Engete 2BHBG-WTU-02 UHF Wireless Transmitter Instructions
- July 27, 2024
- Engete
Table of Contents
UHF Wireless Transmission Transmitter
Instructions
2BHBG-WTU-02 UHF Wireless Transmitter
Instructions for Basic Functions
A. Transmitter
-
XLR plug
-
LED display
-
SET Button:
Click to select channel
Long press to switch from MIC and AUX modes -
Volume Button:
Click to adjust volume
Long press to switch from
OV/ 5V/ 48V power modes -
Charging Port
-
Power Button
B.Receiver
- XLR plug
- LED display
- Power Button
- Charging Port
Connection diagram
Technical parameters
| Frequency range | 550.3-565.3 MHz |
|---|---|
| Working range: | Receiving distance up to 50m |
(Actual distance may vary depending on RF signal absorption, reflection, and
interference)
Audio frequency response range:| 20Hz – 20KHz(-3dB). Based on microphone type
or input signal
Dynamic range:| 110dB
Battery life:| Up To 5 Hours
Receiving sensitivity:| -88dBm
Total harmonic distortion:| 0.2%
Receiving output power:| 10 mW E.I.R.P. max
Working temperature range:| -18°C to 57°C. Battery Characteristics May Limit
This Range.
Channel| 16 Channel
FCC Warning Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>