LANDMANN 28336 Big Sky Western Fire Pit Instruction Manual

July 30, 2024
LANDMANN

Landmann 28336
Owner’s Manual Assembly and Use Instructions for Model:
28336
28346

28336 Big Sky Western Fire Pit

This Owner’s Manual is provided and hosted by Appliance Factory Parts.
Appliance Factory Parts
Experts in BBQ, Humidifier, & Appliance Parts
1-800-955-7075">800-955-7075
Shop genuine replacement parts for Landmann 28336

PLEASE READ ALL RULES FOR SAFE OPERATION AND HELPFUL HINTS BEFORE USING. READ FIRST!
RULES FOR BIG SKY WESTERN FIRE PIT SAFE OPERATION.

  • THIS OUTDOOR FIRE PIT IS FOR OUTDOOR USE ONLY!
  • USE ONLY ON BRICK, CONCRETE, STONE OR OTHER MASONRY SURFACES!
  • DO NOT USE ON LAWNS, WOODEN DECKS OR ASPHALT!
  • KEEP THE OUTDOOR FIRE PIT A MINIMUM OF 10 FT. AWAY FROM BUILDINGS, STRUCTURES, ANY FLAMMABLE ITEMS AND VEHICLES.
  • NEVER USE UNDER LOW HANGING TREE BRANCHES, TRELLIS, OVERHANGS OF ANY KIND INCLUDING COVERED PORCHES.
  • WARNING! NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START OR RESTART FIRES.
  • FOR LONGER PRODUCT LIFE, KEEP FIRES TO A RESPECTABLE SIZE, DO NOT OVERLOAD.
  • THE OUTDOOR FIRE PIT IS FOR ADULT USE ONLY.
  • DO NOT LEAVE UNATTENDED AT ANY TIME WHILE IN USE.
  • DO NOT MOVE THE FIRE PIT DURING USE.
  • DO NOT USE IN WINDY CONDITIONS!
  • DO NOT OVERLOAD OR USE FOR BURNING GARBAGE.
  • USE CAUTION WHEN TENDING THE FIRE, AS SURFACES WILL BECOME VERY HOT WHILE IN USE.
  • USE MITTENS OR GLOVES WITH THE POKER TO REMOVE THE SPARK GUARD, THE SPARK GUARD WILL BECOME VERY HOT!!
  • USE CAUTION WHEN REMOVING THE SPARK GUARD, AS HOT STEAM OR A FLARE UP COULD CAUSE BURNS.
  • BEFORE EACH USE MAKE SURE THE OUTDOOR FIRE PIT IS IN GOOD WORKING CONDITION.
  • USE CAUTION AFTER THE FIRE HAS BEEN EXTINGUISHED, SURFACES WILL REMAINHOT FOR SOME TIME.
  • THE OUTDOOR FIRE PIT MUST BE COMPLETELY COOLED OFF AND ALL EMBERS MUST BE EXTINGUISHED BEFORE ANY COVER CAN BE USED.

PARTS LIST

When unpacking the fire pit from the carton, make sure you find and become familiar with all the parts listed below. Use caution as some parts may have sharp edges.

A
(1) SPARK GUARD B
(1) COOKING GRATE C
(1) FIREBOWL D
(3) RING SECTIONS

E
(3) LEGS
J
(6) 20MM BOLTS
(BOLTS ARE PRE-ASSEMBLED TO RING) F
(1) MULTIPURPOSE POKER G
(3) PINS (PINS ARE PACKAGED WITH LEG)
H
(6) M8 LEG HEXNUTS (HEXNUTS ARE  PRE-ASSEMBLEDTO THE LEG) (6) M8 LEG WASHERS (WASHERS ARE PRE-ASSEMBLED TO THE LEG)

