PROMETER OE-BLD7751-EA Hygromaster 2 Material Hygrometer User Manual
- June 4, 2024
- PROMETER
Table of Contents
PROMETER OE-BLD7751-EA Hygromaster 2 Material Hygrometer
Auto upgrade through Protimeter software
Equipment required:
- Windows PC/Laptop with Protimeter software installed:
- USB cable – Type Micro USB MMS3 and Mini USB for MMS2 and Hygromaster 2
Procedure:
-
Install Protimeter software The software can be found here
-
Installation instructions can be found at the end of this guide.
-
Once installed double-click on the Protimeter.exe shortcut available on the desktop or click on the Protimeter.exe option from the windows menu to run the Protimeter software.
-
Make sure that the batteries are properly placed in meter.
-
Connect the meter to PC/Laptop through micro/mini USB cable.
-
Turn on the meter device and the software shall detect the device.
In case the device is not identified, check for the below:- MMS3 configuration – Settings -> USB connection -> PC software (Default)
- Replace the cable
- Connect to a different USB port on your PC/Laptop
-
Once the device is identified, you will be prompted to download the data. Click on “NO”.
-
Auto new firmware prompt: If a firmware upgrade from the one in the connected device is available, then an auto-prompt to download the same will be shown.
-
Click on “YES” to upgrade the device firmware.
-
The download progress will be shown and the meter device will enter the Bootloader mode.
-
The Upgrade utility will now be prompted. Click on “Update”.
-
The firmware upgrade progress can be seen as below:
-
On successful firmware upgrade, the below popup will be displayed. Click on “OK”.
-
Manual latest firmware check: In case you are not notified about new firmware availability automatically or you missed clicking on “YES” in reference to step 6, click on “Upgrade firmware” option.
-
A dialog with current firmware version in the device and the latest firmware version availableis shown. Click on “Confirm” if you want to upgrade the firmware.
-
Follow steps 7 to 11.
Appendix (Protimeter software installation guide)
-
Click on the below link to download the latest Protimeter software
The software can be found here -
Save and unzip the setup files
- Click on “Save”.
The setup zip file will be downloaded into the “Downloads” folder:
- Click on “Save”.
-
Install the software
-
Make sure that the new software setup folder is unzipped.
-
Double-click on the “ProtimeterSetup” installer.
-
Refer the below pictures for installation:
-
The software is installed and ready to be used.
-