Assure 98.2058 Hand Shower Installation Guide
- July 26, 2024
- ASSURE
Table of Contents
Assure 98.2058 Hand Shower
Product Information
Specifications:
- Hand shower: 1 unit
- Rubber washer: 2 pieces
- Shower holder: 1 unit
- Shower hose : 1 unit
- Self-tapping screw (5): 6 pieces
- Plastic expansion screw (6): 6 pieces
- G1/2 Inlet pipe (7): 2 pieces
- Outlet pipe (8): 1 unit
- Round screw nut (9): 1 unit
- Plastic washer (10): 2 pieces
- Tap body (11) with knob
Product Usage Instructions
Guarantee & Aftercare
When installing or using tools, extra care must be taken to avoid damaging
the finish or fitting. To maintain the appearance, please ensure it is cleaned
regularly using a clean soft damp cloth only. Abrasive cleaners or detergents
must not be used as they may cause surface deterioration. The company provides
a guarantee against faulty material or manufacture excluding serviceable
parts, providing they have been installed, cared for and used in accordance
with our instructions.
Installation
What you receive is whole unit, please.
- Pre installed two G1/2 male connectors under the floor.
- Prepare circular hole in the floor 100mm(4”) minimum,150mm(6”) maximum, Decorative cover 75mm(3”)deep.
- Decorative floor.
- Unscrew and take off lock nut (3), push decorative cover (1) onto the lower position of tube (2), then screw the lock nut (3) on to the thread as far as it will go.
- Screw mounting flange (4) onto the tube.
- Tighten screw the lock nut (3) on to the mounting flange (4).
- Connect cold / hot inlet pipe to two G1/2 male connectors, which is water supply.
- Use screws(5) and expansion screws(6) to fix Flange(4) on the floor.
- Push the decorative cover (1) onto the floor.
- Outlet pipe insert to Tube(2), tighten screw Screw nut (9) by hand (Noted, two plastic washer (10)don’t miss).
- Fit the hose (15) to the outlet pipe,and the handset (12) to the hose,ensuring sealing washers(13) are in place.
- Open water supply and check if any leaks before use.
Operation
When water pressure is lower than 0.7 bar, no water will come out from the
hand shower. Pull out and twist the knob to lock it in position. After
showering, twist the knob to reset automatically.
Important Note
Ensure feed tubes are not kinked during installation and use.
FAQ
Q: What should I do if there are leaks after installation?
A: Check all connections, ensure they are tight, and verify that washers are
properly in place. If leaks persist, contact customer support for assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>