HIKVISION DS-PDD15AM-EG2 15m Dual-Tech Wireless Detector User Manual

: June 3, 2024
: Hikvision

Table of Contents

Appearance
Installation
The 15 m Lens
Resistor Wiring
Connection Type
Powering on
Anti-Masking Alarm
Anti-Cloaking Alarm
Specification
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HIKVISION DS-PDD15AM-EG2 15m Dual-Tech Wireless Detector User Manual

Appearance

Lens
LED Light Pipe
Lens Holder
PCB
Nut
Casing Screw

The Printed Circuit Board (PCB)

PIR Sensor
Block Block ON Block OFF
Anti-Masking Anti-Masking ON Anti-Masking OFF
MW Range Control
Microwave Module
Tamper Resistor Jumpers
Mask Resistor Jumpers
Terminals
Alarm Resistor Jumpers
Tamper Spring
LED LED ON LED OFF
Sensitivity Settings CLOAK AUTO

Installation

Screw Model: PA_3.5 ×25 (4 screws)
a. Ceiling Bracket Fitting
b. Wall Bracket Fitting
Note: Brackets are optional.

The 15 m Lens

a. Detection Range: 85.9°, 52 zones, 4 planes
b. Mouting Height:
Mounting height range from 1.8 m to 2.4 m.
The recommended mounting height is 2.2 m.
c. Microwave Range Control:
Max: 15 m Medium: 0 to 10 m Min: Off

Resistor Wiring

Relay Status

	Normal	Alarm	Mask	Fault
Alarm Relay	Close	Open	Open	Close
Mask Relay	Close	Close	Open	Open

The detector has two method for resistor wiring:

Using jumpers to select the End of Line resistance (Control panel dependent) on the ALARM/TAMPER/MASK pins.
Select an resistance (Control panel dependent), and add the resistor to

ALARM/TAMPER/MASK wiring ports of the detector.
a. Alarm Resistance: 1K, 2K2, 4K7, 5K6, 6K8
b. Tamper Resistance: 1K, 2K2, 4K7, 5K6
c. Mask Resistance: 1K, 2K2, 6K8

Connection Type

a. Normally Closed
b. Singe End of Line Wiring
c. Double End of Line Wiring
d. Triple End of Line Wiring

Powering on

After powering on, the indicator flashes rapidly. Once the detector self test is completed, the LED indicator will go out until the detector detects movement.

Anti-Masking Alarm

Anti-Cloaking Alarm

Specification

Detection Method	Passive Infrared, Microwave
Detection Range	15m
Detection Angle	85.9°
Detection Zones	52
Detectable Speed	0.3 2m/s
Sensitivity	Auto, Low
White Light Filter	6500lux
Microwave Frequency	24GHz (24.15~24.25GHz)
Digital Temperature Compensation	Support
Creep Zone Protection	Support
Digital Processing	Support
Sealed Optics	Support
Tamper Protection	Front
Anti-masking	Support
Anti-cloaking	Support
Anti-blocking	Support
Alarm Output	Normally Closed
LED Indicator	Green (PIR), Red (Microwave), Blue (Alarm)
Transmission Method	Wired
Power Supply	9 to 16 VDC
Typical Voltage	12 VDC
Power Consumption	25mA Max
Operation Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Storage Temperature	-20 °C to 60 °C (-4 °F to 140 °F)
Operation Humidity	10% to 90%
Dimension(W x H x D)	65.7 mm (2.59″) × 103.8 mm (4.09″) × 45.5 mm (1.79″)
Weight	100g
Mounting Height	1.8 m to 2.4 m
Mounting Method	Wall
Application Scenario	Indoor
Bracket	Optional wall & ceiling accessory

©2022 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved.
About this Manual
The Manual includes instructions for using and managing the Product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the Manual is subject to change, without notice, due to firmware updates or other reasons. Please find the latest version of this Manual at the Hikvision website (https://www.hikvision.com/).
Please use this Manual with the guidance and assistance of professionals trained in supporting the Product.

and other Hikvision’s trademarks and logos are the properties of Hikvision in various jurisdictions. Other trademarks and logos mentioned are the properties of their respective owners. Disclaimer

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS MANUAL AND THE PRODUCT DESCRIBED, WITH ITS HARDWARE, SOFTWARE AND FIRMWARE, ARE PROVIDED “AS IS” AND “WITH ALL FAULTS AND ERRORS”. HIKVISION MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS FOR A PARTICULAR PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT YOUR OWN RISK. IN NO EVENT WILL HIKVISION BE LIABLE TO YOU FOR ANY SPECIAL, CONSEQUENTIAL, INCIDENTAL, OR INDIRECT DAMAGES, INCLUDING, AMONG OTHERS, DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA, CORRUPTION OF SYSTEMS, OR LOSS OF DOCUMENTATION, WHETHER BASED ON BREACH OF CONTRACT, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSS.
YOU ACKNOWLEDGE THAT THE NATURE OF THE INTERNET PROVIDES FOR INHERENT SECURITY RISKS, AND HIKVISION SHALL NOT TAKE ANY RESPONSIBILITIES FOR ABNORMAL OPERATION, PRIVACY LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER-ATTACK, HACKER ATTACK, VIRUS INFECTION, OR OTHER INTERNET SECURITY RISKS; HOWEVER, HIKVISION WILL PROVIDE TIMELY TECHNICAL SUPPORT IF REQUIRED.
YOU AGREE TO USE THIS PRODUCT IN COMPLIANCE WITH ALL APPLICABLE LAWS, AND YOU ARE SOLELY RESPONSIBLE FOR ENSURING THAT YOUR USE CONFORMS TO THE APPLICABLE LAW. ESPECIALLY, YOU ARE RESPONSIBLE, FOR USING THIS PRODUCT IN A MANNER THAT DOES NOT INFRINGE ON THE RIGHTS OF THIRD PARTIES, INCLUDING WITHOUT LIMITATION, RIGHTS OF PUBLICITY, INTELLECTUAL PROPERTY RIGHTS, OR DATA PROTECTION AND OTHER PRIVACY RIGHTS.
YOU SHALL NOT USE THIS PRODUCT FOR ANY PROHIBITED END-USES, INCLUDING THE DEVELOPMENT OR PRODUCTION OF WEAPONS OF MASS DESTRUCTION, THE DEVELOPMENT OR PRODUCTION OF CHEMICAL OR BIOLOGICAL WEAPONS, ANY ACTIVITIES IN THE CONTEXT RELATED
TO ANY NUCLEAR EXPLOSIVE OR UNSAFE NUCLEAR FUEL-CYCLE, OR IN SUPPORT OF HUMAN RIGHTS ABUSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER PREVAILS.

This product and – if applicable – the supplied accessories too are marked with “CE” and comply therefore with the applicable harmonized European standards listed under the RE Directive 2014/53/EU, the EMC Directive 2014/30/EU, the RoHS Directive 2011/65/EU.
2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info

INSTALLATION CAUTION

The additional force shall be equal to three times the weight of the equipment but not less than 50N. The equipment and its associated mounting means shall remain secure during the installation. After the installation, the equipment, including any associated mounting plate, shall not be damaged.