Sofirn SP60 Thrower Flashlight Instruction Manual
- August 16, 2024
- Sofirn
Table of Contents
Sofirn SP60 Thrower Flashlight
Thank You
Thank you for purchasing Sofirn products.
Contact us@sofirnlight.com or
eu@sofirnlight.com if you need assistance.
Sofirn SP60 is a powerful flashlight for indoor use and various outdoor activities like camping, hiking, fishing, or hunting. It uses two 21700 batteries and a super bright LED with up to 6800 lumens. This flashlight as a thrower has a longer throw and higher output than IF22A. It can also be used as a powerbank to charge other devices. SP60 offers reliable illumination and is readily available for different situations.
ANSI/NEMA FL1 Chart
Mode| Moonlight| Eco| Low| Medium| High|
Turbo
---|---|---|---|---|---|---
Luminous
Flux [lm]
| 1| 50| 450| 1000| 3000| 6800
Runtime [h]| 480| 60| 9| 3.5| 2| 1.5
Beam Distance [m]| 18| 91| 228| 374| 631| 915
Peak Intensity [cd]| 80| 2075| 13000| 35000| 99500| 209500
Impact Resistance| 1m / 3.28 ft.
Water Resistance| IP68 (not for diving)
Notes
The above mentioned parameters are based on tests according to international flashlight testing standards (ANSI/NEMA FL1) using two 4,000mAh 21700 Li-ion batteries in our laboratory. Results may vary with different battery or under different environmental conditions.
Specifications
- Emitter: a powerful led with a lifespan of 50,000 hours
- Operating voltage: 6V – 8.4V
- Battery options: 2x 21700 rechargeable lithium-ion batteries
- Dimension: 258.5mm (length) × 70mm (head diameter)
- Weight: 418 grams (without battery)
- Flashlight body: Aerospace grade 6061 grade aluminum alloy.
- Toughened mineral glass lens
- Water resistance i.a.w. IP68
- Mode Memory: memorizes the last brightness level used in the general modes (Eco/Low/Med/High).
- The flashlight supports 5V/3A, 9V/2A and 12V/1.5A fast charging and 5V/2A standard charging.
- Reverse polarity protection from improper battery installation.
- Low voltage warning: When the battery voltage is lower than 5.8V, the LED indicator will start to flash red. Please recharge the flashlight or insert new batteries.
- Low voltage protection: It turns off automatically if the voltage gets too low. Please recharge the battery or insert new batteries.
- Advanced Temperature Regulation (ATR) technology: When the flashlight is turned on for a certain period of time, the temperature will drop.
Battery Specifications
| Battery Type | Dimension & Quantity |
|---|---|
| Rechargeable lithium-ion battery | 21700 x 2 |
Battery Installation
Before first use, please unscrew the tail cap and remove the insulating sticker. If the battery needs to be replaced, please make sure that the positive end of the new battery faces the flashlight’s head when you put the battery in.
Battery Level Indicator
The indicator shows the power status for 5 seconds after turning SP60 on.
Green = remaining battery power is good.
Red = remaining battery power is poor
Flashing Red = critical power (less than 30%), please replace or recharge
battery as soon as possible.
When the flashlight is worked as a portable charger:
No LED indicator lights up during the progress of charging digital devices. A
flashing red LED indicates a low battery level.
Charging
SP60 offers a USB type-C charging port for convenient charging. It takes
approximately 4 hours to fully charge the flashlight with a 5V/2A charger (not
included), and 2 hours with a 5V/3A, 9V/2A, or 12V/1.5A charger (not
included).
While charging, the side switch indicator flashes in red. It turns green when
it’s fully charged. Charging the flashlight will disable lock mode. You can
only access moonlight and low brightness settings while charging.
Operation Instructions
STEPPED RAMPING:
ON/OFF : One-click the switch to turn the light on/off.
CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the
side switch and it will start from the present brightness level, automatically
cycle through Eco, Low, Medium, and High mode. The mode is selected when the
side switch has been released. (Please note: moonlight, turbo and strobe are
not in the automatic cycle).
