CRUX SWRNS-63M Radio Replacement with Steering Wheel Control Retention Owner’s Manual

: August 2, 2024
: CRUX

Table of Contents

PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM FOR AMPLIFIED VEHICLES:
DIP SWITCH SETTINGS:
VEHICLE APPLICATIONS:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CRUX SWRNS-63M Radio Replacement with Steering Wheel Control Retention Owner’s Manual

PRODUCT FEATURES:

Retains factory features in select Nissan vehicles while functioning with an aftermarket radio.
Pre-programmed to retain factory Medium Speed CAN-Data Bus Steering Wheel Controls
Includes antenna adapter.
Retains factory phone buttons.
Retains factory USB input.
Retains factory camera (not 360 panoramic camera).
Provides outputs for Reverse & parking brake.
Retains factory auxiliary input

PARTS INCLUDED:

SWRNS-63M MODULE

SWRNS-63M Harness

Antenna Adapter

SWC Cables

USB Retention Cable

INSTALLATION DIAGRAM FOR AMPLIFIED VEHICLES:

For Amplified Systems Please Do Not Cut RCA to get better audio quality ** Please see page 2 for note
For Non-Amplified systems please cut RCA , and mate colored wires to the appropriate aftermarket radio speaker wires

Right Front (+)
Right Front (-)
Left Front (+)
Left Front (-)
Right Rear (+)
Right Rear (-)
Left Rear (+)
Left Rear (-)
GRAY
GRAY/BLACK
WHITE
WHITE/BLACK
VIOLET
VIOLET/BLACK
GREEN
GREEN/BLACK

DIP SWITCH SETTINGS:

AFTERMARKET RADIO DIP SWITCH SETTINGS:

RADIO BRAND	DIP#:	1	2
Toto, Dual, Fahrenheit, Jensen, Kiamichi	OFF	ON	ON
Pioneer, Power Acoustic, Sound stream	OFF	ON	ON
Blaupunkt, Most off-brand Radio Alpine	OFF	ON	ON
Alpine	OFF	OFF	OFF
Clarion, Stinger	ON	ON	OFF
Kenwood	ON	ON	ON
JVC	ON	OFF	ON
Boss, Old Sony	ON	OFF	OFF
New Sony (with Carp lay)	OFF	ON	OFF

SWC MODULE\ DIP SWITCH

NOTE: For Toto, Blaupunkt, Dual, Fahrenheit, Kiamichi, Power Acoustic, Sound stream, and most off-brand radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.

4-PIN SWC CABLE
Use the proper 3.5MM to 4-Pin SWC cable for the aftermarket radio you are using.

OPTION A is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is attached) OPTION B is used for ATOTO, BLAUPUNKT, BOSS, DUAL, FARENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY, SOUNDSTREAM and Most Off-Brand Radios.

NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.

For aftermarket radios that have wires for SWC connections, cut off the 3.5mm plug on the Crux SWC Cable (option B) and connect the SWC wires as follows:

Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.

RED to SWC Key 1 WHITE to SWC Key 2 SHIELD to SWC Ground

VEHICLE APPLICATIONS:

NISSAN
2015 – 2016 Murano Base radio w/ Nav w/o Bose
NOTE: For base radio w/ display & Non-Nav use CRUX Part #SWRNS-63S

**NISSAN INFOTAINMENT WITH MAP AND CAMERA

NOTE:** Some SWC functions might not be retained for the following radio series:
Planet Audio P9900CPA, Jensen CAR 710, Atoto F7, and similar radios of these brands

Crux Interfacing Solutions • Chatsworth, CA 91311 phone: 818-609-9299 • fax: 818-996-8188 • www.cruxinterfacing.com