or charged while charging the Power Station itself.

COLD WEATHER USAGE

Cold temperatures (below freezing) can affect the unit’s battery capacity due to the chemical characteristics of the battery. If you are living off-grid in sub-zero conditions, we recommend you keep your unit in an insulated cooler, and connected to a power source (solar panels). The natural heat generated by the unit contained in an insulated cooler will keep battery capacity at its highest.

BATTERY INFORMATION

Your device has an internal, non-removable, rechargeable battery. Do not attempt to remove the battery, as you may damage the device. The battery can be charged and discharged over 500 times, but it will eventually wear out.

NOTES ON CLEANING
Before cleaning the device, disconnect it from the power supply (remove plug)! Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid. Protect the device from dust and moisture.

DISPOSAL

Dispose of the packaging materials properly, according to their type, such as paper or cardboard. Contact your local waste-disposal service or environmental authority for information on the proper disposal. Do not dispose of electronic devices in the household garbage! As per Directive 2002/96/EC of the European Parliament on waste electrical and electronic equipment and its adaptation into German law, used electronic devices must be collected separately and recycled in an environmentally friendly manner. In accordance with the regulations concerning batteries and rechargeable batteries, disposing of them in normal household waste is explicitly forbidden. Please make sure to dispose of your used batteries as required by law — at a local collection point or in the retail market. Disposal in domestic waste violates the Battery Directive. Batteries that contain toxins are marked with a sign and a chemical symbol. „Cd“ = cadmium, „Hg“ = mercury, „Pb“ = lead.

1. battery contains cadmium
2. battery contains mercury
3. battery contains lead

WARRANTY

The regular warranty period is 5 years and begins on the day of purchase. You can consult the full warranty terms as well as information on extending the warranty period and details of our services at www.bresser.de/warranty_terms.

Bresser GmbH
Gutenbergstraße 2 46414 Rhede · Germany www.bresser.de

Bresser UK Ltd.
Suite 3G, Eden House, Enterprise Way Edenbridge, Kent TN8 6HF · Great Britain www.bresseruk.comIrrtümer und technische Änderungen vorbehalten. · Errors and technical changes reserved. Manual_9638100_Mobile-Power-Station_de-en_BRESSER_v032023a

References

• Bresser | Startseite | Expand Your Horizon mit BRESSER
• index · powered by h5ai 0.26.1 (http://larsjung.de/h5ai/)
• Bresser UK | Home page | Online optics and electronics to explore the world around us.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>