Lightspeed QS0592US01-7 Topcat Instructional Audio System User Guide
- June 3, 2024
- lightspeed
Table of Contents
Lightspeed QS0592US01-7 Topcat Instructional Audio System
CONNECT POWER TO THE 975
Connect the power supply to the 975 and plug the cord into an AC outlet.
The 975 will power on and the power light will glow.
USING THE FLEXMIKE
USING THE SHAREMIKE
Remove microphone from charger and press the mute button to begin speaking.
CHARGE MICROPHONES NIGHTLY
Place the microphones into the cradle charger. The power status light will
glow red when it is charging.
It takes about 5-6 hours to fully charge the microphone battery.
When charging is complete, the power status light will glow green.
USING A WIRELESS AUDIO LINK
You can connect your 2nd (or 3rd) microphone to your computer’s USB port to
enable a wireless 2-way audio link.
SEND AUDIO FROM THE COMPUTER to the 975 to ensure all audio from the computer (videos, video conferencing, audiobooks, music, etc) can be played through the Lightspeed 975 system and speakers.
SEND AUDIO TO THE COMPUTER from the 975 to ensure the teacher’s Flexmike and any student microphones are clearly picked up by a video conferencing solution.
PAIRING MICROPHONES TO THE 975
Your system is shipped with microphones and base units pre-paired for quick
and easy use. If you ever need to pair new components, follow this pairing
process:
PLEASE NOTE: Microphones should be out of the charger while pairing.
-
POINT MICROPHONES AT 975
From a powered off state, point the IR transmitter lens toward the base unit (for Sharemike, the transmitter lens is located on the back of the microphone).
-
PRESS AND HOLD POWER BUTTON
Press and hold the power button for 5 seconds until the Mic 1 and Mic 2 lights start flashing, then release the button and let the pairing process finish. -
CONFIRM STATUS
The status light on the 975 will light up indicating the pairing process is complete. The Mic 1 or Mic 2 light on the microphone will stay illuminated.
If the microphone is out of range, it will automatically shut off after 30 minutes of trying to reconnect. Once you are back in the classroom, or in range, simply press and hold the power button on the microphone to power it up.
INSTALLATION GUIDE
For installation instructions, go to www.lightspeed-tek.com/support/975
-installation-guide/ (or scan the QR code).
USER MANUAL
For complete operating instructions, go to www.lightspeed-
tek.com/975-usermanual (or scan
the QR code).
References
- 975 User Manual | Lightspeed Instructional Audio Solutions
- 975 Installation Guide | Lightspeed Instructional Audio Solutions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>