DIRECT ACCESS TO TURBO MODE : When the flashlight is on/off (not in lock
mode), quickly double-click the switch to activate Turbo mode. Double-click
again to cycle Moonlight-Turbo
DIRECT ACCESS TO STROBE MODE : When the flashlight is on/off (not in lock
mode), quickly triple-click the switch to enter into Strobe. Then double-click
the switch to cycle through Strobe-SOS-Beacon, one-click the switch to return
to previously used mode.
DIRECT ACCESS TO MOONLIGHT MODE : When the flashlight is off, hold the
switch for over one second to enter into Moonlight. Then one click to turn off
or hold the switch again to enter Low cycling through the general brightness
settings.
LOCK/UNLOCK : When the flashlight is off, 4 fast clicks on the switch to
lock the flashlight. LED blinks twice to signal that the light is in lock
mode. Fast two, three or four clicks on the switch to unlock it returning to
previously used mode. You can only access to momentary-moonlight by holding
the switch while being locked. LED will flash twice to indicate the flashlight
is in lock mode when you try other operations.
AUTOMATIC LOCKOUT: When the flashlight turns off after 3 minutes, it will
automatically enter lockout mode.
SMOOTH RAMPING
ON/OFF : Single click the switch to turn the light
RAMPING UP/DOWN : Hold and press the switch to change brightness
sleeplessly.
Ramping changes its direction when the switch is being pressed again within
1.5 seconds. The LED flashes once when it reaches the lowest or highest end of
the ramp. Other operations are the same as stepped ramp.
SWITCH BETWEEN STEPPED RAMPING AND SMOOTH RAMPING
While the flashlight is on, fast four clicks to switch between stepped ramping
and smooth ramping. Emitter blinks twice to signal that the switch is
completed.
Safety Instructions
- SP60 is a powerful flashlight. Never point it directly at a person, animal or moving vehicles. Doing so could cause retinal damage. Please do not allow children to play with it. Strobe mode may cause seizure in persons with photosensitive epilepsy.
- Operating SP60 for a long time in high powered modes will quickly heat up the flashlight. This is normal.
- Pay close attention to the proper installation of the battery. Always check that the positive end of the battery faces the flashlight’s head.
- Please unscrew the tailcap half a turn to avoid unwanted activation during transport. It also prevents the battery from draining while the flashlight is in standby.
- Avoid hitting or dropping the flashlight.
Troubleshooting and Maintenance
- Disassembling the sealed head can damage the flashlight and voids the warranty.
- Sofirn, Ltd. recommends using high-quality brand batteries. Damage by battery leakage voids the warranty.
- Remove the battery if the flashlight will not be used for an extended period of time.
- To prevent self-discharge or accidental activation during storage or transportation, unscrew the tailcap by half a turn or remove the battery.
- Every 6 months threads should be wiped with a clean cloth followed by a thin layer of silicone grease.
- To maintain a proper level of waterproofness, replace worn-out o-rings with an approved spare.
- Troubleshooting: Clean battery contacts regularly as dirty contacts may impair the performance of the flashlight. If you experience problems (flicker, shine intermittently or failure turn on) the following root causes and solutions should be tried:
Reason A : The battery needs a replacement.
Solution: Replace the battery with an approved type of a fully charged battery.
Reason B : Threads, PCB board contact or other contacts are dirty.
Solutions : Please clean the contact points with a cotton swab soaked in rubbing alcohol.
Reason C : The flashlight will not turn on upon first use.
Solution : Please do not forget to remove the insulation sticker from the battery on first use.
If the above methods do not work please refer to the warranty policy before contacting your authorized distributor.
Customer Support
Sofirn Limited:
Tel: +86-755-23440047
Web: www.sofirnlight.com
E-mail: us@sofirnlight.com |
wholesale@sofirn.cn
Fax: +86-755-23440141
eu@sofirnlight.com
Please contact us if you have any questions.
If your product is defective please contact us for replacement within warranty
period.
Manufacturer : Shenzhenshi Jinba Technology Co.,Ltd
Address: 1/F to 9/F, 1st Building, NO.110 Tenglong Industrial Center,
Guanlan Street, Longhua New District, Shenzhen 518000, China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>