circa LIGHTING RL 5131 Roark 30 Inch Modular Ring Chandelier Instruction Manual
- June 4, 2024
- circa LIGHTING
Table of Contents
circa LIGHTING RL 5131 Roark 30 Inch Modular Ring Chandelier Instruction Manual
Roark 30″ Modular Ring Chandelier
Item # RL 5131
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Slotted Screwdriver
Slip Joint Pliers
Measuring Tape
Wire Strippers
Chain Pliers Wire Cutters
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove collar loop (C) from chain (F) by removing quick link (D).
-
Install mounting plate (B) to junction box and secure with mounting screws (K).
-
Secure collar loop (C) to mounting plate (B) using pliers to tighten locknut.
-
Install canopy (E) to collar loop (C) by securing with collar ring (J).
-
Attach hanging rods (H) to hooks on fixture body (I) and to the bottom hooks on fixture loop (G) using quick links. NOTE: Fixture can be installed with bulbs up or down.
-
Determine desired overall length, and amount of chain (F) needed. Shorten chain using chain pliers. (Keep extra chain)
-
Attach chain (F) to collar loop (C) and to fixture loop (G) using quick links (D).
-
Thread fixture wire and ground wire through chain (E). NOTE: When you reach the collar loop (C), ensure there is no tension on the wires. Cut excess wires, being sure to leave about 12″ to reach the junction box.
-
Separate two sides of molded wire, and strip insulation on each 5/8″.
-
Loosen collar ring (J) and let canopy (E) slip down chain (E) carefully.
-
Twist all fixture wires together. Slip through center hole of collar loop (C).
NOTE: Untwist wires and separate to prepare for connection. -
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
-
Connect fixture neutral wire (ribbed) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (smooth with markings) to the supply hot wire (usually black) using wire nut (A). CAUTION: Do not reverse the hot and neutral connections.
-
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install canopy (E) to collar loop (C) by securing with collar ring (J). 18. Insert bulbs into the sockets.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>