ulinktech Ophelia GIII Instructions
- August 5, 2024
- ulinktech
Table of Contents
ulinktech Ophelia GIII
Product Usage Instructions
Connecting IoT Devices to Microsoft Azure Sphere Cloud
To connect your IoT devices to the Microsoft Azure Sphere cloud using the Ophelia GIII:
- Ensure the Ophelia GIII is powered on and properly connected to your network via Ethernet.
- Access the device management interface and configure the Azure Sphere cloud settings.
- Follow the on-screen prompts to establish a secure connection between your IoT devices and the cloud.
Utilizing Bluetooth 5.0 Features
The Ophelia GIII supports Bluetooth 5.0 for wireless connectivity. To utilize Bluetooth features:
- Enable Bluetooth on your IoT devices.
- Pair the devices with the Ophelia GIII using the appropriate settings.
- You can now exchange data wirelessly between the devices and the Ophelia GIII.
Data Storage and Backup
The Ophelia GIII offers SD storage and power backup for data integrity. To save data and ensure backup:
- Insert an SD card into the designated slot on the device.
- Configure data saving settings to automatically backup important information.
Ophelia GIII
The Ophelia GIII enables the secure connection of IoT devices to the Microsoft
Azure Sphere cloud
via Ethernet.
Specifications
-
WF-M620-RSD2 module
-
Northbound link:
– 10 Base-T/100 Base-TX Ethernet -
Southbound link:
– Bluetooth 5.0 -
Power loss detection
-
Power backup (>10s)
-
SD Storage
-
Power-down data saving
-
Protocol
– TCP/IP, Modbus, MQTT, HTTP, CoAP,HART -
3 LEDs:
– 3 programmable LEDs -
Micro-HDMI
– MCU programming and debugging port -
Input voltage: 9~36V
-
Dimensions: 95mm95mm25mm
-
Enclosure: Mountable, white
-
Operating temperature: -10 °C to 60 °C
Ports
- RJ45 Ethernet.
- Debug Port
- DC power supply.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FAQ
Q: What should I do if I encounter interference issues with the device?
A: If you experience interference, ensure that the device is not placed
near other electronic equipment that may cause disruptions.
Try adjusting the location of the Ophelia GIII to minimize interference.
Q: How can I reset the device to factory settings?
A: To reset the Ophelia GIII to factory settings, locate the reset button
on the device and hold it down for at least 10 seconds. The device will reboot
with default settings.