SAMSUNG RS625 Series Fridge with Ice Maker User Manual

SAMSUNG RS625 Series Fridge with Ice Maker

Product Information

The refrigerator comes in normal and dispenser-featured models. The actual appearance may vary based on the model and country.

Key Features:

• Freezer shelves
• Multipurpose freezer bin
• Refrigerator bin
• Refrigerator shelves
• Multipurpose drawer
• Ice maker bucket (Dispenser models only)
• Water tank (Applicable models only)
• Wine rack (Applicable models only)
• Dairy bin
• Deodorizer filter

Installation

Step-by-Step Installation

Step 1: Select a Site

Ensure proper space requirements for installation.

Step 2: Spacing (Applicable Models Only)

1. Open the door and locate the provided spacer.
2. Unpack the spacer and attach it to the rear of the refrigerator to ventilate air to the rear wall.

Step 3: Adjust the Levelling Feet

To adjust the height of the freezer side, turn the leveller clockwise to raise or counter clockwise to lower. Repeat for the fridge side.

Step 4: Connect the Water Dispenser Line (Applicable Models Only)

Assemble the water pipe line using couplers and connect to the cold water tap.

Step 5: Connect to a Water Source (Applicable Models Only)

Connect the cold water pipe to the water filtering hose by following Water Line Installation instructions. Use new hose-sets supplied with the appliance.

FAQ

Q: Can I change the position of the freezer shelves?

A: For all models, do not change the position of the freezer shelves as it may damage the product when closing the door.

Installation

Follow these instructions carefully to ensure a proper installation of this refrigerator and to prevent accidents before using it.

WARNING

• Use the refrigerator only for its intended purpose as described in this manual.
• Any servicing must be performed by a qualified technician.
• Dispose of the product packaging material in compliance with the local regulations.
• To prevent electric shock, unplug the power cord before servicing or replacements.

Refrigerator at a glance

The actual appearance of your refrigerator may differ, depending on the model and the country.

Normal models

Dispenser-featured models

1. Freezer shelves
2. Multipurpose freezer bin
3. Dried food and meat storage drawer
4. Refrigerator bin
5. Refrigerator shelves
6. Vegetable drawer
7. Multipurpose drawer
8. Ice maker bucket **
9. Water tank *
10. Wine rack
11. Dairy bin
12. Lower freezer bin *
13. Lower refrigerator bin
14. Deodorizer filter 15 Freezer bin

• Applicable models only
• ** Dispenser models only

NOTE

• The design of the egg container may differ with the model.

CAUTION

For all models, do not change the position of the freezer shelves. Freezer shelves have different lengths, and if you change the position, you may damage the product when closing the door.

Step-by-step installation

STEP 1 Select a site

Site requirements:

• Solid, level surface without carpeting or flooring that may obstruct ventilation
• Away from direct sunlight
• Adequate room for opening and closing the door
• Away from a heat source
• Room for maintenance and servicing
• Temperature range: between 5 °C and 43 °C

Clearance

See the pictures and table below for space requirements for installation.

1. more than 50 mm recommended
2. 165°
3. 165°
4. 564 mm
5. 1726 mm
6. 610 mm
7. 908 mm
8. 29 mm
9. 1165 mm

NOTE

The measurements in the above table may differ, depending on the measuring method.

STEP 2 Spacing (applicable models only)

1. Open the door and locate the provided spacer.
2. Unpack the spacer and attach it to the rear of the refrigerator as shown. It helps ventilate air to the rear wall and save power consumption.

STEP 3 Adjust the leveling feet

CAUTION

• The refrigerator must be levelled on a flat, solid floor. Failing to do so can cause damage to the refrigerator or physical injury.
• Levelling must be performed with an empty refrigerator. Make sure no food items remain inside the refrigerator.
• For safety reasons, adjust the front side a little higher than the rear side.

The refrigerator can be levelled using the front legs that have a special screw (leveler) for leveling purposes. Use a flat-head screwdriver for leveling.

To adjust the height of the freezer side:
Insert a flat-head screwdriver into the leveller of the freezer-side front leg. Turn the leveller clockwise to raise, or turn it counterclockwise to lower.
To adjust the height of the fridge side:
Insert a flat-head screwdriver into the leveller of the fridge-side front leg. Turn the leveller clockwise to raise, or turn it counter-clockwise to lower

Installation (external dispenser line)

1. Assemble the water pipe line using couplers.
2. Close the main water supply, and then close the water tap.
3. Connect the coupler to the cold water tap.

CAUTION

• Make sure you connect the coupler to the cold water tap. Connection to the hot water tap may cause the water filter to be clogged and fail to operate normally.
• The warranty for your refrigerator does not cover the water line installation. The water line installation will be performed at your own costs unless the installation fee is included in the retailer’s price.
• Samsung takes no responsibility for the water line installation. If water leaks occur, contact the installer of the water line.
• The water line must be repaired by a qualified professional. If you encounter a waterleak, contact a local Samsung service centre or the installer of the water line

STEP 5 Connect to a water source (applicable models only)

CAUTION

• The water line must be connected by a qualified technician.
• The warranty for your refrigerator does not cover the water line installation. The water line installation will be performed at your own costs unless the installation fee is included in the retailer’s price.
• Samsung takes no responsibility for the water line installation. If water leaks occur, contact the installer of the water line.

To connect the cold water pipe to the water filtering hose

CAUTION

Make sure the water filtering hose is connected to a cold, potable water source pipe. Connecting to the hot water pipe may cause the water filter to malfunction.

1. Shut off the water supply by closing the main water valve.
2. Locate the cold, potable water pipe (1).
3. Follow the Water Line Installation to connect to the water pipe.

