lightspeed Mobile PA Portable Audio System User Guide

June 4, 2024
lightspeed

lightspeed Mobile PA Portable Audio System

lightspeed Mobile PA Portable Audio System

PLUG IN POWER SUPPLY TO THE MOBILE PA BEFORE FIRST USE

Mobile PA should be charged for at least 4-5 hours before first time use in order to achieve a full day use. Connect the AC power cord into the DC power supply. Insert the connector into the Mobile PA and plug the power cord into an electrical outlet. Mobile PA automatically powers on and the white Power light on the side panel will glow.

CHARGE THE MICROPHONES

Place the microphones into the integrated cradle charger. The microphone battery status light will glow red when it is charging. When charging complete, the battery status light will glow green.

lightspeed Mobile PA Portable Audio System 1

USING THE FLEXMIKE

lightspeed Mobile PA Portable Audio System 2

USING THE SHAREMIKE

lightspeed Mobile PA Portable Audio System 3

CHARGE MICROPHONES NIGHTLY

Place the microphones into the integrated cradle charger. The power status light will glow red when it is charging. When charging is complete, the power status light will glow green. It takes about 4-5 hours to fully charge the microphone battery.
Note: Microphones will only charge when Mobile PA is plugged into AC power.

lightspeed Mobile PA Portable Audio System 4

PAIRING MICROPHONES TO MOBILE PA

Your system is shipped with microphones and Mobile PA paired for quick and easy use. If you ever need to pair new components, follow this pairing process: Microphones should be out of the charger while pairing.

POINT MICROPHONES AT MOBILE PA
From a powered off state, point the IR transmitter lens toward Mobile PA (for Sharemike, the transmitter lens is located on the back of the microphone).

PRESS AND HOLD POWER BUTTON
Press and hold the power button for 5 seconds until the Mic 1 and Mic 2 lights start flashing, then release the button and let the pairing process finish. Status light on Mobile PA will flash blue/white in pairing mode.

CONFIRM STATUS
The status light on Mobile PA will glow blue indicating the pairing process is complete. The Mic 1 or Mic 2 light on the microphone will stay illuminated. If the microphone is out of range, it will automatically shut off after 30 minutes of trying to reconnect. Once you are back in the classroom, or in range, simply press the power button on the microphone to power it up.

lightspeed Mobile PA Portable Audio System 5

PAIRING PERSONAL DEVICE TO MOBILE PA BLUETOOTH

  • SET UP YOUR OTHER AUDIO SOURCE
    On your personal device, make sure your Bluetooth setting is on and in the search mode.

  • PUT MOBILE PA IN PAIRING MODE
    Press and hold Audio Input Volume Selector button for 3-5 seconds until status light starts blinking blue to be discovered by your personal device.

  • PAIR TO YOUR DEVICE
    Select Lightspeed_MPA on your personal device and complete pairing process.

lightspeed Mobile PA Portable Audio System 6

For complete operating instructions, go to www.lightspeed-tek.com/mobilepa-usermanual (or scan the 2D barcode).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals