LANDMANN 23870 Series Fire Pit Instruction Manual

: July 30, 2024
: LANDMANN

Table of Contents

23870 Series Fire Pit
PARTS LIST
FIRE PIT ASSEMBLY INSTRUCTIONS
HELPFUL HINTS:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Landmann 23870
Owner’s Manual Find Your Landmann Fireplace Parts – Select From 49 Models
——– Manual continues below ——–

23870 Series Fire Pit

This Owner’s Manual is provided and hosted by Appliance Factory Parts.
Appliance Factory Parts
Experts in BBQ, Humidifier, & Appliance Parts
1-800-955-7075
Shop genuine replacement parts for Landmann 23870
Assembly and Use Instructions for Model:
23870 23871 23872 23873 23874 23875

PLEASE READ ALL RULES FOR SAFE OPERATION AND HELPFUL HINTS BEFORE USING.

READ FIRST!
RULES FOR THE FIREDANCE BEARS FIRE PIT SAFE OPERATION.

THIS OUTDOOR FIRE PIT IS FOR OUTDOOR USE ONLY!
USE ONLY ON BRICK, CONCRETE, STONE OR OTHER MASONRY SURFACES!
DO NOT USE ON LAWNS, WOODEN DECKS OR ASPHALT!
KEEP THE OUTDOOR FIRE PIT A MINIMUM OF 10 FT. AWAY FROM BUILDINGS, STRUCTURES, ANY FLAMMABLE ITEMS AND VEHICLES.
NEVER USE UNDER LOW HANGING TREE BRANCHES, TRELLIS, OVERHANGS OF ANY KIND INCLUDING COVERED PORCHES.
WARNING! NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START OR RESTART FIRES.
FOR LONGER PRODUCT LIFE, KEEP FIRES TO A RESPECTABLE SIZE, DO NOT OVERLOAD.
THE OUTDOOR FIRE PIT IS FOR ADULT USE ONLY.
DO NOT LEAVE UNATTENDED AT ANY TIME WHILE IN USE.
DO NOT MOVE THE FIRE PIT DURING USE.
DO NOT USE IN WINDY CONDITIONS!
DO NOT OVERLOAD OR USE FOR BURNING GARBAGE.
USE CAUTION WHEN TENDING THE FIRE, AS SURFACES WILL BECOME VERY HOT WHILE IN USE.
USE MITTENS OR GLOVES WITH THE POKER TO REMOVE THE SPARK GUARD, THE SPARK GUARD WILL BECOME VERY HOT!!
USE CAUTION WHEN REMOVING THE SPARK GUARD, AS HOT STEAM OR A FLARE UP COULD CAUSE BURNS.
BEFORE EACH USE MAKE SURE THE OUTDOOR FIRE PIT IS IN GOOD WORKING CONDITION.
USE CAUTION AFTER THE FIRE HAS BEEN EXTINGUISHED, SURFACES WILL REMAIN HOT FOR SOME TIME.
THE OUTDOOR FIRE PIT MUST BE COMPLETELY COOLED OFF AND ALL EMBERS MUST BE EXTINGUISHED BEFORE ANY COVER CAN BE USED.

PARTS LIST

When unpacking the ﬁre pit from the carton, make sure you ﬁnd and become familiar with all the parts listed below. Use caution as some parts may have sharp edges.

A
(1) SPARK GUARD B
(1) COOKING GRATE

C
(1) FIREBOWL DD
(3) RING SECTIONS M
(3) PINS J
(6) M6 x 25MM BOLTS
(BOLTS ARE PRE-ASSEMBLED TO RING) EE
(4) LEGS F
(1) MULTIPURPOSE POKER X
(8) M6 x 10MM BOLTS

Z
(8) M6 FLANGE HEXNUT

FIRE PIT ASSEMBLY INSTRUCTIONS

A Phillips or plain screwdriver and an adjustable wrench are needed for assembly.
STEP 1: ASSEMBLE THE LEGS
Take each of the (4) legs [ EE ] and assemble them to the ﬁrebowl [ C ] as shown using (8) 10MM bolts [ X ] and (8) hexnuts [ Z ].
Tighten securely with adjustable wrench.
STEP 2: ASSEMBLE RING SECTIONS
Assemble (1) ring section [ DD ] to the ﬁrebowl [ C ] using (2) 25MM bolts [ J ]. For each ring section, assemble (1) pin [ M ] as shown between the bolt and the ﬁrebowl. Assemble the remaining (2) ring sections the same way. Be sure the pins are evenly spaced. Hand tighten the bolts only until all ring sections are assembled, then tighten all bolts securely.
STEP 3: PLACE SPARK GUARD
Place the spark guard [ A ] onto the pins [ M ].
The spark guard keeps sparks contained in the ﬁre pit. PLEASE USE at all times.
STEP 4: ADD SAND
Before using, add a 1-1.5 in. layer of sand or about 5 lbs. (size wise, its the same amount as a 5 lb. bag of sugar) to the bottom of the ﬁrebowl. This will help against the corrosive nature of the ashes and help radiate the heat upwards.
DO NOT RETURN PRODUCT TO THE STOREIF YOU HAVE QUESTIONS OR HAVE TROUBLE WITH ASSEMBLY, PLEASE CALL
1-800-321-3473 FOR ASSISTANCE. COOKING GRATE
Remove spark guard from the ﬁre pit. Align and place the cooking grate [ B ] onto the (3) pins [ M ]. The pins will keep the cooking grate in position. Never burn wood on the cooking grate.
IMPORTANT!
ADD 5 LBS OF SAND TO THE BOTTOM OF THE FIREBOWL.
WARNING!
CARBON MONOXIDE HAZARD!
BURNING WOOD OR CHARCOAL PRODUCES CARBON MONOXIDE, WHICH HAS NO ODOR AND CAN CAUSE DEATH IF BURNED IN ENCLOSED AREAS. NEVER BURN WOOD OR CHARCOAL INSIDE HOMES, VEHICLES, TENTS OR ANY OTHER ENCLOSED AREAS.

HELPFUL HINTS:

ADDING 5 LBS OF SAND TO THE BOTTOM OF THE FIREBOWL WILL EXTEND THE FIREBOWL LIFE.
KEEP THE FIRE PIT OUT OF THE WEATHER AND ELEMENTS• STORE THE FIRE PIT IN A DRY LOCATION OUT OF THE WEATHER.
DO NOT LET THE FIREBOWL FILL WITH WATER.
DO NOT DUMP ASHES WHERE A FIRE CAN BE STARTED.
DISPOSE OF ASHES IN PROPER RECEPTACLE ONLY AFTER ASHES HAVE COOLED.
USE ANY COVER ONLY AFTER THE FIRE PIT IS COMPLETELY COOL TO THE TOUCH.

Congratulations on your purchase of the Firedance
Bears Fire Pit! At Landmann USA, we strive to provide you with an easy to use, easy to assemble product. However, in the unlikely event your package should have a missing or defective part, please contact us at: customerservice @landmann-usa.com
-OR
1-800-321-3473 M-F 8-5 ET.
Proof of purchase may be required.
Thank you!
AVAILABLE ACCESSORIES FOR THE FIREDANCE BEARS DISPONIBLE ACCESSORIOS PARA FIREDANCE BEARS
These custom made accessories are made just for the Firedance Bears ﬁre pit.
COVER
MODEL 29481 Please visit our website at: www.landmann-usa.com
-OR-
Call customer service toll free at: 1-800-321-3473

WARNING!
NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START OR RESTART FIRES.

WARNING!
HOT SURFACES DURING USE! USE MITTENS, POKER OR GLOVES ON THESE PARTS.