FIRE PIT ASSEMBLY INSTRUCTIONS

A Phillips or plain screwdriver and an adjustable wrench are needed for assembly.
Assembly time: 15 minutes
STEP 1: ASSEMBLE THE LEGS
Take each of the (3) legs [ E ] and assemble them to the firebowl [ C ] as shown using (6) washers [ I ] and hexnuts [ H ]. Tighten securely with adjustable wrench.
STEP 2: ASSEMBLE RING SECTIONS
Assemble (1) ring section [ D ] to the firebowl [ C ] using (2) bolts [ J ]. Assemble the remaining (2) ring sections the same way. Hand tighten the bolts only until all ring sections are assembled, then tighten all bolts securely.
STEP 3: ASSEMBLE THE PINS
Assemble each of the (3) pins [ G ] by threading them into the hexnuts welded on the inside of the firebowl [ C ]. Do not over tighten!
STEP 5: ADD SAND
Before using, add a 1-1.5 in. layer of sand or about 5 lbs. (size wise, its the same amount as a 5 lb. bag of sugar) to the bottom of the firebowl. This will help against the corrosive nature of the ashes and help radiate the heat upwards.
DO NOT RETURN PRODUCT TO THE STORE.
IF YOU HAVE QUESTIONS OR HAVE TROUBLE WITH ASSEMBLY, PLEASE CALL 1-800-321-3473 FOR ASSISTANCE.
IMPORTANT!
ADD 5 LBS OF SAND TO THE BOTTOM OF THE FIREBOWL.
WARNING!
CARBON MONOXIDE HAZARD!

BURNING WOOD OR CHARCOAL PRODUCES CARBON MONOXIDE WHICH HAS NO ODOR AND CAN CAUSE DEATH IF BURNED IN ENCLOSED AREAS. NEVER BURN WOOD OR CHARCOAL INSIDE HOMES, VEHICLES, TENTS OR ANY OTHER ENCLOSED AREAS. COOKING GRATE
Remove spark guard from the fire pit. Align and place the cooking grate [ B ] onto the (3) pins [ G ]. The pins will keep the cooking grate in position. Never burn wood on the cooking grate.

HELPFUL HINTS:

  • ADDING 5 LBS OF SAND TO THE BOTTOM OF THE FIREBOWL WILL EXTEND THE FIREBOWL LIFE.
  • KEEP THE FIRE PIT OUT OF THE WEATHER AND ELEMENTS.
  • STORE THE FIRE PIT IN A DRY LOCATION OUT OF THE WEATHER.
  • DO NOT LET THE FIREBOWL FILL WITH WATER.
  • DO NOT DUMP ASHES WHERE A FIRE CAN BE STARTED.
  • DISPOSE OF ASHES IN PROPER RECEPTACLE ONLY AFTER ASHES HAVE COOLED.
  • USE ANY COVER ONLY AFTER THE FIRE PIT IS COMPLETELY COOL TO THE TOUCH.

Congratulations on your purchase of the Big Sky Western Fire Pit! At Landmann USA, we strive to provide you with an easy to use, easy to assemble product. However, in the unlikely event your package should have a missing or defective part, please contact us at: customerservice@landmann- usa.com
-OR-
1-800-321-3473 M-F 8-5 ET.
Proof of purchase may be required.
Thank you!
AVAILABLE ACCESSORIES FOR BIG SKY
These custom made accessories are made just for the Big Sky Western Fire Pit. COVER MODEL 29300
This high quality cover keeps out the elements.
Please visit our website at: www.landmann-usa.com
-ORCall customer service toll free  at:1-800-321-3473 HOT SURFACES DURING USE!

WARNING!
NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START OR RESTART FIRES.
WARNING!
HOT SURFACES DURING USE! USE MITTENS, POKER OR GLOVES ON THESE PARTS.

Landmann® Limited
Distributed by Landmann® USA
Cartersville, GA 30120
www.landmann-usa.com
Made in China
© 2011 Landmann® USA
Big Sky® and Landmann® are registered trademarks of Landmann USA.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals