HEYPOWER TM001 Bone Conduction Speaker User Manual

HEYPOWER TM001 Bone Conduction Speaker User Manual

Product Disruption

1. Short press :VOL-/
   Short press: About 2 seconds: Disconnect Bluetooth

2. Short press: VOL+
   Short press: About 2 seconds: ON/OFF

3. Hanging rope hole

4. Charging port(Type C):5V1~2A

5. Indicator light: The blue light remains on when turned on (connected),
   Flashing red and blue alternately (unpaired state)
   The shutdown light is off;
   The charging status red light flashes (if the device is turned on and in playback mode, the red light will also light up separately)
   The red light will turn off when fully charged (if in the startup playback state, the blue light will resume working).

Operation instruction

Single Speaker Operation:

1. Long-press the power key until you hear the voice indicate “Power on.”
2. Turn on your phone’s Bluetooth, search for “Hum Bird Speaker” and palr.
3. Once connected, place Hum Bird Speaker on surface of any hollow object to play.

Double Speaker Stereo Operation (TWS):
Turn on both speakers in same time, 3-5 seconds, the speakers can paired each other automatically.

FM Function:

1. Short-press the Power key to switch from Bluetooth mode to FM mode
2. Long-press the Function key to search FM channels automatically.
3. After searching finished, triple click the Function key to switch radio station.
4. FM Volume control: single click go down, double click go up, triple click-switch to next stored station.
   *(Suggost to use FM function ourdoors, plug in USB cable as well.)**

Charging:
The charging cable can be used with regular USB 5V charger, Car USB charger… but it is not compatible with fast charger, especially with 9V 12V and other chargers whose output voltage is higher than 5 Voltage.

LED indicator:
When charging, the red LED will be lighted, Once charged, the red LED will be off.
When Bluetooth mode turned on, and the LED blue light will blink. Once paired/connected,  the blue light will be always on.

Tips
Before starting peal off the protect film of the stick pad which on the bottom of speaker. then place the speaker onto the surface of any hollow subjects.
Using mall/pin lo assist lanyard through the hole

Any queries,please contact us:hello@bocoice.com

Note:

1. After several trial, sticky pad will be not sticky enough, you can clean the dust with wet cloth, then it can back to well sticky. Double side tape will be useful also.
2. If you play music at maximum volume, the speaker itself will get hot, which is normal. When the volume is lowered little, the speaker will return to normal temperature.

FCC Warning:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio / TV technician for help.

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>