• A. Close Main Water pipe
• B. No gap

NOTE

New hose-sets supplied with the appliance are to be used and old hose-sets should not be reused.

To connect the water filtering hose to the water line

1. Loosen and remove the compression nut (a) from the water line of the refrigerator, and insert it to the water filtering hose.
2. Tighten up the compression nut (a) to connect the water filtering hose and the water line.
3. Open the main water valve and check for any leaks.
4. If there are no leaks, dispense about 10 litres of water or dispense the water for 6 – 7 minutes before actually using the refrigerator to remove impurities inside the water filtering system.
   • A. Water Line from unit
   • B. Water Line from Kit
5. Secure the water line to a sink or a wall using a clip.

CAUTION

• Do not tighten the water line excessively. Make sure the water line is not bent, pinched, or squashed.
• Do not mount the water line on any part of the refrigerator. This may damage the refrigerator.

NOTE

If you have to relocate the refrigerator after connecting the water line, make sure the joined section of the water line must is straight.

To repair the water line

CAUTION

The water line must be repaired by a qualified professional. If you encounter a water leak, contact a local Samsung service centre or the installer of the water line. Reverse osmosis water filtration system The water pressure of the water supply system to a reverse osmosis water filtration system must be between 206 kPa (30 psi) and 861 kPa (125 psi). The water pressure of the reverse osmosis water filtration system to the refrigerator’s cold water line must be at least 206 kPa (30 psi). If the water pressure is below the specified:

• Check if the sediment filter in the reverse osmosis system is blocked. Replace the filter \if necessary.
• Refill the water tank in the reverse osmosis system with water.
• If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter. For more information or servicing, contact a licensed plumbing professional.

Ordering a new filter

To purchase a new water filter (part type: HAFEX/EXP), contact a local Samsung service centre.

To mount the water filter into place

1. Attach the lock clips (x2) to appropriate positions under the sink, for instance. Then, fix the lock clips firmly using screws.
2. Insert the water filter into the upper and lower clips in the correct direction.\ Make sure to check the vertical direction of the water filter.

NOTE

If the filter is installed horizontally, water may remain in the filter. Therefore, vertical installation is recommended.

CAUTION

Do not mount the water filter on any part of the refrigerator. This may damage the refrigerator.

STEP 6 Initial settings

By completing the following steps, the refrigerator should be fully functioning.

1. Plug the power cord into the wall socket to turn the refrigerator on.
2. Open the door, and check if the interior light lights up.
3. Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be slightly chilled, and the motor will run smoothly.
4. Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready for use.

STEP 7 Final check

When installation is complete, confirm that:

• The refrigerator is plugged into an electrical outlet and grounded properly.
• The refrigerator is installed on a flat, level surface with a reasonable clearance from the wall or the cabinet.
• The refrigerator is level and is sitting firmly on the floor.
• The door opens and closes freely, and the interior light turns on automatically when you open the door.

SmartThings

Installation

Visit the Google Play Store, Galaxy Apps, or Apple App Store and search for “SmartThings”. Download and install the SmartThings app provided by Samsung Electronics to your smart device.

NOTE

• The supporting software version of the SmartThings app is subject to change according to the OS-supporting policy the manufacturer provides. In addition, as for the SmartThings app or the functions that the app supports, the new application update policy on the existing OS version can be suspended due to usability or security reasons.
• The SmartThings app is subject to change without notice to improve usability or performance. As the mobile phone OS version is updated every year, the SmartThings is also updated continually according to the latest OS. If you have enquiries regarding the items mentioned above, please contact us at st.service@samsung.com
• Recommended encryption systems include WPA/TKIP and WPA2/AES. Any newer or non-standard Wi-Fi authentication protocols are not supported.
• Wireless networks may be affected by the surrounding wireless communication environment.
• If your Internet service provider has \registered the MAC address of your PC or modem for identification, your Samsung Smart Refrigerator may fail to connect to the Internet. If this happens, contact your Internet service provider for technical assistance.
• The firewall settings of your network system may prevent your Samsung Smart Refrigerator from accessing the Internet. Contact your Internet service provider for technical assistance. If this symptom continues, contact a local Samsung service center or retailer.
• To configure the wireless access point (AP) settings, see the user manual of the AP (router).
• Samsung Smart Refrigerators support IEEE 802.11 b/g/n (2.4 GHz) protocols.(IEEE 802.11 n is recommended.)
• Unauthorized Wi-Fi wireless routers may fail to connect to applicable Samsung Smart Refrigerators.

Samsung account

You are required to register your Samsung account to use the app. If you don’t have a Samsung account, follow the app’s onscreen instructions to create a free Samsung account.

Getting started

Turn on the device you want to connect, open the SmartThings app on your phone, and then follow the instructions below. If a pop-up appears saying that a new device has been found, tap ADD NOW. If a pop-up doesn’t appear, tap the

• button, and then select the device you want to connect from the list of available devices. If your device isn’t in the list of available devices, tap Supported Devices, select the device type (Refrigerator), and then select the specific device model. Follow the instructions in the app to set up your device. Once setup is complete, yourrefrigerator will appear as a “card” on your Devices screen.

SmartThings app

Integrated control

You can monitor and control your refrigerator at home and on the go.

• Tap the refrigerator icon on the SmartThings Dashboard or tap the Devices icon at the bottom of the dashboard, and then tap the refrigerator “card” to open the Refrigerator page.
• Check the operation status or notifications related to your refrigerator, and then change options or settings if necessary.

NOTE

Some options or settings of the refrigerator may not be available for remote control.

References

• Samsung US | Mobile | TV | Home Electronics | Home Appliances | Samsung US

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>