B K Licht BKL1562 RGB USB LED Strip Instruction Manual

: June 8, 2024
: B K Licht

Table of Contents

Mounting instructions
Safety directions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

B K Licht BKL1562 RGB USB LED Strip

Instruction

Mounting instructions

Safety directions

Please read this information carefully before installing or using this product. Please keep this user manual for further reference.

The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the light.
Maintenance of the lights is limited to the surfaces. For electrical safety reasons, this product must not be cleaned with water or other liquids. Use only a dry, lint-free cloth for cleaning.
When mounting, ensure that the attachment material is suitable for the subsurface and that this surface is capable of carrying the weight of the fixture. The manufacturer is not liable for improper installation of the item on the relevant subsurface.
The symbol of the crossed-out garbage can on the product or the packaging means that the product must not be disposed with ordinary household waste. At the end of its useful life, the product must be returned to a point of acceptance for the recycling of electric and electronic device. Please ask your local municipality for the point of acceptance.
Do not install the light on a damp or conductive subsurface.
Never use the light if you notice any damage. Please make sure that no cables get damaged during the installation work.
The lights have a protection class rating of “IP20“ and are solely intended for indoor use only of private households.
Do not look directly into the light source (illuminant, LED, etc.).
This light source is not suitable as room lighting but is intended for use as a decorative light.
LED colour deviation when using different chargers may occur. The light colour and luminous strength of the LED’s can also change as a result of life span level from the lamp.
Do not attempt to switch on the adaptable light tape whilst it is rolled up or still in its packaging.
The flexible LED tape can be shortened with a scissor every “10“ cm at the marked positions.
The remaining section cannot be electrically connected again after shortening and can therefore no longer be used.
To assemble the components with adhesive surfaces, remove the protection foil on the rear side and press the component firmly on the intended position. Make sure that the assembly location is clean, dry and free of grease.
Please observe that only the protective film on tape is removed before applying the parts with double-sided tape.
No chemical cleaners such as glass cleaners are to be used on the surfaces, otherwise a firm join or adhesion cannot be guaranteed.
This article is not suitable for use with dimmable electric circuits. It can be controlled using the accompanying remote control.
The infrared diode of the receiver must be placed in a position that enables to address it with the remote control without any obstacles between the two components.
Remote control functions: ”A” → Switch ON and OFF / ”B” → Select color of light / ”C” → Select lighting effects / “D“ → 1. A selected light colour can be dimmed or brightened using this controller. 2. This controller will change the speed of the selected lighting effect.
The integrated USB plug does not have data function and is only provided to connect the device to the power supply.
Batteries or rechargeable batteries are not permitted in domestic waste. They must be decontaminated according to the regulations of the responsible authorities as hazardous waste. Use the available collection points.